Owner/User Manual
Contents
1. Model APS 25E 3 Button Remote Security System Owner s Manual Table Of Contents Introduction Features and Options Arming The System Protection While Armed Disarming Your System Intrusion Signals Valet Override Programming amp Safety Control Switch Manually Overriding Your System Eliminating the Arm Disarm Chirps Remote Panic Operation Trunk Release Optional Device Channels Replacement or Additional Transmitters Programming Transmitter Battery Replacement System Features At A Glance FCC COMPLIANCE ile qevice complies with Part 15 of the FCC rules and with RSS 210 of Industry anada Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received including any interference that may cause undesired operation Warning Chan Ss or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment NOTE The manufacturer is not responsible for any radio or interference caused by unauthorized modifications to this equipment Such modifications could void the user s authority to operate the equipment PATENTED www voxxintl com company patents Page 1 128 9321 Page 1 8 Your purchase of this state of the art security system expresses a deep concern for the security of your vehicle its contents and passengers To2. 9321 Page 4 8 2 If the LED is flashing two times pause two times etc then an intrusion attempt was made to the hood trunk or an optional sensor that has been connected to zone 2 3 If the LED is nes three umes pauso lt Ihiee times etc then an intrusion attempt was made through one of the vehicle s doors These intrusion warning indicators are stored in the system s memory and will only be erased from memory when the ignition key is turned on Push Button LED Valet SYSTEM OVERRIDE Switch The Valet switch allows you to temporarily bypass all alarm functions eliminating the need to hand your transmitter to parking attendants or garage mechanics When the system is in valet mode all alarm functions are bypassed however the remote panic feature and remote door locks optional will remain operational To use the valet mode 1 Enter the vehicle and turn the ignition key to the on position 2 Press and hold the LED valet push button switch for 5 seconds until the LED turns on solid The LED will remain on as long as the system is in the valet mode 3 To return to normal operation with the ignition switch on press and release the LED valet push button switch one time The LED will turn off indicating the unit has been returned to the normal mode of operation In the event you lose your keychain transmitter or if the transmitter fails to disarm the system the valet switch can be used as a system override swi
3. fully appreciate the many functions and safeguards incorporated in this system please spend a few minutes reading this manual You may find unexpected features that could mean the difference between protected and fully protected FEATURES 2 Three Button Programmable Code Hopping RF Transmitters Three Channel Receiver capable of accepting 4 transmitters Code Learning Remote Panic in all modes Protected Valet 7 Function LED Arm Disarm Zones 1 2 amp 3 Valet Arming Intrusion Alert with Memory Audible Arm Disarm Defective Zone Tamper Confirmation Instant Siren Activation Starter Disable True Last Door Arming hardwire only Defective Zone By Pass Hardwire or Voltage Sense Selectable Active or Passive Arming Selectable User Programmable Permanent Chirp Delete 6 Tone Multi Tone Siren Additional Negative Trigger Input RF Inhibit with Ignition On Parking Light Flasher Plug In Dual Stage Shock Sensor OPTIONS Remote Trunk Release Remote Keyless Entry Multiple Vehicle Capable Remote Starter Remote Power Window Roll Up Page 2 128 9321 Page 2 8 ARMING THE SYSTEM ACTIVE fi Turn ot the engine exit the vehicle and close and lock all doors hood and runk Press and release the Lock button on the keychain transmitter The siren will chirp once the vehicle s parking lights will flash once the doors will
4. lock optional and the dash mounted LED will begin to slowly flash WARNING Excessive pressure on the transmitter buttons will damage the in ternal components on the circuit board All that is required is a light push to the button NOTE If the siren chirped three times when Locked then one of the entry points hood trunk doors has been left opened Closing the hood trunk or doors will correct the problem and you do not need to disarm the system to make the correction If the siren chirped three times sometime after arming the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired Again closing the hood trunk or doors will correct the problem and you do not need to disarm the system to make the correction ARMING THE SYSTEM PASSIVE 1 Turn off the engine exit the vehicle close and lock all doors hood and trunk 2 The dash mounted LED will begin to flash rapidly indicating that the system is automatically passive arming As an added convenience the automatic passive arming will not begin until all doors and trunk lid are closed allowing passengers to exit the vehicle at their convenience In 30 seconds you will hear a single short chirp from the siren and the vehicle s parking lamps will flash one time indicating the system is ARMED At this time the dash mounted LED will begin to flash slowly providing a visual indi
5. cation that the system is fully ARMED OPTION NOTE If the optional mer included power door lock interface has been installed the alarm control module can be programmed to a Automatically lock the doors during step 3 above or b Lock the doors only when the transmitter is operated 4 If you wish to arm the system immediately simply press and release the ARMING button on the keychain transmitter The siren will chirp once the vehicle s parking lamps will flash once the doors will lock optional and the dash mounted LED will begin to slowly flash Page 3 128 9321 Page 3 8 PROTECTION WHILE THE SYSTEM IS ARMED 1 Opening any door hood or trunk will cause the alarm to immediately sound The siren will continue to sound for 30 seconds then stop and automatically re arm the vehicle If the potential thief left a door opened the siren will sound for six 30 second cycles then re arm and ignore the opened door Any strong impact to the vehicle s glass will cause the alarm to trigger for the full 30 second alarm cycle with Dual Stage Any mild impact to the vehicle s glass or body will cause the alarm to sound a short series of warning tones Whenever the system is armed the dash mounted LED indicator will slowly flash This serves as a visual deterrent to the potential thief The LED is a ver low current bulb and will not cause the vehicle s battery to drain even when le unattended for extended periods Whene
