Multi-use - Conair Canada
Contents
1. KEEP AWAY FROM WATER DANGER Any appliance is electrically live even when the switch is off To reduce the risk of death or injury by electric shock 1 Always unplug appliance from electrical outlet immediately after using except when charging unit 2 Do not place or store appliance where it could fall or be pulled into a tub or sink 3 Do not use appliance while bathing or in the shower 4 Do not place appliance in or drop into water or other liquid 5 If appliance has fallen into water do not reach for it Unplug immediately 6 Unplug this appliance before cleaning DO NOT REACH INTO THE WATER WARNING To reduce the risk of burns electric shock fire or injury to persons 1 Never leave a plugged in appliance unat tended 2 This appliance should not be used by on or near children or individuals with certain dis abilities 3 Use appliance only for its intended use as described in this manual Only use attachments recommended by the manufacturer Do not use an extension cord to operate the appliance 4 Never operate the appliance if it has a dam aged cord or plug is not working properly has been dropped or damaged or dropped into water Return the appliance to a Conair service centre for examination and repair 5 Keep the appliance cord away from heated surfaces 6 Do not pull twist or wrap the cord around the appliance 7 Never drop or insert any object into any open ing of th2. 0 472 7606 2010 Conair Consumer Products Inc Www conaircanada ca Consumer Call Centre E mail Consumer_Canada Conair com O9CON C072 IB 9716 ging in another appliance to test the outlet 2 Make sure the electrical plug is not connected to a switch which turns power off when lights are turned off 3 Be sure you have inserted the trimmer properly into the charging stand that all connections are secure and that the trimmer switch is in the OFF position OPERATING INSTRUCTIONS 1 Before using your trimmer for the first time place the unit in the charging stand and charge it for 16 hours Always place the trimmer in the base with the ON OFF switch in the OFF posi tion 2 Always check to see if the charging light is on when you place the trimmer in the charging stand The switch must face forward for the trimmer to slide properly into the base and fixed firmly 3 Plug the adaptor into any wall outlet at the volt age listed on the label affixed to the adaptor Unplug adaptor when not in use 4 The adaptor may become warm while charging This is normal Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries the unit should be recharged for 16 hours every 3 months approximately USER MAINTENANCE INSTRUCTIONS TAKING CARE OF YOUR TRIMMER OILING THE BLADES About once a month you should oil the trimmer blades with the oil provided in your kit It is best to do
3. MULTI USE GROOMING SYSTEM sj Have a Question Please do not return this product to the retailer Call Us First Our customer service and product experts are ready to answer ALL your questions Please call our TOLL FREE customer service number at 1 800 472 7606 or visit us online at www conaircanada ca Model GMT187WGBC Instruction Booklet CONA blades until it clicks into position 2 Hold the trimmer in an upright position and begin trimming under your jawline using short even strokes 3 After your beard is blended turn off the trimmer and remove the attachment by gently pulling up on tab TO TRIM YOUR MUSTACHE 1 For best results start with a clean tache 2 Comb through your mustache in the direction it grows 3 Place the wide 5 position comb over the facial hair blade and snap it into position It is a good idea to start with the longest trim setting adjustment You can always go back and cut your mustache more closely with a shorter setting ALWAYS TRIM YOUR MUSTACHE FROM THE TOP DOWN 4 After your mustache has been trimmed to the desired length remove the 5 position comb and 7 using the blades only define the out LC line of the bottom of your mustache 5 Use the scribe blade for fine detailing and hair art SHAVING FOIL Your trimmer includes a shaving foil When attached it will allow you to shave close and around your facial hair to provide an extra clean look Just mov
