360Q Instructions
Contents
1. 360Q SERIES SAFETY INSTRUCTIONS AND OPERATING PROCEDURE SAVE THESE INSTRUCTIONS A Lamp Installation Loosen the captive knurled brass screw and remove socket cap from rear of unit In sert lamp fully into socket Be sure lamp is properly seated by holding the socket cap in both hands and pressing down on both sides of the lamp base with your thumbs CAUTION Do not touch glass portion of lamp with your hands Agents such as sodium grease or oil from your fingers may be transferred to the glass wall These contaminants can cause the lamp to rupture or can greatly reduce the performance and life of the lamp If accidentally soiled immediately clean the lamp with a soft clean lint free cloth soaked in methylated spirits denatured alcohol and then polish with a dry soft clean lint free cloth B Beam Adjustment and Lamp Centering The beam may be altered in appearance utilizing the three flat head machine screws in conjunction with the round head machine screw The hot spot may be increased peak field or decreased flat field by moving the socket plate towards the front or rear of the fixture respectively This is accomplished by loosening the round head machine screw a few turns then by alternately adjusting the three flat head screws the field can be adjusted to the desired look The lamp should also be centered during this procedure again using the three flat head screws to fine tune the field until the hot spot is ce2. ess to install the lens holder back into unit NOTE Be sure to note the position and orientation of the lenses before removing them to assure correct reassembly and optical correctness of the fixture Clean the lenses with a mild soap and water or a commercial glass cleaning solution and a soft clean lint free cloth Insure that the cleaning process does not leave film on the lens since the heat from the beam will bond onto the surface ALTMA gh N 57 Alexander Street Yonkers NY 10701 ti ng NC Tel 914 476 7987 212 569 7777 800 4 ALTMAN Fax 914 963 7304 BRINGING Are aon di LIGHT Visit our website at www altmanltg com 2008 Altman Stage lighting Company Inc
3. ntered in the beam Once the desired field has been achieved tighten the round head machine screw to lock the socket mounting plate into position then tighten the two nuts on the round head screw onto the socket cap to prevent the screw from vibrating loose CAUTION Always insure that the lamp in centered when using an iris A lamp imaged onto an iris will cause premature iris failure C Focusing A hard or soft edge beam pattern is accomplished by loosening the lens adjusting knob then sliding the lens holder in or out until desired focus is attained Tighten the lens adjusting knob to lock the lens holder into position D Beam Shaping The four shutters are used to shape the beam pattern By moving these shutters in and out or side to side a wide variety of shapes and angles are made possible Remember the left hand shutter as you stand at the rear of the fixture will shape the right hand side of the beam and the top shutter affects the bottom of the beam and so on CAUTION When using an iris always close down the shutters as close to the edge of the iris as possible This will minimize the detrimental heating effect of the lamp upon the iris E Lens Cleaning To gain access to the lenses for cleaning or other purposes remove the lens adjusting knob and slide the lens holder out of the unit Remove the lens retaining ring and carefully remove the front lens If necessary remove the lens spacer and remove the rear lens Reverse this proc
Download Pdf Manuals
Related Search