SpotCell 100 Series Quick Installation Guide
Contents
1. place the DU and CU in the general areas where they are to be located Do not physically mount them at this time If the DU is mounted indoors maximum separation between the DU and CU and back to back positioning will optimize performance 4 Set Mode amp Connect Power Set the mode switch located to the right of the label on the CU to 1 install Connect the power supply to the CU and then plug the adapter into an AC outlet Back of CU Power Connector Mode Switch 5 Align DU first rotation The DU should be mounted in an area where your cell phone works best In this location rotate the DU in a complete circle The LED on the back of the DU will change color red yellow or green during the rotation Rotate 360 6 Align DU final rotation Begin rotating the DU again When the LED turns green stop the rotation This is the direction the DU must face when mounted 7 Mount DU Now mount the DU Typical installations are pictured below Make sure the DU is facing in the same direction where the LED turned green in step 6 Pipe Mount with Hose Clamp Wall Mount 8 Set CU to Active Set the mode switch on the CU to 2 active Hold the CU in the location to be mounted The LCD on the bottom of the CU indicates coverage 4 by the number of bars more bars indicate better coverage 9 Mount CU Mount the CU from a wall or ceiling2. Q SPOTWAVE coverage made simple www spotwave com Spotwave Wireless Inc 1 Hines Road Ottawa ON K2K 3C7 Canada 2005 Spotwave Wireless Inc All rights reserved Printed in Canada Spotwave and SpotCell are trademarks of Spotwave Wireless Inc Patents pending 780 00004 01 03 Q SPOTWAVE coverage made simple SpotCell 100 Series Quick Installation Guide To install the SpotCell system If required more detailed information on installing a SpotCell system can be found in the User Manual which is available for downloading at http www spotwave com support documentation AN WARNING For your safety beware of power lines and ensure that appropriate safety measures are maintained at all times during the installation of your SpotCell equipment Contact with high voltage power lines could result in death or serious injury 3 Connect CU to DU Connect the CU to the DU with the cable provided 1 Parts List e Donor Unit DU e Cable 80 25 m Mounting kit e Coverage Unit CU Power supply DU outward facing unit CU indoor unit 2 Location The DU can be mounted anywhere your cell phone works This may be on a rooftop typical rural set up on the side of a building or inside a building typical downtown set up The CU will be mounted inside the building where your cell phone does not work The illustration at the right depicts a typical installation To start the installation
3. close to the center of the area requiring coverage Mounting bracket 10 Final Checklist 1 Follow local code requirements for properly grounding the system 2 If the DU is mounted outdoors ensure that there is a drip loop on the cable connecting to the DU on the cables connecting to both sides of the ground block and where the cable enters the building bolt 3 Firmly affix the cable to the building where it runs between the DU and CU
Download Pdf Manuals
Related Search