FEISOL Tripod CT-3371 / CT
Contents
1. User Manual gt FEISOL CT 3371 and CT 3471 A Mount and Center Column Installation For exchanging Mounts flat Ball Head Mount Center Column Mount Leveling Base Video Pan on the Tripod unscrew the three small set screws on top of the mainframe using the included hex key see picture insert desired Mount and re tighten the three screws To avoid possible damage to the screws or Tripod do not over tighten them B Leg Tension Adjustment Insert the two hexagonal wrenches included into the two screws at the base of the leg see picture and tighten or loosen them to the desired friction by turning the wrenches in opposite directions 6 F190 no us WWW FEISOL NET ned C Leg Extension In order to extend a leg section turn the Twist Lock approximately one half turn in the counterclockwise direction Note If the Twist Lock is turned too far approximately 20 turns the leg section may fall out and Compression Rings may become lost or damaged To firmly lock a leg section into place turn the Twist Lock approximately one half turn in the clockwise direction Do not over tighten D Weight Hook Installation To increase Tripod stability during windy conditions a Weight Hook is included allowing for heavier objects backpack weight bags to be attached to the tripod The Hook can be screwed onto the bottom of the Mounting Plate On an optional Center Column a Weight Hook Is pre installed see picture 6 F192. 0 no us WWW FEISOL NET lentes E Ball Head optional Installation When using the flat Mounting Plate pre installed after making sure that the Ball Head s Panning Knob is locked screw the Ball Head into the Tripod s 3 8 Mounting Screw by turning the Ball head clockwise until it fits snugly Do not over tighten When using an optional Center Column making sure that the Center Column and the Ball Head s Panning Knob are securely locked screw the Ball Head onto the 3 8 Mounting Screw by turning the Ball Head clockwise see picture Do not over tighten lit FEISOL 6 F190 no us WWW FEISOL NET lender F Spike optional Installation Remove the Rubber Caps on the end of the legs by inserting a wooden stick or similar object between the Rubber Cap and the Aluminum ring at the end of each leg see picture By pushing forward around the ring the Rubber Cap can be removed exposing a thread into which the Spike can be screwed and locked tightly into place with the included wrench Once the Spike is in place it does not need to be removed again because the metal tip of the Spike can be receded into its rubber sleeve when desired for use on scratch sensitive surfaces Note that damage to your tripod s Carbon Tubes or Aluminum parts can occur if they are dropped squeezed overloaded or forced downward e g into sand dunes or snowbanks Exercise caution to avoid such conditions 6 F190 no u
3. s WWW FEISOL NET esis
Download Pdf Manuals
Related Search