Instruction manual
Contents
1. mulations from the filter If the filter is very dirty rinse well in warm water The temperature of the water must not exceed 40 C 16 After washing the filter allow it to dry com pletely before repositioning it The silver ion filter not just retains dust parti cles but also has an efficient antibacterial action It also greatly reduces concentrations of irritants such as pollen and spores If the appliance is not used for long periods e After unplugging the appliance from the power socket empty the tank e Clean and reposition the filter e Cover the appliance with a plastic bag to pro tect it from dust TECHNICAL SPECIFICATIONS Power supply voltage Absorbed power Maximum power input See rating plate Freeze protection device Yes Hygrometer Yes Fan speeds 2 Air filter Yes Dimensions HxLxD 485x375x190 Tank capacity 3 litres Operating limits temperature 2 C 32 C relative humidity 30 90 K Important information for correct disposal of the product in accordance with EC Directive mmm 2002 96 EC At the end of its working life the product must not be dis posed of as urban waste It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this servi ce Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent mater2. A Draining into the tank The condensate can be drained directly into the tank The tank can be easily removed fig 1 fig 1 B Continuous external draining If the appliance is to be operated for long periods but you are unable to empty the tank regularly you are recommended to use the continuous drain facility 1 Remove the continuous drain cap by turning it anticlockwise then remove the rubber bung from the spout fig 2 2 In models with continuous drain screw on the connector as shown in figure 3 Make sure the gasket in the connector is positioned cor rectly 3 Attach the rubber hose to the outlet as shown 13 in figure 4 4 Make sure the end of the hose is no higher than the spout or water could remain in the tank Make sure there are no kinks in the hose Fig 5 Nota Bene Keep the rubber bung to close the spout fig 5 YES Instructions for fitting the castors 1 Unplug from the mains socket and empty the tank if full 2 Remove the rubber caps from the bottom of the appliance by pulling forcefully or using pliers see figure 6 1 3 Fit the castors by inserting the pins into the holes see figure 6 2 on While fitting the castors do not tilt the appliance at an angle of more than 45 After fitting the castors wait for at least an hour before using the dehumidifier again GB H
3. Do not use the appliance outdoors e Do not obstruct the air intake or outlet e Do not use the appliance in laundry rooms Instructions Read these instructions carefully before installing and or using the appliance e Keep these instructions carefully 12 If the appliance is transferred to other owners they should also be given these instructions e Failure to respect the instructions may result in injury or damage to the appliance The manufacturer is not liable for damage deriving from failure to follow these instruc tions e Keep the list of Service Centres and identify the Centre nearest you Electrical connections After moving the appliance wait at least an hour before turning it on again Before plugging the appliance into the mains soc ket check that e The mains power supply corresponds to the working voltage indicated on the rating plate e The power socket and electrical circuit are adequate for the appliance e The power socket matches the plug If this is not the case have the plug replaced by a qua lified electrician e The mains socket is adequately earthed INSTALLATION Position the appliance in the room to be dehumi dified A free space of at least 50 cm must be left at the front of the dehumidifier so as not to block the air outlet For efficient ventilation a space of about 5 10 cm should be left at the back of the appliance The condensate can be drained in one of the following ways
4. OW TO DEHUMIDIFY Display Decrease humidity Increase humidity button button Fan button s woe Hygrometer thermometer button ig A ON Standby button MODE button Description of buttons ON Standby button ON Standby button MODE button Selects the operating modes dehumidifying dry smart and fan Fan button Selects fan speed Hygrometer thermometer button Temporarily displays the temperature and humi dity measured in the room by the appliance N B the measurements displayed are indicative only Humidity increase decrease buttons Adjusts the percentage of humidity present in the room increasing it or reducing it by steps of 5 14 Display Meaning of the codes or symbols which may be displayed Indicates that the appliance is in standby mode C i Indicates that the tank is full absent or positioned incorrectly Indicates that the appliance is operating at low temperatures In this situation venti lation cycles are alternated with dehumi dification cycles to avoid the formation of ice For use in particularly cold environ ments you are recommended to heat the room to raise the ambient temperature even minimally This allows the dehumi difier to operate in conditions that impro ve its performance and accelerate the dehumidifying process Indicates that there may be a fault with the probes or that the humidity in the room is too low t
