KAVACXXROBB Robot Vacuum Cleaner with Base
Contents
1. 7 kogan Robot Vacuum Cleaner with Base Station KAVACXXROBB USER MANUAL IMPORTANT Please read this user manual before use and keep handy for future reference Warning Use product only as described in this manual Failure to follow all instructions listed below may result in shock fire injury or the unit being damaged Attention Do not take apart any accessories including the remote control Only use replacement parts Or accessories provided or recommended by Kogan This product 1s designed for household use Do not use it in industrial surroundings or outdoors SAFETY NOTICE This product contains a rechargeable battery It 1s to be charged by the provided charging device This product can only be used with a DC24V 500mA adapter Do not use the appliance if any parts are damaged or defective This appliance 1s not intended to be used by persons including children with reduced physical sensory or mental capabilities or lacking in experience of knowledge of the product unless they are being supervised and have received instruction concerning the use of the appliance by a person responsible for their safety Children must be supervised to ensure they do not play with the product Before connecting this product to the wall socket make sure that the main voltage is the same as that stated on the rating plate Keep the charger cord away from hot surfaces and sharp edges Never use accessories from other produc2. 4 Use the battery provided and do not replace with another brand Attention Please don t forget to take out the battery before discarding the vacuum cleaner e Please remember to turn off the switch before taking the battery out of the cleaner e Please don t place the battery in high temperature environments or in water Please don t exert external force on the battery or drop it from a high place e The battery should be recycled with a safe disposal Please don t discard it with household trash or throw it into a fire e Ifthe battery leaks be careful to avoid the liquid with your skin or clothing Use a dry mop to clean anything the liquid has touched then send the battery to a battery recycling centre e Please do not use a non rechargeable battery with the vacuum Cleaning Modes S Spot Cleaning Mode The unit will focus on a particular area cleaning the local space for approximately 4 and a half minutes covering approximately 1 6 square meters For cleaning single average sized rooms M Normal Cleaning Mode Cc Unit will clean are area covering 20 square AS Eo metres over the time of approximately 30 WV minutes then it will return to standby mode Approximate cleaning algorithm L Around the Column Obstacle Mode M m e a me apte dal Will completely circle around any obstacles encountered then move off to clean other zones In m
3. ERATION OF THE DOCKING STATION If the battery goes flat during the vacuuming process the cleaner will automatically locate the docking station so that the battery can be charged Qv Insert the adapter end into the DC socket on the docking station refer to the Automatic charging as shown earlier in the manual Take the cleaner and connect to the docking station The green light will flash while the device is charging and will stop when the battery 1s fully charged Attention when the dock station is charging your unit the battery icon will flash This just means that the dock station is charging and does NOT reflect battery capacity status It will flash all the time during charging and will keep flashing whether the battery is full or not e Auto Press the Auto button once and a sweeping icon will display which signifies the automatic cleaning system Press Auto once more to cancel the automatic cleaning system e Clock Setting current time Press the Clock button and then the hour icon will start to flash which you can set via the or buttons Press the Clock button again and the minute icon will start to flash which you can set via the or buttons Again press the Clock button and the day of the week can be set via the or buttons After completing the settings press the Clock button to confirm all settings Time Pre setting the vacuum time Press the Time button an
4. d then the hour icon will start to flash Set it via the or buttons Press the Time button again and the minute icon will start to flash which you can set via the or buttons After completing the time press Time again OFF will be shown on the display Press the button and ON will be shown on the display then press Time to complete the time function You can cancel the pre setting by cutting off the power Attention If the battery has not fully charged at the docking station or the automatic charging time 1s less than 5 hours but the pre setting time 1s reached the function will not work The pre set time should be more than 5 hours After finishing setting the docking station should not be powered off before the vacuum time If you have chosen the Time function please cancel the Auto function otherwise the Time function will not be workable It may happen that the vacuum cleaner does not find the docking station because of obstacles a flat battery or because of the complex conditions of working in a large area Please charge the vacuum cleaner on the docking station when setting the vacuum time REMOTE CONTROL PANEL Power Cleaning modes Direction button 1 Open the battery cover and insert replace the battery as shown in pic 1 2 Place the positive and negative poles correctly as shown in pic 2 3 Take out the battery 1f the remote will not be used f
5. e used on the first charge Connect the end of the adapter to the DC socket on the vacuum cleaner and it will be charged directly See picture below N f A Warning L e High voltage Danger of injury NS by electric shock You must have dry hands before use Once the battery 1s fully charged unplug the adapter from the socket Do not pull the power cord but instead grasp it by the plug to remove from the socket Then take the adapter from the vacuum cleaner Automatic Charging Firmly seat the docking station on an even surface against a wall There must be no walls or cavities in range of 3m from the front of the docking station and likewise 0 5m must be kept from along its sides The vacuum cleaner will not be able to locate the station if the infrared signal sensor is blocked or covered Insert the adapter end into the DC socket on the docking station see pic 1 A Warning High voltage Danger of injury by electric shock You must have dry hands before use First charging time 1s 8 hours then regular charging time should be 4 5 hours USING THE PRODUCT Before using pick up objects like clothing loose papers pull cords for blinds or curtains power cords and any fragile objects as they may entangle the cleaning brushes If the device passes over a power cord and drags 1t there 1s a chance that the object could call off a table or shelf e Ensure the battery is charged e Put the robot clea
