IMA User Manual.indd
Contents
1. LISTED Ice Maker User Manual ol Tek Part IMA V www KoolTekCoolers com P 877 Kool Tek Table Of Contents Introduction Parts Description and Illustration Ice Maker Specifications Features and Benefits Control Panel Operation Safety and Installation Important Safety Instructions Electrical Requirements Space Requirements Operating Instructions Ice Maker Operation Care and Cleaning Maintenance Notes Tips Troubleshooting Introduction Congratulations on your purchase of a Kool Tek Ice Maker To ensure that you enjoy years of trouble free operation keep this manual which contains valuable information about how to operate and maintain your Ice Maker properly and safely Please read carefully We have engineered this portable ice maker to produce ice at the touch of a button The unique curved shape ice allows liquid to flow over it more easily eliminating splashing Simply pour tap water into the Ice maker Ready to use within 10 15 minutes Note it may take more time to produce the ice cubes on the initial use Parts Description and Illustration of Unit 1 2 3 4 5 6 7 8 9 10 1112 13 14 SS Zs Ow CX SS x KS SZ 57 E 7 A 7 sa XXXI LJ 1 Inner liner 8 Water Inlet Tube 2 Water Reservoir 9 Water Drain Plug 3 Ice Collecting Tray 10 Compressor 4 Ice Storage Basket 11 Wa2. to the water reservoir and the ice cubes will drop from the fingers You will hear a sound as the ice cubes are released In about 30 seconds the water tray will tilt backward and the ice shovel will start to push the ice into the ice collecting section Once the water tray returns to its leveled position the second ice making cycle begins When the ice cubes are collected and reach the ice bin sensor the ice maker will stop operating and the ice full indicator will illuminate When the ice is below the sensor the ice maker will re start the cycle For best performance water temperature should be between 60 75 F Notes Tips e It is normal for the compressor and condenser surfaces to reach temperatures of 160 F during operation and surrounding areas may be hot to the touch Due to fast freezing ice cubes may appear cloudy This is actually trapped air in the water and does not affect the taste or quality of the ice When defrosting or leaving the unit turned off prop and leave the door open at least two inches This allows air to dry the inside of the cabinet reducing the chance for mildew 6 Care and Cleaning Maintenance If the compressor stops for any reason such as water shortage too much power off etc do not restart the system right away Wait 3 minutes then restart the ice maker Remove the drain plug to the remaining water from the water reservoir when the ice make
3. positioned so that the plug is accessible 3 The appliance shall not be exposed to rain 4 Fill with potable water only Space Requirements e During transportation the incline angle of the cabinet should not be over 45 Do not turn the ice maker upside down Compressor and sealed system problems can occur e The ice maker should be placed on a horizontal properly leveled surface e To ensure proper ventilation for your ice maker allow for a 6 150mm space at the top back and on each side of the ice maker e Before using the ice maker for the first time please wait 12 hours after positioning it in a proper place e Clean the inner liner ice collecting tray water box ice shovel and evaporator frequently Operating Instructions Starting your ice maker STEP 1 Connect water line to water inlet valve STEP 2 Press ON OFF button to turn unit on The ice maker will begin to work Ice Maker Operation The ice making process is as follows e Water is pumped into the water tray from the water reservoir It takes about 40 seconds Ice making cycle begins The evaporator in the water tray starts to form ice on the evaporator fingers WARNING Do not touch evaporator while unit is making ice The evaporator will cause a burn It takes approximately 6 to 14 minutes depending on ice selection for the ice making cycle to complete Once completed the water tray will tilt forward the remaining water will flow back
4. r will not be used for long periods of time Screw the drain plug back in place after the water has been drained Always charge with fresh water before starting ice production at initial installation and after long shutoff period Please clean the ice maker regularly When cleaning unplug the unit remove the ice cubes Use a diluted solution of water and hydrogen peroxide to clean the inside and outside surface of the ice maker Do not spray ice maker with chemicals or diluted agents such as acid gasoline or oil Rinse unit thoroughly before starting Troubleshooting This troubleshooting section is to be used only as a guideline to assist in determining any problems Problem Possible Cause Suggested Solution The compressor works abnormally with a buzzing noise The voltage is lower than Stop the ice maker and do not restart it recommended until the voltage is normal There is no water Press the stop button fill with water wait 3 minutes and press the start button to restart Or when the water has reached the fill line the ice maker will restart automatically Check Water connection Indicator lights on display are Replace fuse di Tum power on The water temperature in the Stop the machine and reset the ice making water storage box or ambient time Restart the machine after turning is too low unit off The ice made are too large with pieces sticking together Conditions for ice making The water box does not
5. ter inlet 5 Ice Shovel 12 Water Pump 6 Water Tray 13 Lid 7 Evaporator 14 Control Board SPECIFICATIONS Daily Ice Output 33 Lbs 24 hours Ice Storage Capacity 2 9 Lbs Approximately 150 ice cubes Compressor High Efficiency CFC Free R134a Water Reservoir Capacity 1 2 Gallons Dimensions 14W x 17 3 4 H x 16 D Unit Weight Net Gross Lbs 48 6 Lbs 22 kg Features and Benefits The ice maker is different from traditional commercial ice makers The Kool Tek ice maker is suitable for use in office break rooms and homes e It is micro computerized and makes ice fast and easy Through each cycle the ice maker completes the following steps Water filling Ice making Water releasing Ice dropping Ice transfer Ice storage OV a ae Control Panel Operation ON OFF Press to turn unit on Ice maker will restart automatically Safety and Installation IMPORTANT SAFETY INSTRUCTIONS WARNING To reduce the risk of fire electric shock or injury when using your ice maker follow these basic precautions Plug into grounded 3 prong outlet Do not remove ground prong Do not use an adapter Do not use an extension cord e Disconnect power before servicing Do not pull directly on wire when plugging and unplugging the unit 1 If the supply cord is damaged it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard 2 The appliance must be
6. turn Check that automatic shovel is not jammed cycle are right but no ice is Refrigerant leaks Call for service made Sealed system is blocked Please note If there is a power failure or the power cord is disconnected or if someone accidentally pushes the off power button during an ice making cycle small ice chips could possibly be produced during the restart cycle and when the cycle is complete these smaller chips will lodge in the automatic shovel causing the shovel to jam If this should occur the ice chips will have to be removed by disconnecting the power cord and gently pushing the shovel to the rear of the cabinet and removing the ice chips then restarting 7
Download Pdf Manuals
Related Search