USER MANUAL - Integra Healthcare Equipment
Contents
1. Trouble Shooti Power indicator does not light Not con Connect to mains up The fuse has blown Replace fuse if the system is prepared for external fuse replacement or send the system to repair Control box defective Send control box to repair Power indicator lights up Actuator plug not pushed into Push actuator plug into But actuator does not run control properly control box properly Relays in control box are Actuator defective Replace actuator heard clicking Control box defective Replace control box Power indicator lights up Control box defective Send control box repair but actuator does not run Handset defective send handset repair No relay noise is heard Handset plug not insert properly Check all cord connections from control box Emergency stop engaged Deactivate emergency stop Charger plugged in Unplug charger Control box completely dead Battery completely flat Charge battery on battery and no relay Battery defective Replace battery clicking is heard Control box okay apart from handset defective Send handset for repair One direction on one channel Control box defective Send control box for repair Warning and Caution 1 Patient lifter is a Transfer Device that allows patient attendant to transfer patients from bed to wheelchair or commode etc It however should not be used to transport patients 2 When lifting patient make sure the base legs2. are in the most widely opened position and the rear caster brakes are engaged Otherwise the lifter may tilt over 3 When battery power is 50 low the controller will give beep warning At this moment you should charge the battery immediately Please note that a lifted patient cannot be lowered down when battery is out of power 4 Push the Emergency red button if the control unit system is out of control 5 QUICK RELEASE system push pull enables stepless retraction of the actuator under load Mechanical emergency lowering Refer to Picture A Picture A 6 How to Charge please refer to Picture B a With Jumbo Linak set battery box control box amp actuator assembled insert the power cord plug in control box and the other end to a wall outlet b Now it is charging the Charge light is on c When the charging action Is finished the Charge light will be off automatically Usually it is need to charge 4 hours from the 50 capacity to 100 capacity d Remove the power supply cord e Now you can operate again PICTURE B Control box with internal charger eal il al Emergency stop button LCD display Connect the plug EET lug of power cord in control a box and the other end Connect the plug of Handset to a wall outlet
Download Pdf Manuals
Related Search