User Manual - ehealthynet
Contents
1. 23 IEC 60601 Compliance Electromagnetic Immunitytest test level level environment guidance Portable and mobile RF communications equipment should be used no closer to any part of the blood pressure monitor including cables than the recommended separation distance calculated from the equation applicable to the frequency of the transmitter Recommended separation distance d 1 24P d 1 24P 80MHz to 800MHz Conducted 3 Vrms 3v d 2 3 800MHzto 2 5 Ghz IEC61000 4 6 150kHzto 80 MHZ where P is the maximum output power rating of the transmitter in Radiated RF 3 V m 3 Vim watts W according to the 1 61000 4 3 80MHzto2 5 transmitter manufacturer and d is Ghz the recommended separation distance in metres Field strengths from fixed RF transmitters as determined by an electromagnetic site survey should be less than the compliance levelin each frequency range Interference may occur in the vicinity of equipment marked with the following symbol o NOTE 1 At 80 MHz and 800 MHz the higher frequency range applies NOTE 2 These guidelines may not apply in all situations Electromagnetic propagation is affected by absorption and reflection from structures objects and people Field strengths from fixed transmitters such as base stations for radio cellular cordless telephones and land mobile radios amateur radio AM and FM radio broadcast and TV br2. NOTE 1 At 80 MHz and 800 MHz the separation dis tance for the higher frequency range applies NOTE 2 These guidelines may not apply in all situ ations Electromagnetic propagation 1 affected by absorption and reflection from structures objects and people N Ce
3. besity smoking and drinking alcohol may influence the blood pressure Diastolic blood pressure mmHg 110 100 1 Mild hypertension 90 Normal systolic value 85 Normal blood pressure 80 Optimal blood pressure target value Systolic blood pressure 120 130 140 160 180 mmHg 200004 Blood Pressure SYSBP Color Classification mmHg mmHg indicator Optimal lt 120 lt 80 Green Normal 120 129 80 84 Green High Normal 130 139 85 89 Yellow Mild Hypertension 140 159 90 99 Orange Moderate Hypertension 160 179 100 109 Orange Severe Hypertension 2180 2110 RED Note This chart is not intended to provide a basis for any type of emergency condition or diagnosis based on the color indicator this chart only depicts different clas sification of blood pressure Consult your physician to interpret the blood pressure results properly SPECIFICATION Product Wrist Blood Pressure Monitor Model MBP 022 B Oscillometric Method automatic inflation and measurement Size L73mm x W65mm x H65mm Weight Approximate 122g Measurment Mechanism 15 LCD Digital Display Power Source 2 AA Batteries Measurement Pressure 0 299 mmHg Range Pulse 40 199 pulse min Pressure 3 mmHg Accurac Pulse 5 of reading Temperature 5 40 C Humidity 15 8596 RH 111112 86 106 kPa 20 55 Humidity 10 8596 RH 86 106 kPa Opera
4. ect the paired device under Measure Button of the App And Press Start Stop Button on the monitor to start measure ment MODE SETTING Measurement Unit Press Setting SET Button when power is off the screen displays as the picture below press Memory MEM Button to switch between mmHg Default and KPa units User Press SET Button when it is in Measurement Unit Set ting Mode the screen displays as the picture below press MEM Button to switch between User1 and User2 user tmp user 2 Date Press SET Button when it is in User Setting Mode press it 3 times to enter Date Setting Mode in a sequence Year li Month li Day In each time pressing SET Button the screen displays as the pictures from left to right in the next page press MEM Button to increase the value by 1 lt EID END 228 tt PLIN eu tt iyu dp ou ti Year Setting Month Setting Day Setting Time Press SET Button when it is in Day Setting Mode press it 2 times to enter Time Setting Mode in a sequence Hour Bl Minute In each time pressing SET Button the screen displays as the pictures from left to right in the next page press MEM Button to increase the value by 1 4 Hour Setting Minute Setting MEASUREMENT Pre measurement Keep calm for 5 10 minutes before measurements avoid eating drinking smoking exercising and having bath Any of these activities may influe
5. ertealihulvet Wrist Blood Pressure Monitor MBP 022 B User Manual TABLE OF CONTENT 8 000 4 PACKAGE 4 INTENDED USE 5 PARTS tai dte tees 5 HARDWARE SET 6 6 5 8 11 ABOUT BLOOD PRESSURE 14 04 000 16 SAFETY PRECAUTIONS 17 CARE amp 18 TROUBLESHOOTING 19 WARRANTY i nne du E HRS 20 EXPLANATION OF SYMBOL 21 ELECTROMAGNETIC COMPATIBILITY INFORMATION 22 INTRODUCTION Thank you for purchasing the eHealthyNet Wrist Blood Pressure Monitor The eHealthyNet Wrist Blood Pres sure Monitor is compact and easy to use that uses the oscillometric principle to measure your blood pressure data The monitor works with your mobile device to track your blood pressure data and share it with your family via eHealthyNet App PACKAGE CONTENT 1eHealthyNet Wrist Blood Pressure Monitor 1Storage Box e 1 User Manual e 2AA Batteries INTENDED USE The eHea