5. RODUCTION Thank you for choosing a De Longhi product Take a couple of minutes to read these instruc tions This will avoid danger or damage to the appliance Symbols used in these instructions These symbols draw your attention to important warnings It is vital to respect these warnings Failure to do so may result in electric shock serious injury burns fire or damage to the appliance L Danger Failure to observe the warning may result in life threatening injury by electric shock AN Important Failure to observe the warning may result in injury or damage to the appliance N B This symbol draws your attention to important recommendations and information Problems and repairs In the event of problems first try and resolve them by reading the information given in the Troubleshooting section on page 9 If the appliance requires repair always contact a Service Centre authorised by the manufacturer Always insist on original spare parts Repairs car ried out by unauthorised personnel may be dan gerous and invalidate the guarantee 11 SAFETY Fundamental safety warnings AN Danger This is an electrical appliance it is therefore important to respect the following safety warnings e Do not touch the appliance with wet hands e Do not touch the plug with wet hands e Make sure the mains socket used is always accessible enabling you to unplug the appliance when necessary e Always unplug the
6. SOME NOTIONS ON HUMIDITY Air always contains a certain amount of water in the form of vapour This determines the level of humidity in an atmosphere The capacity of the air to hold water vapour increases with temperature This is why in our homes as soon as the tempe rature decreases the vapour contained in the air condenses as is evident on the colder surfaces in the room such as the windows walls etc The purpose of a dehumidifier is to remove the excess moisture from the air avoiding the dama DESCRIPTION ACCESSORIES Control panel Water level viewing window Condensate collection tank Lifting handle Air intake grille akon ge caused by condensation Experts have established that the optimum envi ronmental conditions for our well being and for the home are obtained between 40 and 60 relative humidity With very low temperatures you are recommended to heat the room even minimally This considerably increases the dehumidifying power of the appliance With heating the condensation formed by the water vapour on windows and other cold surfaces evaporates into the air to be collected by the dehumidifier Air leaving the dehumidifier is usually about 1 C warmer than room temperatu re 6 Silver ion air filter 7 Air outlet grille 8 Condensate drain hose 2 m 9 Castors 10 Continuous drain connector certain models only 10 INT
7. appliance using the plug itself Never pull the cable as it might be damaged e To disconnect the appliance completely from the electricity supply you must unplug it from the mains socket e If the appliance malfunctions do not attempt to repair it Turn the appliance off unplug from the mains socket and contact a Service Centre e Do not move the appliance by pulling the power cable e Itis dangerous to modify or alter the charac teristics of the appliance in any way e Ifthe power cable is damaged it must be replaced by the manufacturer or an authorised technical service centre in order to avoid all risk e Do not use extension leads e The appliance must be installed in accordance with the rules on household appliances in force in the country concerned e The appliance must be connected to an effi cient earth installation Have your electrical circuit checked by a qua lified electrician AN Important Keep packaging materials plastic bags polystyrene foam out of reach of children Important The appliance is not intended for use by persons including children with redu ced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Always supervise children Make sure they do not play with the appliance GB Appropriate use The appliance is designed and produ
8. ced for domestic use only Use this appliance only as described in this instruction manual As with all electrical equipment whilst the instruc tions aim to cover as many eventualities as possi ble caution and common sense should be applied when operating and installing this appliance General safeguards e Do not install the appliance in rooms contai ning gas oil or sulphur Do not install near sources of heat e Do not use the appliance on sloping surfaces e Keep the appliance at least 50 cm away from flammable substances alcohol etc or pres surised containers e g aerosol cans e Do not rest heavy or hot objects on top of the appliance e Always transport the appliance upright or resting on one side Remember to drain the condensate tank befo re moving the appliance Wait at least 1 hour after transporting the appliance before starting it e R134a refrigerant complies with European environmental standards However you should avoid perforating the refrigerant cir cuit At the end of its working life consign the appliance to a specialist collection centre ENVIRONMENTAL INFORMATION This unit contains fluorinated greenhouse gases covered by the Kyoto Protocol Maintenance and disposal must be carried out by qualified personnel only R134a GWP 1300 e The materials used for packaging can be recy cled You are therefore recommended to dispose of them in special differentiated waste collection containers e
