6 Channel Remote Control - User Manual
Contents
1. Disconnect the power source from the blind shade of the covering that needs to be re Channel Selection 1 6 programmed 2 Leave the power source disconnected for approximately 15 minutes up to 1 hour 3 Reconnect the power source 4 Program the blind shade by pressing the button of the new desired channel buttons 1 6 and the Channel lt or gt button The blind shade is now programmed to that channel The blind shade can be reprogrammed as many times as necessary The channel will also need to be reprogrammed after installing new batteries or if using a power supply when the standard house power goes out2. a Techniku a Techniku NNOVATION IN AUTOMATION e NNOVATION IN AUTOMATION Overview 6 Channel Remote Control Programming 6 Channel Remote Control Remote Control Overview IMPORTANT Program each blind shade immediately after connecting _ the power source batteries or power supply at the window covering al The infrared remote control can operate the blind shade within a 50 range Because it is infrared the receiver eye must be in direct line of sight with the remote control for the blind shade to operate The remote control has six different channel modes buttons 1 6 with channel function lt or gt and an ALL A or F Step 1 Insert 2 AAA batteries in the proper orientation as shown channel Using the remote control you can in the battery case of the remote control o Operate up to six bli nds shades individually program one window covering on each of the six channels Operate an unlimited number of blinds shades by programming multiple Step 2 Decide which channel 1 6 you wish to program the blind window coverings on the same channel ie east facing blinds shades on shade Channel 1 west facing blinds shades on Channel 2 etc Each channel will operate all of the blinds shades programmed on that channel that are within Step 3 Point the remote control at the receiver and press the selected channel mode first di rect line of sight at the same time note motors are not synchronous The butt
3. ons 1 6 followed by the Channel lt or gt button The blind shade is now six programmable channels allow you to operate up to six groups of one or programmed to that channel See below DO NOT PRESS THE P OR ALL CHANNEL more blinds shades FIRST IF THE P OR ALL CHANNEL IS INADVERTANTLY PRESSED DURING Operate all blinds shades within direct line of sight using the ALL channel PROGRAMMING SEE REPROGRAMMING THE REMOTE CONTROL Programming reprogramming and operating the remote control is simple By pressing two buttons the blind shade can be programmed Simply press the channel mode buttons 1 6 first followed by the channel function button lt or gt to operate the channels 1 6 Buttons 1 6 for Channel P Do NOT Use Selection Mode Operate Individual Channel To operate the blind shade on an individual channel buttons 1 6 press the selected channel mode first buttons 1 6 and the Channel lt or gt button The blind shade will operate from that channel only and will not respond to the other channels except ALL ALL Channel Operate ALL Channels To operate all of the blinds shades within direct line of sight simply press the A or V The ALL channel does not need to be programmed separately Reprogramming the Remote Control Channel If a blind shade is not programmed to the desired channel reprogramming is simple Function Tilt Lift for 1
Download Pdf Manuals
Related Search