Aztech Quick Start-Up Guide
Contents
1. Azlech in HOme Quick Setup Guide Peterborough Distribution Inc DISPLAY Visit myaztech ca for product User Manual and Configuration Manual Step 1 Power up your In Home Display IHD Plug the AC power adaptor into a 120 V AC wall outlet and press the Power button on the right side of your IHD While your IHD is normally plugged in you can unplug it and use Quick Read mode to spot check the energy efficiency of your appliances Initially the IHD must be plugged in for at least 4 hours to charge the battery Step 2 Select Language e Select the language by using the up or down buttons to scroll e Press the center navigation button to select the desired language This selection impacts labels on the information screens and menus Select Language ra gals Select Power Step 3 Wait for IHD to connect to your meter During this process e Looking for meter will be displayed e and the light bar will glow red sweeping back and forth When the meter connection is found e the information screens will become available for viewing e and the IHD will begin receiving information from the Smart meter Most Smart meters will provide new data every minute If you are not consuming much electricity it may take several minutes or longer to notice any changes Note some meters only provide data hourly If no connection is found after 15 minutes e move the IHD closer to the meter and allow additional time for2. Detailed Summary Last 24 Hours Last 24 Hour Details Last 30 Days Last 30 Days Details i Where data is available FCC Notices This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment uses and generates radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try and correct the interference by one or more of the following measures reorient or relocate the receiving antenna Increase the separation between the equipment and receiver connect the equipment into an outlet on a circuit different from that to which the receiver is connected consult the dealer or an experienced radio TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment To comply with FCC RF exposure compliance requirements a separation distance of at least 20 cm must be maintained between the
3. antenna of this device and all persons This device must not be co located or operated in conjunction with any other antenna or transmitter S 097 0905 C02 Please contact your utility company for support myaztech ca Product is protected under US Patent 8325057 China Patent 101765758 Japan Patent 5026530 NZ patent 579331 Other patents pending
4. the IHD to connect to the meter BEO 863 Elh 0 20 h If no connection is found after moving closer to your meter please contact your utility to confirm that your IHD has been registered Please provide the following information to your utility e LAN ID Model No 000 0905 Contains IC 4695A S0000816 e Serial Number Contains FCC ID SCLS0000816 aie wee FW 1 1 stechmeter c This information is found on the label on the bottom of your IHD ABEOCIATER NC pean ee RoHS FEC Use Quick Read Mode to check the impact of any given appliance on your electricity usage by SN 207CSF0930C507000046 D cxicinsise cron pand STU nnn comparing the change in usage readings before and after starting the appliance NOTE ALL COSTS ARE FOR INFORMATIONAL AND EDUCATIONAL PURPOSES ONLY AND NOT FOR BILLING Aztech Associates Inc provides a limited one year warranty for this product For details or to obtain warranty support please visit myaztech ca Copyright 2013 by Aztech Associates Inc All rights reserved No part of this manual may be reproduced distributed or transmitted in any form or by any means including photocopying recording or other electronic or mechanical methods without the prior written permission of Aztech Associates Inc Step 4 IHD Operation Switch between cost and usage modes Scroll up and down through screens Power Menus IN COST MODE IN USAGE MODE Current Summary
Download Pdf Manuals
Related Search