4. comb because it lets you gradually adjust the closeness of the cut For closest cut and shortest hair push switch all the way to level 3 This is the setting to use for the 2 day shave look To increase the cutting length slowly push control down to level 2 or 1 for longer cut Note that too much clipped hair on the clipper can slow down its operation To remove it without removing the blades simply use the enclosed cleaning brush and gently sweep away the clipped hair from cutting surfaces GROWING A BEARD AND MUSTACHE There are three key factors that will determine which beard or mustache style is best for you 1 The shape and dimensions of your face 2 The natural growth of your beard mustache 3 The thickness of your beard mustache If you are unsure about the type of beard or mustache that would most suit your face speak with a profes sional hair stylist and ask for an opinion on what style would be best Once your beard or mustache has been styled it is essential that you maintain its appearance To do this use your trimmer to trim your beard mustache weekly For the best trimming results your beard should be slightly damp NOT WET when using your trim mer This will prevent the trimmer from removing more hair than desired TYPES OF BEARDS MUSTACHES OO PE e a r J GETTING STARTED OUTLINING YOUR BEARD 1 It is always best to begin with a clean slightly damp beard 2 After you have combed through y
5. e appliance 8 Do not place the appliance on any surface while it is operating 9 Do not use the appliance with a damaged or broken comb or with teeth missing from the blades as injury may result Before each use make certain the blades are aligned properly and oiled 10 Do not use the appliance outdoors or where aerosol spray products are being used or oxygen is being administered 11 THIS PRODUCT IS FOR HOUSEHOLD USE ONLY USER MANUAL FOR ADAPTOR BEFORE USING THE CLASS 2 POWER SUPPLY READ THESE INSTRUCTIONS CAREFULLY Model SW 038011A Rated input voltage 120Vac 60Hz 0 2 Amax Rated output 3 8 VDC 110mA OPERATION 1 For dry location use only Do not expose to rain 2 When not in use unplug unit completely 3 Never operate this unit if the specification is out of the rating 4 When using this unit a warm temperature will be reached CAUTION 1 Risk of electric shock dry location use only or do not expose to liquid vapor or rain 2 Do not shot the polarity output cord 3 Do not operate any appliance which has a damaged output cord or housing 4 Always unplug the unit before cleaning or when not in use 5 This power unit is intended to be correctly oriented in a vertical or floor mount position 6 Be sure voltage is in correct voltage before plugging in SAVE THESE INSTRUCTIONS TROUBLESHOOTING If your rechargeable trimmer does not seem to be taking a charge take the followi
6. e the shaving head in an up and down gentle stroke to remove any stray hairs Be sure not to press to hard as that could cause some skin irritation After each use clean the shaving head as follows 1 Make sure the appliance off 2 Remove the shaver head from the unit 3 Remove the foil head from the shaving head press the two buttons on either side of the shaving head and pull the foil head away 4 Use the cleaning brush to gently remove any hairs from the cutter and shaving head ON OFF SWITCH To operate simply slide switch toward blade to stop push slide away from blade CARE OF YOUR TRIMMER REPLACEMENT REMOVAL OF BLADE SET To remove blade set from your trimmer make sure the trimmer is in the OFF posi tion Remove the blade set by placing thumb against the smaller cutter and pushing forward releas ing the cutter assembly from the trimmer housing Replace with new cutting system and reverse the removal procedure only this time place your thumb on the large cutter and snap into place Make sure the taper control is set to the longest 1 position BATTERY REMOVAL CONTAINS NICKEL CADMIUM BATTERY MUST BE COLLECTED RECYCLED OR DISPOSED OF PROPERLY DO NOT DISPOSE OF IN THE MUNICIPAL WASTE 1 Using a small Phillips head screwdriver remove the screws at the back of the trimmer 2 Remove the bottom housing and push the batteries out Bring the batteries to the nearest collection centre fo
7. ng troubleshooting steps before returning it for repair 1 Be sure the electrical outlet is working by plug MULTI USE GROOMING SYSTEM MODEL GMT187WGBC Multi use Handle Hair trimming blade Nose Ear hair trimmer Blade Cover Foil Shaver 5 Position Adjustable Combs Fine Detailing Blade Carry all Storage Stand LIMITED TWO YEAR WARRANTY Conair will repair or replace at our option your unit free of charge for 24 months from the date of purchase if the appliance is defective in workmanship or materials To obtain service under this warranty return the defective product to the service centre listed below together with your purchase receipt and 5 50 for postage and handling In the absence of a purchase receipt the warranty period shall be 24 months from the date of manufacture ANY IMPLIED WARRANTIES OBLIGATIONS OR LIABILITIES INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE SHALL BE LIMITED IN DURATION TO THE 24 MONTH DURATION OF THIS WRITTEN LIMITED WARRANTY IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY EXPRESS OR IMPLIED WHATSOEVER This warranty gives you specific legal rights and you may also have other rights which vary from province to province SERVICE CENTRE Conair Consumer Products Inc 100 Conair Parkway Brampton Ontario L4H OL2 1 80
