7.5×10ft Rectangular Solar Offset Umbrella With Base
Contents
1. Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com 11 How to Replace the LEDs Step 1 Pull out the Solar cover and Solar light LED respectively cover Step 2 Replace with new Step 3 Solar light LED and new Complete Solar Cover if wanted by inserting the new solar light LED and new solar cover respectively Using Removable Cover gt F Step 1 Remove netting and store fD separately Step 2 Close umbrella canopy le lt gt completely and fasten velcro storage straps fs Step 3 Using the ridged fiberglass pole for support reach the cover over the closed umbrella Step 4 Secure cover using velcro Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com Warnings12 1 Do not use this umbrella during periods of high wind and rain Failure to do so may result in personal injury and or property damage 2 Always take the umbrella down when not in use 3 Placement of the umbrella over or near a Swimming pool can cause premature fading of the canopy This is not covered under our warranty 4 To prevent damage to the canopy open the umbrella facing the opposite direction that the wind is blowing 5 Please make sure that the Ballast is fil2. 1300mAh are supplied with panel rechargeable batteries from any major retailer Tools required Phillips head screw driver not included Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com Instructions Of Set Up amp Operation conta Step 1 Unfasten the storage straps around the canopy as shown in Fig 11 Fig 13 Canopy Position Adjusting Rotates 360 Fig 14 Glide handle Fig 12 Crank handle Step 2 To open the umbrella turn the crank handle in the open direction until Pull up the Lever clamp Slide the glide handle up along the pole Pull down the Lever clamp when achieve the desired tilting angle The higher the glide handle the less the tilting angle To fully open the canopy continually turn the crank handle in the open direction until it s fully opened If the crank becomes too hard to crank check to see if the rope has come off the pulley If you continue to turn the uoht switch Crank the rope could break Contact our customer service toll free at 1 855 880 7205 for further assistance Step 3 Press the light switch to turn on off the solar lights as shown in Fig 13 then the solar offset umbrella is ready to enjoy Step 4 The umbrella has a unique design that moves the pole out of your way and off to the side
3. 6 oenen ov Reon Blow moulding BSE ABM BLK SOL olar Panel SOLPWO Outside PWO Umbrella Base Blow moulding BSE BBM BLK SOLCAP Solar Cap SOL CAP Center Umbrella Base Lower Cross Leg CSLC58X BLK SOLBCC SOLBCC D Upper Cross Leg CSLD58X BLK SOLWM Solar Light SOLWM Holder Pole HDP 58X BLK Frame Only FRM 911045 GG Bolt 4 HDW GG CAN Canopy 1 CAN 7 5X10 O8RBP RST COC HH Washer 4 HDW HH SWT Switch 1 HDW 2Switch Pole Support PSC L58 BLK Holder Pole Ring HPR 3058 Cup BLK Control Knobs HDW 29CK Cover CVR 7 5X1008 RBP RST COC This ATLeisure product is covered by U S Patent No 5 937 882 U S Patent No 7 533 679 U S Patent No 7 604 015 and U S Patent No 8 104 492 Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com Oc LALSUre create your escape www atleisure com ATLANTA GEORGIA Customer Service Toll Free 1 855 880 7205 Monday through Friday from 8 00am 5 00pm Eastern Time
4. Of Set Up amp Operation 8 You must charge batteries before first use Please note that batteries can discharge if they are left unused or uncharged for a long period of time Since there can be a six month period between production and final customer purchase we recommend you charge your solar umbrella for at least 8 hours in direct sunlight before the first use Failure to charge the batteries will result in premature dimming of the lights in your new solar umbrella Make sure the light switch is in the off position when charging the solar panel For everyday normal use turn on the light switch in the night time when you want to use solar light and turn off the switch after use And make sure the light switch is in the off position ii in the daytime for the solar panel to recharge the batteries Insert the main pole of the Umbrella Frame with Canopy N into the Holder Pole F slide the Holder Pole Ring onto the Holder Pole F at same time until the lower fixed stop pin sits on the Holder Pole Ring as shown in Fig 10 Tighten the two control knobs into the Holder Pole F to secure the umbrella as shown in Fig 10 Please remove the plastic film on all solar panels hubs and lights as this protective coating is to prevent damage in shipping We recommend that you change the batteries in your solar light umbrella every year or when you feel the light output is diminished Buy three 3 AA size Ni MH 1200mAh minimum
5. The multiple position canopy can rotate 360 around the axis of the main pole to offer the shade on your expected area around the umbrella as shown in Fig 14 Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com How to Replace the Batteries10 i y Step 1 Pull the plug out of the socket under the solar panel Pull by holding the plug not by pulling on the wires Step 2 Twist counterclockwise and remove the solar panel from the top of the umbrella as shown in Fig 16 Step 3 Put the solar panel upside down on a flat non abrasive surface to avoid scratching Loosen all four 4 screws on the solar panel bottom case as shown in Fig 17 Step 4 Carefully open the bottom case and set aside Replace the batteries matching the on the batteries with the on the battery case as shown in Fig 18 Step 5 Carefully put the bottom case back Align the screw holes and replace the screws Do not over tighten the screws as shown in Fig 19 Attach the solar panel back onto the umbrella and recharge the batteries in the sun Make sure batteries are fully charged before first use For everyday normal use turn on the light switch in the night time when you want to use solar light and turn off the switch after use And make sure the light switch is in the off position in the daytime for the solar panel to recharge the batteries
