Silent Brass ST9 Personal Studio Users Manual
Contents
1. If the sound is distorted please select the Hi position E Setup and Use Stereo Ear Phone supplied or Headphones optional PICKUP MUTE PICKUP MIC p gt Signal path CD MD etc Disconnecting the cable while the power is ON may result in damage to the unit The sudden noise may also result in hearing impairments E Specifications Frequency Characteristics INPUT 120 Hz to 20 kHz AUX IN 160 Hz to 20 kHz Input Output Levels QdBm 0 775 Vrms INPUT 30dBm AUX IN 20dBm OUTPUT PHONES 10dBm Jacks and Terminals INPUT AUX IN OUTPUT PHONES all mini jack type Control Volume Input Lo Hi Power OFF ON ECHO Power Supply 6F22 6LR61 9 Volt battery Operation with Manganese bat teries last about 12 hours Dimensions WxDxH 75 x 70 x 25 mm 2 15 16 x 2 3 4 x 1 Weight 65g 2 30z without batteries Accessories Stereo Ear Phones 9 Volt Battery Strap2. GITAL APPARATUS SET OUT IN THE RADIO INTERFER ENCE REGULATION OF THE CANADIAN DEPARTMENT OF COMMUNICATIONS LE PRESENT APPAREIL NUMERIQUE N EMET PAS DE BRUITS RADIOELECTRIQUES DEPASSANT LES LIMITES APPLICABLES AUX APPAREILS NUMERIQUES DE LA CLASSE B PRESCRITES DANS LE REGLEMENT SUR LE BROUILLAGE RADIOELECTRIQUE EDICTE PAR LE MINISTERE DES COMMUNICATIONS DU CANADA e This applies only to products distributed by Yamaha Canada Music Ltd e Ceci ne s applique qu aux produits distribu s par Yamaha Canada Musique Lt e E installing Replacing the Battery A single 6F22 6LR61 9 Volt battery is used to power the ST9 Before replacing the battery switch the power OFF Make sure that the power switch is set to OFF when replacing the battery Turn over the device and remove the battery compartment cover 6F22 6LR61 Insert an 6F22 6LR61 9 Volt battery _9 Volt Battery Take careful note of the polarity markings making sure the battery is not inserted with its poles reversed Back Side Replace the battery compartment cover When battery power becomes low the sound will become distorted or the reverb will not function properly When these symptoms appear replace the battery with a new one as Battery Compartment soon as possible Cover E Nomenclature 1 YAMAHA Strap Accessory Power Switch OFF ON ECHO Indicator This is the device s p
3. Gene BRASS Personal Studio ST9 Owner s Manual Thank you for purchasing the Yamaha Silent Brass Personal Studio ST9 In order to obtain the maximum performance and enjoyment from your ST9 we urge you to read this Owner s Manual thoroughly before using Please keep this Owner s Manual in a safe place for later reference Your ST9 will give you years of reliable service if you follow the simple rules given below E Location Do not expose it to the following conditions to avoid deformation discoloration or more serious damage Direct sunlight e g near a window High temperatures e g near a heat source outside or in a car during the daytime Excessive humidity Excessive dust Strong vibration E Power Supply e Turn the power switch OFF when not in use E Turn Power OFF When Making Connections To avoid damage to the Personal Studio and other devices to which it is connected a sound system for example turn the power switches of all related devices OFF prior to connecting or disconnecting audio cables E Handling and Transport Never apply excessive force to the controls connectors or other parts Always unplug cables by gripping the plug firmly not by pulling on the cable Disconnect all cables before moving the unit e Physical shocks caused by dropping bumping or placing heavy objects on the unit can result in scratches and more serious damage E Cleaning Clean the cabinet an
4. d panel with a dry soft cloth lt A slightly damp cloth may be used to remove stubborn grime and dirt Never use cleaners such as alcohol or thinner Avoid placing vinyl objects on top of the unit vinyl can stick to and discolor the surface E Electrical Interference This unit contains digital circuitry and may cause interference if placed too close to radio or television receivers If this occurs move it further away from the affected equipment YAMAHA is not responsible for damage caused by improper handling or operation FCC INFORMATION U S A 1 IMPORTANT NOTICE DO NOT MODIFY THIS UNIT This product when installed as indicated in the instructions contained in this manual meets FCC requirements Modifications not expressly approved by Yamaha may void your authority granted by the FCC to use the product 2 IMPORTANT When connecting this product to accessories and or another product use only high quality shielded cables Cable s supplied with this product MUST be used Follow all installation instructions Failure to follow instructions could void your FCC authorization to use this product in the USA 3 NOTE This product has been tested and found to comply with the requirements listed in FCC Regulations Part 15 for Class B digital devices Compliance with these require ments provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interfer
5. ence with other electronic de vices This equipment generates uses radio frequencies and if not installed and used according to the instructions found in the user s manual may cause interference harmful to the operation of other electronic devices Compliance with FCC regulations does not guarantee that interference will not occur in all installations If this product is found to be the source of interference which can be determined by turning the unit OFF and ON please try to eliminate the problem by using one of the following measures Relocate either this product or the device that is being affected by the interference Utilize power outlets that are on different branch circuit breaker or fuse circuits or install AC line filter s In the case of radio or TV interference relocate reorient the antenna If the antenna lead in is 300 ohm ribbon lead change the lead in to co axial type cable If these corrective measures do not produce satisfactory results please contact the local retailer authorized to distribute this type of product If you cannot locate the appropriate retailer please contact Yamaha Corporation of America Electronic Service Division 6600 Orangethorpe Ave Buena Park CA 90620 The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries CANADA THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DI
6. ower switch When set to the ON position the power is switched ON and the indicator will light When set to the ECHO position the reverb circuit is activated and applied to the signal received from the pickup mute pickup mic Make sure that the volume is set to its minimum level when operating the power switch Volume Knob Controls the volume of the signal delivered via the OUTPUT PHONES jack OUTPUT PHONES Jack Connect a pair of Stereo ear phones supplied or headphones optional to this jack It can also be used as an external output jack allowing the ST9 to be connected with a commercially available audio cable stereo mini phone jack to an external amplifier sound system for sound reproduction or to a tape deck etc for recording AUX IN Jack Use a commercially available audio cable stereo mini phone jack to connect the output jack of an external device such as a CD player etc to this jack to play along with the external audio source Use the volume control on the external device to control the volume of the external device INPUT Jack Connect a Yamaha Pickup Mute Pickup Mic to this jack The INPUT jack also supplies power to the pickup mute pickup mic Never use any device other than a Yamaha Pickup Mute or Pickup Mic INPUT Select Switch Lo Hi Select the switch position depending upon the requirements of the connected device At first set the switch to the Lo position and play
Download Pdf Manuals
Related Search