2826 WATER BUTT PUMP
Contents
1. Pump full of air Obstructed inlet Unplug from the electricity supply and disconnect outlet hose submerge in water and allow all air to escape reconnect hose and power Remove inlet strainer and foam clean and replace Obstructed pipe outlet Remove obstructions or kinks and clean outlet filter Worn impeller Contact Hozelock customer services for assistance The pump works only intermittently Solid particles prevent the free rotation of the impeller Clean inlet and impeller The temperature of the fluid is too high Fluid too dirty A Only use with fluids below 35 C Empty and clean the water butt refill with fresh rain tap water Faulty motor Contact Hozelock customer services for assistance cont Jet of water sprays out Air vent hole operating This is not a problem The hole is to allow air to exit the pump to make priming the pump easier Water is leaking from Inlet assembly not tight the outlet of the pump enough Tighten Hozelock connector not correctly attached Re attach Hozelock connector Pump Specification Max Pumping Height Hmax 11m Maximum Suction Height 8m Maximum Flow Rate Qmax 2200 Iph Hozelock Ltd Midpoint Park Birmingham B76 1AB England Tel 44 0 121 313 1122 info hozelock com www hozelock com 33725 001 Do not dispose of electrical appliances as unsorted municipal waste use separate collection2. This filter is designed to protect your Hozelock products from damage due to the use of dirty water It is essential to use with micro irrigation AquaPod amp all Sprinklers It is optional with sprayguns nozzles 8 lances Pump storage Store the pump in a dry place and protect from frost TO DRAIN WATER see Fig 4 add a 2166 hose connector available separately and place the end of hose in a suitably sized and positioned container Overload protection e The Hozelock Water Butt Pump has a built in thermal protection switch The pump stops if an overload condition occurs The motor restarts automatically after it has cooled Troubleshooting Problem The pump does not pump water 8 the motor is not running Possible Cause No electricity Plug inserted incorrectly Remedy Check that the electricity supply is turned on amp that the pump is correctly plugged in Circuit breaker is tripped Blocked impeller Reset electricity supply If the circuit breaker trips once more contact a specialised electrician Unplug from the electricity supply and remove possible obstructions from the impeller Damaged motor Contact Hozelock customer services for assistance Pump has overheated Pump contains thermal protection check if pump case is hot and if so allow to cool The pump supplies a limited amount of water or the pump does not pump water and the motor is running
3. Do not spray the outlet towards people or animals This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety ACME This pump can be used to 1 Drive sprayguns and micro irrigation systems 2 Move rainwater and domestic waste water bath water 3 Remove water from paddling pools and flooded rooms The pump can be completely or partially submersed and used to transfer clean or moderately dirty fluids This pump should not be used with swimming pools where Before installation and whenever you are handling the pump always disconnect from the electrical supply To prevent injury never put your fingers into the mouth of the pump e Screw the threaded fitting supplied onto the pump see Fig 1 e Use the handle provided to carry or lift the pump e When used with a water butt for the first time ensure the water butt is emptied and cleaned of all sediment leaves and accumulated debris down To start the pump e Insert the pump into a 220 240v A C socket Maintenance In ordinary conditions the Water Butt Pump does not require any maintenance however occasionally it will be necessary to clean the two filters and the inlet e To avoid the pump clogging the pump
4. facilities Contact you local government for information regarding the collection systems available If electrical appliances are disposed of in landfills or dumps hazardous substances can leak into the groundwater and get into the food chain damaging your health and well being When replacing old appliances with new ones the retailer is legally obligated to take back your old appliance for disposals at least free of charge