6. hould be supply lines i T transient burst SERD met 3 typical commercial or ve T ospital environment 61000224 input outputlines input output lines 1 kV differential 1 kV differential Mains power quality should be Surge mode mode that of a typical commercial or IEC 61000 4 5 2 kV common 2 kV common hospital environment mode mode Voltage dips short interruptions and voltage variations on power supply inputlines IEC 61000 4 11 5 UT 95 dip in UT for 0 5 cycle 40 UT 60 dip in UT for 5 cycles 70 UT 30 dip in UT for 25 cycles 5 UT gt 95 dip UT for5sec 5 4 UT gt 95 dip in for 0 5 cycle 40 UT 60 dip in UT for 5 cycles 70 0 30 dip UT for 25 cycles lt 5 0 95 dip UT for5sec Mains power quality should be that of a typical commercial hospital environment If the userofthe blood pressure monitor requires continued operation during power mains interruptions it is recommended that the blood pressure monitor be powered from an uninterruptible power supply or a battery Power frequency 50 60 Hz magnetic field 61000 4 8 3A m 3A m Power frequency magnetic fields should be at levels characteristic of a typical location in a typical commercial or hospital environment NOTE UT is the a c mains voltage prior to application of the test level
7. lthyNet Wrist Blood Pressure Monitor is in tended for use at home or medical center It is a non in vasive blood pressure monitoring system designed to measure the systolic and diastolic blood pressures and pulse rate of an adult individual with an inflatable cuff wrapped around the Wrist Please follow the instruction of this user manual in order to use the monitor safely and properly The measurement range of the cuff cir cumference is 22cm to 32cm PARTS Setting Button Start Stop Button Memory Button HARDWARE SET UP Batteries Remove the battery cover Insert 2 AAA batteries into the compartment eHealthyNet APP Download eHealthyNet App The App is available in both Google Play and Apple App Store Before the first use of the monitor download the eHealthyNet App from Google Play and Apple Store Account Setting Follow the on screen instruction to register and set up your personal account A Connect the monitor with mobile devices 1 Switch bluetooth on under the Settings menu on IOS or Andriod devices 2 Selectthe Measure button in the main screen and then button in the upper right corner es Back Please select your device acm 3 Pressand hold the Start Stop Button on the monitor until you see a bluetooth sign appears on screen Wait the monitor pairs with your mobile device it may last for 30 seconds After successful pairing sel
8. ments including domestic establishments and those directly connected to the public low voltage power supply network that supplies buildings used for domestic purposes 25 y Recommended separation distances between portable and mobile RF communi cations equipment and the blood pressure monitor The Wrist blood pressure monitor is inteded for use in an electromagnetic environment in which raidted RF disturbances are controlled The customer or the user of the blood pressure monitor can help prevent elec tromagnetic interference by maintaining a minimum dis tance between portable and mobile RF communications equipment transmitters and the Wrist blood pressure monitor as recommended below according to the ma simum output power of the communication equipment eparation distance according to frequency of transmitter m Rated maximum 150 80 MHZ 80 MHzto 800 MHZ 800 MHzto 2 5 Ghz output power of transmitter 3 5 3 5 7 w 4 Vu E E 0 01 0 12 0 12 0 23 0 1 0 38 0 38 0 73 1 1 2 1 2 2 3 10 3 8 3 8 7 3 100 12 12 23 For transmitters rated at maxlmum output power not listed above the recommended separation distanced in meters m can be estimated using the equation appli cable to the frequency of the transmitter where P is the maximum output power rating of the transmitter In watts W according to the transmitter manufacturer
9. nce the blood pressure Body Posture 1 Be seated with your feet flat on the floor without crosing your legs 2 Place your hand palm side up in front of you on a flat surface like a table 11 3 The Middle of the cuff should be in the same level of the right atrium of your heart Apply The Cuff 1 Wrap a bare wrist with the cuff adjust its position 1 cm above the hand and make sure the monitor facing up with your palm side up 2 Seoure the cuff closed with the Velcro fastener 3 Be seated place you hand on a flat surface e g a table with the palm side up Make sure the cuff is in the a same level of the right atrium of your E heart Take Measurements with Mobile Devices 1 Switch on bluetooth launch the eHealthyNet App in your mobile device 2 Select the paired monitor under Measure Button of the App And Press Start Stop Button on the monitor to start measurement Take Measurements without Mobile Devices The monitor can work without pairing with a mobile de vice Press Start Stop Button twice to skip switching on the bluetooth and start measurements Note Stop the measurement process at any time by pressing the Start Stop Buttion i ABOUT BLOOD PRESSURE The World Health Organization WHO and Internation al Society of Hypertension ISH have created the fol lowing guide to classify and assessing high blood pres sure Please note that other factors such as Diabetes o