8. our beard in the direction it grows naturally you will want to outline the desired shape beginning under your jawline 3 Begin defining your beard s shape under your chin and work upward on each side of your face toward your ears Then define the upper outline of your beard across your cheeks past your sideburns and toward your hairline NOW YOU RE READY TO TRIM YOUR BEARD The trimmer includes a five position comb for use with the hair trimming blade 2 10mm which provide lengths of 3 32 shortest to 3 8 lon gest 2 To use the 5 position comb slide the unit over the trim mer blades and snap it down into position At first until you become familiar with the adjustments use the longest trim setting You can always go back and make your beard a little shorter 3 Begin trimming your beard using smooth even strokes Start with your sideburns and work downward toward your chin Never attempt to trim against the natural growth of your beard because the hair will be cut too short 4 If you decide you want a closer trim you can now adjust the 5 position comb attachment to a shorter setting such as 3 32 or 5 32 and go over your beard again until you achieve the desired length BLENDING THE NO JAWLINE eeN The three jawline laa AN FO attachments will help PAX BW you to achieve a neat finished trim under your chin To use one of the attachments press it down over the trimmer
9. r proper disposal DO NOT throw the batteries into the normal municipal waste system A N sortom k HOUSING CUTTING POSITION NOSE EAR HAIR TRIMMER TO OPERATE TRIMMER 1 To insert battery remove compartment cover by pulling straight down Insert one AA alkaline battery negative end up as indicated in Fig 1 Alkaline batteries will insure the best per formance and longest life for your appliance If you are not going to use the unit for a long period of time or if the battery is dead remove the battery from the unit This will increase the life of your trimmer 2 After inserting the battery replace the battery compartment 3 Now your unit is ready to be used 4 Always purchase the correct size and grade of battery most suitable for the intended use 5 Replace all batteries of a set at the same time 6 Clean the battery contacts and also those of the device prior to battery installation 7 Ensure the batteries are installed correctly with regard to polarity and 8 Remove batteries from equipment v which i is not to be used for an extended period of time 9 Remove used batteries promptly Do not use in the shower and do not use water to clean IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances especially when children are present basic safety precautions should always be taken including the following READ ALL INSTRUCTIONS BEFORE USING
10. this over a piece of newspaper Turn the trimmer on and hold it so that the blades are pointed downward Spread one drop of oil across the blades then turn the trimmer off and wipe away the excess oil with a soft cloth Be careful not to use too much oil and don t oil your trimmer more than necessary as this could damage the motor Never attempt to oil the motor bearing as it is permanently lubricated After oiling the blades return the trimmer and oil packet to the trimmer storage base Keep oil away from children BLADE CARE Because the trimmer blades are precision made for a very special use they should always be handled with care Each time you finish using the trimmer take the cleaning brush pro vided and brush away any loose hair that has collected in the blades Then store the trimmer in its recharging storage base to protect the blades until the next use Be especially careful when changing or adjusting blades When you have your trimmer serviced be sure that both blades are sharpened or replaced at the same time To promote the long life of the appliance use your trimmer only for the purpose intended by the manufacturer to trim your beard and mustache THREE POSITION TAPER CONTROL The Conair trimmer taper control switch is positioned at the back of the unit You can hold the trimmer in your hand and adjust the switch as needed The taper control eliminates the need in some situations for an attach ment
Download Pdf Manuals
Related Search