5. should not be placed on the bottom of the water butt this can be achieved by either suspending the pump from a rope attached to the handle or by placing the pump on 2 bricks see Fig 2 The pump has a self priming vent to remove any trapped air The priming process can take up to 5 minutes For faster priming lower the pump in to the water without the hose connected and connect the hose after a few seconds once the air has Make sure that the pump is escaped disconnected from the electric TO CONNECT TO AN IRRIGATION power supply before performing SYSTEM any maintenance A e To clean the coarse inlet filter remove filter cover on base of pump by twisting clockwise see Fig 5A Remove filter sponge and rinse in clean water Replace sponge and re assemble filter E For use with hoses and hose reels see Fig 2 add a 2166 hose connector available separately and pass hose out through hole in lid of tank E For use with micro irrigation system Do not use with a pressure regulator see Fig 3 Remove inlet from pressure regulator and attach directly to the hose outside of the water butt using a 2166 hose connector and a 2289 accessory adaptor both available separately cover A e To clean the fine outlet filter remove tap connector on outlet of pump remove fine filter from inside the tap connector and rinse in clean water see Fig 5B Replace fine filter in tap connector and re assemble NB
6. WATER Burr P Hozelock Ltd Midpoint Park Birmingham B76 1AB England Tel 44 0 121 313 1122 info hozelock com www hozelock com 33725 001 lt i gt UMP 12 5mm Garden Hose Hose Reel 2166 Hose Connector These instructions do not cover the use of the hose reel or other connected appliances 12 5mm Garden Hose 2166 Hose 2166 Hose Connector Connector I 2166 Hose LL ie 2291 Double Connector 2289 Accessory 8 lt Adaptor 1 2170 Hose p Connector from mT g Male Connector Adaptor Resulator E A 4mm outlet By adaptor Ao bod 13mm or 4mm Pipe 2x Bricks ff pressure 2x Bricks 4mm Pipe regulator FOR AQUAPOD SYSTEMS FOR ALL OTHER MICRO IRRIGATION SYSTEMS a 12 5mm Garden Hose 2166 Hose Connector Paddling Pool General Safety Warning Read this manual carefully before installing this pump This sign warns the user that failure to follow an instruction may damage the pump or the system This sign warns the user of important electrical safety information Carefully store this manual If problems arise contact Hozelock customer services Every Hozelock Water Butt Pump is carefully tested and packed during assembly On receipt check that the pump has not been damaged during transport If the pump is damaged do not use and contact Hozelock customer serv
7. ices Electrical Safety Check that the voltage and frequency of pump shown on the rating label corresponds to those available on the mains ZA ELECTRICAL INSTALLATION A 10MA OR 30MA RESIDUAL CURRECT DEVICE RCD MUST BE FITTED TO THE MAINS SUPPLY PROTECT THE PLUG AND THE POWER CABLE FROM HEAT OIL AND SHARP EDGES DO NOT OPERATE THE PUMP IF IT HAS A DAMAGED POWER CORD OR PLUG IF THE POWER CORD OR PLUG IS DAMAGED IT MUST BE REPLACED BY A SUITABLY QUALIFIED PERSON IN ORDER TO AVOID A HAZARD ZA MAKE SURE THAT ELECTRIC CONNECTIONS ARE PROTECTED FROM WATER amp SPLASHES THE POWER CABLE SHOULD HAVE A MINIMUM OF 3 CORE 0 75MM SECTION EQUIVALENT TO THAT OF H05 RN F TO MAKE SURE THE PLUG IS PROTECTED FROM ANY SPLASHES USE THE 10M CABLE SUPPLIED TO CONNECT AS FAR AWAY FROM THE PUMP AS POSSIBLE BEFORE USING THE PUMP ALWAYS INSPECT IT VISUALLY ESPECIALLY THE POWER CABLE AND THE PLUG DO NOT USE THE PUMP IF IT IS DAMAGED NEVER USE THE POWER CABLE TO LIFT THE PUMP UK and Ireland This product is fitted with a BS 1363 plug with a 5 amp ASTA approved fuse If you have to replace the fuse only those that are ASTA or BSI approved to BS 1362 and with a rated current of 5 amps should be used If there is a fuse cover fitted this cover must be refitted after changing the fuse If the fuse cover is lost or damaged the plug must not be used Spare fuse holders and fuses are availab
8. le from electrical outlets If the power supply cord or plug becomes damaged in any way it should be replaced by a suitably qualified person A replacement plug should be wired according to the following instructions IMPORTANT This appliance must be earthed As the colours of the wires in the mains lead of this product may not correspond with the colours or markings identifying the terminals in your plug you should proceed as follows Brown Live Blue Neutral Green Yellow Earth The wire that is coloured green amp yellow must be connected to the EARTH terminal in the plug which may be marked with the letter E or coloured green or green amp yellow or marked with the earth symbol The wire that is coloured blue must be connected to the NEUTRAL terminal which may be marked with the letter N or coloured blue or black The wire that is coloured brown must be connected to the LIVE terminal which may be marked with the letter L or coloured brown or red If in doubt contact a qualified electrician people can become immersed in water This pump shouldnot be used for table fountains aquariums fountains filters for fish ponds waterfalls The pump cannot be used for sea water amp inflammable corrosive explosive or dangerous liquids The pump must never be run dry The pump must not be used when people are in the water The sprayer must not be used when people are in the water
Download Pdf Manuals
Related Search