6. l 7 5x10ft Rectangular Package Contents 2 atleisure Solar Offset Umbrella EN Nae With Base Assembly and User Manual ITEM UMB MJ002 YM PART DESCRIPTION OQTY PC A Side Blow Molded Base 2pcs The schematics in this manual are for assembly and operation illustration B Center Blow Molded base 1pc only They may differ from the umbrella s actual appearance C Lower Cross Leg 1pc D Upper Cross Leg 1pc F Holder Pole with control knobs 1pc i L Pol 1 If you have any questions problems or need additional parts please Bip MURAL ap pe do not return to the place of purchase Contact our customer CAN Canopy 1pc service department toll free at 1 855 880 7205 or email us at N Umbrella Frame with canopy and holder 1pc customerservice atleisure com pole ring Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com 3 Package Contents PART DESCRIPTION QTY PC SOLPWO Solar Panel 1pc SOLCAP Solar Cap 1pc SOLBCC Solar Cover on the umbrella ribs 18pcs SOLWO Solar Light on the umbrella ribs 18pc M Cover 1pc PART PICTURE DESCRIPTION QUANTITY GG Hex Bolt M10 1 5x20 4pcs in blister pack ORD ao HH Flat Washer M10 A2 70 4pcs in blister pack S 4 PREPARATION Before beginning assembly of product make sure all parts are present Compare parts with package contents list If any part is missing or damaged do not attempt to assemble the prod
7. led with water before opening the umbrella Do not stand on umbrella base CANOPY CARE INSTRUCTIONS Simply clean the umbrella canopy with a soft brush and mild detergent Do not machine wash Do not iron Air dry the canopy thoroughly before storing for extended periods of time Make sure the canopy is completely open during drying process to prevent shrinkage Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com 13 Warranty Replacement Parts14 90 DAY WARRANTY This product is covered under a manufacturer s 90 day warranty from date of ie purchase against defects in materials and workmanship This warranty does a not cover damage due to neglect abuse or weather related damage For full warranty disclosure email us at customerservice atleisure com f HOW TO FILE A CLAIM l l Light Switch SOL WO If you are within your warranty to file a claim you must have your receipt and pictures of your damaged umbrella Email information to ATLeisure at i 5L customerservice atleisure com SOL BCC O is UAS I A Q B j A A 0 Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com 15 Replacement Parts conta Me paro o eaen
8. t the Pole Support Cup L over the Holder Pole until it lays on the base Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com 5 Base Assembly Instructions conta Fig 5 Step 5 Fill the Blow Molded Base with water to weight down the umbrella Now you are ready to secure the umbrella to the blow molded base by tightening the control knobs as shown in Fig 5 Solar Light Assembly Instructions 6 Solar screw in adapter Fig 6 Fig 7 Lst Step 1 Put the solar cap on the top of umbrella and leave the plug and wire out of the solar cap from underneath Attach the solar panel and solar cap to the solar screw in adapter in the top of the umbrella by turning the solar panel clockwise Do not over tighten Step 2 Insert the plug into the socket under the solar panel as shown in Fig 7 charge the batteries before the first use as shown in Fig 8 Make sure to charge the batteries for at least 8 hours before the first use Otherwise it will shorten lifespan of the batteries and decrease performance If charging the solar panel while attached to the umbrella make sure the switch on the pole is in the off position on Step 3 Put the solar umbrella in the sunlight to Fig 8 Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com 7 Solar Light Assembly Instructions conto Instructions
9. uct or return to the place of purchase Contact our customer service toll free at 1 855 880 7205 for replacement parts or further instructions Tools Required for Assembly Open end wrench or adjustable wrench Phillips screwdriver Not included Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com Base Assembly Instructions 4 Remove all protective materials Be careful not to throw away small parts such as screws washers etc that may be wrapped in the protective materials Fig 1 Step 1 Place Lower Cross Leg C on the ground line up notches and place Upper Cross Leg D cross over the Lower Cross Leg C as shown in Fig 1 Step 2 Attach the Holder Pole F to the base by using the Bolts GG and Washers HH found in blister pack as shown in Fig 2 Hand tighten only Adjust the Holder Pole F to be sure it is positioned correctly on the base Finally tighten all bolts Be careful not to over tighten T P Step 3 Unscrew the Control Knobs and put aside for future use to fasten the umbrella pole Place the Center Blow Molded base B onto the cross legs as shown in Fig 3 Contact our customer service department toll free at 1 855 880 7205 or email us at customerservice atleisure com Fig 4 Step 4 Attach the two Side Blow Molded Bases A onto the cross legs next to the Center Blow Molded base B as shown in Fig 4 Inser
Download Pdf Manuals
Related Search