Quick Installation Installation Installation Guide of Solar Eye
Contents
1. Initial setup is required for first time use Users are allowed to change these parameters as follo wi a Set Time Hold Enter key for 3 seconds for setting as Fig Press left amp right key to change time and switch to the next setting by enter key Press right key to enter into currency setting interface Ge veo ti eo0 00 oe ce b Set Currency Press left amp right key to switch among andthen choose the target one by enter key When it s finished press right key to enter into yield coefficient setting interface gt 68 88 c Set Yield Coefficient Press left amp right key to change coefficient and then confirm it by enter key All digits flash to indicate the setting is finished At this time press right key enter into emission coefficient setting interface 2 0 000 il Yield coefficient indicates the yield per 1Kwh electricity generated from PV inverter d Set Emission Coefficient Press left amp right key to change coefficient and then confirm it by enter key All digits flash to indicate the setting is finished At this time press right key enter into main interface PeNercy J viero CO HISTORY a 0000 J i Emission Coefficient indicate the decreased CO2 volume kg per 1Kwh electricity genera2. Quick Installation Guide of Solar Eye ENER The quick installation guide contains the essential steps for installing and operating the Solar Eye Observe the detailed operating and installation manual This guide does not replace the user manual Observe all national regulations 1 install Solar Bee 2 Install Solar Eye 1 1 Connect the Straight Networking Cable a Press the Solar Eye bottom groove into the convex of base a Remove the square silica gel plug and then insert network cable c Insert the two wall plugs With a sound of clattering installation will be finished d Wring two ST3x25 screws into wall plugs and keep Solar Bee the screw head 5mm space outside Insert network cable y b Fix the accessories waterproof seal sets to Solar Bee Solar Bee i Solar Eye Base Front cover b If want to remove Solar Eye from the base press the base button and release connection Back cover 1 2 Wall Mounting a Use the ST2 7 6 screws to fix two wall mounting plates onto the pillars of Solar Bee f Connect Solar Bee and the PV inverter ST2 7 6 the straight networking cable Suspension loop Direction screw Oo Base button Press the button to release connection 3 Set amp Operation Three keys left C right B and enter A are available as Fig which can help achieve all functions a QO one Cas ven Pm JOO 319 3 1 Initial Setting
3. ted from PV inverter 3 2 Wireless Connection Solar Eye can be connected to Ever solar inverter up to 5 inverters as following a Set Up Wireless Connection Press the key of Solar Bee under normal working state for 15 seconds until LED of Solar Bee flashes which indicates Solar Bee has been into connection state ress right key of Solar Eye to go into connection state At this time t hannel Solar Bee stays in will show on top left corner on Solar Eye and press left amp right key to choose channels Solar Bee stays in on indicates Solar Bee stays in channel 1 enere Y vie PCO HISTORY L i Please repeat operation process above again if the connection fails
Download Pdf Manuals
Related Search