10. oadcast cannot be predicted theoretically with accuracy To assess the electromagnetic environment due to fixed RF transmitters an electromagnetic site survey should be considered If the measured field strength in the location in which the blood pressure monitor is used exceeds the applicable RF compliance level above the blood pressure monitor should be observed to verify normal operation If abnormal performance is observed additional measures may be necessary such as reorienting or relocatingthe blood pressure monitor b Overthe frequency range 150 kHz to 80 MHz field strengths should be less than V1 V m 24 Guidance and manufacturer s declaraiton electromagnetic emissions The Wrist blood pressure monitor is inteded for use in the electromagnetic environment specified below The customer of the user of the Wrist blood pressure moni tor should assure that it is used in such an environment Emissions test RF emissions Compliance Electromagnetic environment guidance The blood pressure monitor uses RF energy only for its internal function Therefore its RF emissions are very low and are not likely to cause any interference in nearby electronic equipment The blood pressure monitor is suitable CISPR 11 Group RF emissions CISPR 11 Class Harmonic emissions ci A IEC 61000 3 2 999 Voltage fluctuations flicker emissions Complies 61000 3 3 for use in all establish
11. placement is our only responsiblity 20 and your only remedy under the warranty EXPLANATION OF SYMBOL Symbol for WARNING Symbol for TYPE B APPLIED PART R Symbol for ENVIRONMENTAL PROTECTION wm Waste electrical products should not be disposed of with household waste Please recycle where facilities exist Check with your local authority or retailer for recycling advice Symbol for THE OPERATION GUIDE MUST BE READ Symbol for MANUFACTURER SN Symbol for SERIAL NUMBER Symbol for EUROPEAN REPRESENTATIVE 5 C 6 Symbol for MARK Conforms to essential requirements of the Medical Device Directive 93 42 EEC ELECTROMAGNETIC COMPATIBILITY INFORMATION Guidance and manufacturer s declaraiton electromagnetic immunity The Wrist blood pressure monitor is inteded for use in the electromagnetic environment specified below The customer of the user of the Wrist blood pressure moni tor should assure that it is used in such an environment E Immunity test 60601 testlevel Compliance level Electromagnetic environment guidance Electrostatic discharge ESD 61000 4 2 X6 kV contact 8 kV air 6 kV contact 8 kV air Floors should be wood concrete or ceramic tile If floors are covered with synthetic material the elative humidity should be at least 30 9o Electrical fast 2 kV for power 2 kV for power Mains power quality s
12. t sunlight see the storing environmental condition in the section SPECIFICATION 2 Remove batteries if the monitor will not be used in 3 months TROUBLESHOOTING Error Sign Error signs are displayed on the monitor s screen if there are abnormalities during measurement Sign Cause Correction Wrap the cuff properly Weak Signal or drastic P change blood pressure Check if the connector of the cuff s air tube is detached Avoid use the monitor near a cell phone or any high radiation External disturbance device ES Keep calm during measurement i Cause Correction Wrap the cuff properly E Error during inflation Check if the connector of the cuff s air tube is detached Keep calm for 5 10 mins before measurement E lt Abnormal Blood Pressure Repeat a measurement after 30 minutes of rest if the abnormalty persist for 3 times of measure ments contact your physician CL Low Battery Replace all the batteries at once WARRANTY The eHealthyNet Wrist Blood Pressure Monitor is war ranted to be free from defects in materials and work manship within two year from the date of purchase when used in accordance with the provided instructions The Warranty extends only to the end user We will at our option repair or replace without charge the eHealthyNet Wrist Blood Pressure Monitor covered by the warranty Repair or re
13. ting environment Storage environment SAFETY PRECAUTIONS 1 Read all of the information in the User Manual and other provided instructions before operating the monitor 2 Consult your physician if there is any concern about using the monitor 3 Do not use the monitor in a moving vehicle as it may lead to inaccurate result 4 not use the cuff on your neck as it may lead to suffocation 5 Use ONLY the cuff provided in this package 6 Do not drop the monitor or subject it to strong im pact 7 Replace all the batteries at once 8 Take out the batteries if the monitor will not be used in 3 months AN The monitor is designed for adults and should not be used on infants youning children pregnant or pre eclamptic patients Consult your physician be fore use on children 17 AN The product might not meet its performace spec ifications if not stored or used within the specified range of temperature relative humidity and air pressure in the section SPECIFICATION Please do not share your cuff with other person to avoid any cross infection CARE amp MAINTENANCE Cleaning the Monitor Clean the monitor with soft dry cloth Do not use any abrasive and volatile cleaning agent Cleaning the Cuff Use a piece of cloth soaked with 1 99 Bleach solution to clean the cuff Air dry it after cleaning 2 Storage 1 Store the monitor in a dry and clean environment avoid direc
Download Pdf Manuals
Related Search