6. ner in the room which is to be cleaned e Turn on the main power switch e Once the switch has been turned on the command buttons S M L will flash Press the button until they stop flashing If you press the L button during the flashing the device will search for the dock station and charge automatically Main power switch e To start the robot cleaner press one of the buttons S M L to choose the desired cleaning mode e To PAUSE the cleaning press one of the command buttons To resume cleaning press one of the command buttons again To turn the cleaning robot OFF press the main power switch There are 3 cleaning modes which are as follows Large L The robot cleans for 60 minutes and will keep running until the battery charge has gone weak If you use the docking station then the vacuum will charge automatically and then start working again This mode is suitable for large rooms Medium M The robot cleans for 30 minutes This 1s suitable for small rooms Small S The robot will clean for 4 minutes working in a space of 1 square meter This mode is suitable for spot cleaning in one area There are three cleaning systems as follows Side brush sweeps into corners and along edges Two rotating brushes pickup dirt hair and particles into the dustbin Vacuum power picks up the remaining fine dirt The cleaning robot works on all hard floors such as wood tiles marble short carpet etc OP
7. or a long time Before using the remote control make sure to turn off the power switch on the robot vacuum Power Press power to turn on the vacuum cleaner If you press it again it will turn off Direction Button Change the vacuum direction by pressing the arrows Clean Modes S M L press S M L to select the cleaning model CLEANING AND MAINTENANCE Removal installation and cleaning of the dust container Slide the dust container out by pressing the button on the vacuum cleaner See pic 1 and 2 below then empty the rubbish 2 Cleaning the fan motor Press the black button on the container where the fan will be released automatically See pic 3 Turn the fan upside down which will release 2 catches and open the cover see pics 4 and 5 Use the cleaning brushes to clean the edge of the vent Pic Attention Do not use water or a wet mop to clean the fan motor 3 Cleaning and replacing the filter Open the holder and pull out slightly see pic 6 and remove rubbish dirt Use the dust brush to clean the dust container see pic 7 Pic 6 Pic 7 Open the transparent sheet see pic 8 take out the filter see pic 9 Clean the filter with a hair dryer or a brush see pic 10 Pic 10 Pic 8 After cleaning the filter put it back into the dust container or you can replace it with a new filter 4 Removal Installation of Main brush Removal and installation of the main brush and the floor bru
8. ost cases will circle an object 1 5 times then continue cleaning beyond it L Along the Wall Cleaning Mode gt A Unit will continue cleaning large rooms in this mode until fA the battery runs flat and it needs to go back to recharge Perfect for cleaning all of your rooms
9. rs by unqualified persons could be dangerous USAGE RESTRICTIONS e For indoor use only Do not use outdoors or on balconies e This device is nota toy Do not sit or stand on it supervised when the robot is cleaning e Do not pick up anything that is flammable burning or smoking e Do not use this device to pickup anything that is wet s Do not use with long piled carpets PRODUCT DESCRIPTION 1 Infrared Sensor 2 Handle 3 Battery Charging Indicator 4 Command Buttons 5 Bumper 6 Wall Sensor 7 Step Sensor 8 Side Brush ANE N 9 Power Switch 10 Main Rotating Brush 11 Bottom of Dust Container 12 Vacuum Inlet Cover 13 Battery Charger Socket 14 Dust Container 15 Rechargeable Battery Small children and pets should be SUPPLIED CONTENTS R Cleaning brush Remote control Docking station Adapter Filter SPECIFICATION Battery Type 14 4V DC Ni MH 1700mA Charge Output 24W Charge Input AC 100 240V Noise Level 60dB First Charging Time 8 Hours Normal Charging Time 4 5 Hours Working Time 60 90 Minutes Dust Container Capacity 330ml Remote Control Distance 5m Unit Size 34cm x 8 5cm OPERATION GUIDE 1 Battery charging Manual Charging and Automatic Charging Manual Charging Attention Charge the battery for 8 hours before first use and manual charging is recommended to b
10. sh Push the safety latch forward and lift the cover with the right thumb then using the left hand lift the rod of the middle brush see pics 1 and 2 Take out the main brush and the floor brush see pic 3 Before closing the cover of the bottom part of the vacuum cleaner attach the main brush and the floor brush into the appropriate openings Attention It is very important to clean the hair on the main brush regularly as it will improve the vacuum cleaner performance For strong hair wool or string wrapped around the main brush please turn the brush by hand to unwind the strand or cut it off 5 Removal Installation of side brush Before replacing the side brush release the screw on the main shaft of the side brush Push the side brush to the main shaft then tighten the screw after cleaning see pic 1 Pic 1 REPLACEMENT OF BATTERY 1 Use fingers to press the two ends of the battery buckle then take out the battery vertically upwards refer to pics 1 and 2 Attention if you do need to change the battery please contact the Kogan customer support team for further details 2 Please place the positive and negative electrodes correctly to avoid damage 3 Ifthe vacuum will not be used for a long time please charge the battery fully to extend the battery life When the vacuum is next used please change for 8 hours to ensure the battery is in the best possible state
11. ts nor attempt to recharge this product with another charger Before use check the charger cord for any signs of damage or aging You must never use this product if it has a damaged power cord or plug Never use this product if you have wet hands or feet Do not spray the product with water or with any other liquids Do not put water or any other liquids into the product This product is designed for household use Do not use in industrial surroundings or outdoors Store in a dry place If the product 1s being used do not block the air inflow and outflow openings Blocked air vents can cause overheating and motor damage Do not vacuum large pieces of paper or plastic bags as they can easily clog the vacuum Never use the vacuum cleaner without the filters or the dust container being inserted Using a charger from another product may cause a risk of fire This product contains a Ni MH battery Do not incinerate the battery nor expose it to high temperatures as they may explode When the battery pack 1s not in use keep it away from other metal objects such as paperclips coins keys nails screws or or anything else that can create a connection from one battery terminal to another The battery must be removed from the product before it 1s discarded The battery 1s to be disposed of safely The appliance must be disconnected from the mains supply when removing the battery Repairs should be carried out only by Kogan technicians as repai
Download Pdf Manuals
Related Search