9. e This dehumidifies automatically According to room conditions the appliance auto matically establishes the optimum settings for maximum comfort Press the MODE button and choose Smart mode The symbol appears on the display Relative humidity and fan speed cannot be set 15 Fan mode Press the MODE button and choose fan mode is displayed Press the button to select the required fan GB speed MIN MAX CLEANING AND MAINTENANCE Always unplug the appliance from the power soc ket before performing any cleaning or maintenan ce operations For safety reasons never wash the dehumidifier using a jet of water Cleaning the cabinet e Clean the appliance using a damp cloth then dry with a dry cloth e Do not use petrol alcohol or solvents to clean the appliance e Do not spray liquid insecticide or similar pro ducts as they may deform the plastic Cleaning the silver ion air filter If the filter is dirty air circulation is compromised and the efficiency of the dehumidifying and air purifying functions decreases It is therefore good practice to clean the filter at regular intervals The frequency depends on the duration and conditions of operation If the unit is used constantly or systematically you are recommended to clean the filter once a week e Remove the air filter by pulling sideways Fig 7 fig 7 e Use a vacuum cleaner to remove dust accu
10. ials to be recovered to obtain significant savings in energy and resources As a reminder of the need to dispose of household applian ces separately the product is marked with a crossed out wheeled dustbin TROUBLESHOOTING Check the following points before calling your local authorised Service Centre PROBLEMS The appliance is operating in dehumidifying mode but the humidity does not decrease The appliance does not work for 3 minutes after start up t is displayed is displayed OC is displayed CAUSE The filter is blocked The temperature or humidity in the room are too low The room is too big for the dehumidifying power of the appliance Too many sources of humidity in the room pots of boiling water etc The humidy set point is too high The safety device has tripped The tank is missing The tank is full The tank is incorrectly positioned The temperature in the room is very low One of the sensors on the appliance is faulty or the humi dity in the room is too low or too high to be measured cor rectly 17 GB SOLUTION Clean the filter In certain conditions it is nor mal for the appliance not to dehumidify in certain cases it is recommended to heat the environment Decrease the humidity set point Wait for 3 minutes to pass Replace the tank Empty the tank Position the tank correctly Increase room temperature See if the appliance start
11. o be measured pr MODE SELECTION 1 Plug the appliance into a mains socket 2 is displayed to indicate that the appliance is in standby and therefore ready for opera tion lf Fb is displayed empty the tank or posi tion it correctly 3 Press the ON Standby d button Dehumidifying mode Press the MODE button and choose dehumidif ying mode 6 and the level of relative humidity previously set are displayed Press the or button to set the desired humi dity 30 means a dry environment 80 a humid environment Press the button to modify fan speed MIN MAX When MAX speed is selected the appliance ope rates at maximum dehumidifying power When MIN speed is selected the appliance opera tes at low power and the noise will also be less Press the button to display room temperatu re amp symbol and the relative humidity in the room in sequence When the appliance reaches the set level of humi dity it will stop and the fan will come on at regular intervals to maintain a correct relative humidity reading As soon as the humidity increases above the set point the appliance will automatically resume dehumidification operation Dry mode In Dry mode the appliance operates constantly at maximum power This mode is useful to dehumidify the room rapidly Press the MODE button and choose Dry mode QB symbol on Relative humidity and fan speed cannot be set Smart mod
12. s wor king again when moved into another room with a level of humidity within the operating limits indicated in the Technical Specifications sec tion If the problem persists call the Service Centre
Download Pdf Manuals
Related Search