The Skimmer Plug™ Installation Guide
Contents
1. The Skimmer Plug Installation Guide Closed Frozen Water This is the proper way to close your Pool leave 2 6 inches of water over the Skimmer Plug with the bottom ofthe skimmer completely open to remain dry Ifthe Skimmer Plug was removed the water will now completely drain itself to the bottom of the skimmer faceplate and the skimmer will remain dry during the winter Even with a Skimmer Plug installed never close off the bottom of your skimmer Do disconnect all hoses and remove any valves or fittings Ifthe Skimmer Plug was removed the water will fill the skimmer The ice will form across the pools surface and back into the skimmer the ice will then expand cracking the skimmer causing it to leak The water will now continue to leak out the crack draining the pool draining will now cause the surface of ice to lower on one side and leverage the pool skimmer and wall on the other side crushing the wall Dip the Skimmer Plug into the pool water before inserting into the skimmer faceplate this will help the foam portion of the plug more easily slide into place If pool water is not enough use O ring lubricant on all the edges of the foam pad O ring lubricant will also cure a minor drip caused by possible mold defects or nicks in your skimmers faceplate Aboveground pools should remove any hoses valves or fittings that are attached to the skimmer It is very important that the bottom of the skim2. mer remains open so any water that enters will quickly drain out Once the Skimmer Plug is installed you should not allow water to get much higher than about 6 inches up from the bottom of the skimmer plug This means you may need to monitor the water level in your pool over the winter months If the water level in the pool rises due to a leaking cover etc excess water should be drained If the water level in the pool becomes too high ice can form above the faceplate potentially causing damage to the pool Do not leave your pool unattended all winter long Periodically check the pool and fittings for any sign of leaks and to maintain the proper water level which should be at the halfway point on the skimmers faceplate A pool that is left up during the freezing temperatures must not be allowed to leak A small leak that develops during summer usage often goes undetected thought to be evaporation or spillage Persistent wet area around pools should be inspected To determine if your pool is leaking mark the liner at the water level and closely observe the water level in the pool for a period of 7 10 days after the pool is closed for the season If you experience any rain during this period be sure to compensate for the added water If you notice a leak that cannot be stopped release the tension on the winter cover immediately to alleviate additional stress on the pool walls Failure to do so could cause damage to your pool Removing excess sno
3. w and Ice from the winter cover will also reduce stress on the cover and pool walls PLEASE be sure to follow the winterizing recommendations of your local pool professional They will know the climate in your area and offer the best advice to properly winterize your pool and protect it from freeze damage
Download Pdf Manuals
Related Search