6. e new battery with the side facing up away from the circuit board 5 Close the case and reassemble in reverse of disassembly Page 7 128 9321 Page 7 8 APS 25E SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS DISARMED VALET MODE INTRUSION ZONE 3 INTRUSION ZONE 2 INTRUSION ZONE 1 SIREN CHIRP INDICATORS 1 CHIRP 2 CHIRPS DISARM 3 CHIRPS ARM ZONE ACTIVE 4 CHIRPS DISARM INTRUSION PARKING LAMPS Optional 1 FLASH 2 FLASH DISARM 3 FLASH DISARM INTRUSION Where applicable These chirps are optional and may be disengaged Your System Has These Features Activated Q Starter Cut out Q Motion Detector Q Door Lock Interface Q Hardwire Q Shock Detector Optional Channel 2 Device To purchase replacement transmitters or to get additional product information go to www prestigecarsecurity com 2014 Voxx Electronics Corporation 150 Marcus Blvd Hauppauge NY 11788 128 9321 Page 8 128 9321 Page 8 8
7. he Lock Button of each transmitter you want programmed until you hear a chirp from the horn or siren 4 Press the valet program button to advance to the unlock channel two siren chirps 5 Press the Unlock button of each transmitter you want to operate the unlock function until you hear a chirp from the horn or siren 6 Press the valet program button to advance to the trunk release channel three siren chirps 7 Press the trunk button of each transmitter you want to operate the trunk release feature until you hear a chirp from the horn or siren 8 Turn the ignition switch off The above action programs the Lock Unlock amp optional Trunk Release This remote has the ability to operate 2 similar alarms from a single transmitter To toggle on and off vehicle one or two Press the Trunk Key button the Lock button for 5 seconds The LED flashes 2 times Release the buttons to select 2nd vehicle mode Program this transmitter into the second vehicle s system Any time you are in 2nd vehicle when the transmitter is operated the LED will flash twice for each function When in in the prime vehicle mode the LED will flash once for each function Transmitter Battery Replacement 1 Locate and remove the 00 point Philips head screw on the back of the transmitter case 2 Carefully separate the front case from the rear 3 Slide the CR2032 battery out from under the battery clip and dispose of properly 4 Install th
8. mote panic switch 1 Press and hold the arming button on the keychain transmitter for 3 seconds or more The alarm will immediately sound 2 To stop the alarm press and release the Trunk Key button on the keychain Konomit If the button is not pressed the alarm will automatically stop after seconds TRUNK RELEASE This security system has an additional feature that can be wired to a number of dif ferent optional accessories Some of the more common uses for this channel are Remote Trunk Release available for any vehicle with factory installed electronic push button trunk release Remote Car Starter available for most automatic transmission fuel injected vehicles Remote Window Roll Up available for most vehicles equipped with power windows TO ACTIVATE THIS OPTIONAL ACCESSORY Press and hold the Trunk Key button on the keychain transmitter for approximately 3 seconds If the system has been programmed differently by your installation center this output may be accessed by pressing buttons 1 amp 2 simultaneously for 3 seconds NOTE This feature will not operate when the vehicle s ignition key is turned ON Page 6 128 9321 Page 6 8 PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS BANK 1 Transmitter Model Name 143BP Is Also Found On Back Of Transmitter Case Battery Use CR2032 1 Turn the ignition key to the on position 2 Press and release the valet programming switch 3 times Siren Chirps 3 Press t
9. tch Open the car door the alarm will sound Turn the ignition key on and press and hold the LED yalet switch on The alarm will stop sounding and the vehicle can now be started NOTE Always remember to exit Valet Mode to ensure that the vehicle remains protected at all times ELIMINATING THE ARM DISARM CHIRPS The normal arming and disarming confirmation chirps can easily be turned on and off using the valet push button switch To do this 1 Turn the ignition key on and then off Page 5 128 9321 Page 5 8 2 Within 10 seconds of turning the ignition key off press and release the LED valet push button switch three times 3a If before proceeding with step 2 the chirps were on then you will hear 2 chirps to indicate that the chirps have been turned off 3b If before proceeding with step 2 the chirps were off then you will hear 1 chirp to indicate that the chirps have been turned on NOTE Whenever the chirps are by passed the 3 chirp defect and 4 chirp in trusion indicator will always operate This feature will always warn you if there is a defective sensor during the arming sequence or if the vehicle had been tampered with in your absence even if the normal arming and disarming chirps have been turn off REMOTE PANIC OPERATION The Lock and Unlock buttons on your keychain transmitter also functions as a panic switch for instant activation of the alarm in emergency situations To use the re
10. ver the system is triggered the vehicle s parking lights will flash for the 30 second alarm cycle attracting added visual attention to the vehicle Whenever the system is armed the vehicle s starter will be bypassed If a thief should choose to ignore the siren the vehicle can not be started DISARMING THE SYSTEM 1 As you approach the vehicle press and release the Unlock button on the keychain transmitter 2 The siren will chirp 2 times and the vehicle s parking lamps will flash two times 3a ACTIVE The dash mounted LED will turn off and remain off until the system is re armed 3b PASSIVE Never attempt to disarm the systemi from a distance that prevents you from opening a door within 30 seconds Since the system is programmed for passive arming it will begin to re arm until a door is opened Opening the door will suspend the passive arming cycle INTRUSION WARNING SIGNALS The system will inform you if an intrusion attempt has occurred while you were away from the vehicle If an intrusion attempt has occurred the siren will chirp 4 times when disarming the system The vehicle s parking lights will also flash 3 times to indicate an intrusion has oc curred Enter the vehicle and observe the dash mounted LED for further information 1 Ifthe LED is flashing one time pause one time etc then an intrusion attempt was made to a light activated entry point or the shock sensor was activated Page 4 128
Download Pdf Manuals
Related Search