EMField™ Generator Transport Case - ETS
Contents
1. Placing the EMField into the Transport Case continued from inside page 4 lf required gently apply light pressure with both hands to seat the EMField evenly in the foam Lower the lid and close all latches Safety Information Note Denotes helpful information intended to provide tips for better use of the product CAUTION Denotes a hazard Failure to follow instructions could result in minor personal injury and or property damage Included text gives proper procedures S WARNING Denotes a hazard Failure to follow instructions could result in SEVERE personal injury and or property damage Included text gives proper procedures al ONLY QUALIFIED PERSONNEL should install operate or service this equipment For complete safety information see the EMField Generator User Manual SETS LINDGREN An ESCO Technologies Company USA Headquarters 1301 Arrow Point Drive Cedar Park TX 78613 Phone 1 512 531 6400 Please see www ets lindgren com for a list of all ETS Lindgren offices Copyright 2015 by ETS Lindgren Inc All Rights Reserved No part of this document may be copied by any means without written permission from ETS Lindgren Inc The ETS Lindgren logo is a registered trademark of ETS Lindgren Inc meen seinen SETS LINDGREN An ESCO Technologies Company EMField Generator Transport Case For complete product information Download the EMField Generator Use2. r Manual from www ets lindgren com WARNING Failure to use the transport case properly can result in permanent damage to the EMField For safety the ETS Lindgren EMField Generator is shipped in a protective transport case This case is designed for short distance transporting for example between on site locations or between facilities The transport case provides foam casing that is custom designed for the EMField and the case is watertight and dust proof You must use the case when transporting the EMField S WARNING The transport case should be placed inside a padded box when shipped to other destinations The transport case is not designed to be the outer shipping box WARNING When the EMField is stored in the transport case handle the case with care permanent damage to the EMField can occur if the transport case is handled roughly Removing the EMField from the Transport Case 1 Grasp the handle on the EMField Continue to the inside page of this document for steps 2 4 Note Your EMField model may differ from the model shown in this document ets lindgren com ETS LINDGREN l EMField Generator Transport Case An ESCO Technologies Company Removing the EMField from the Transport Case continued from front page Placing the EMField into the Transport Case 1 Nose first lower the EMField into the foam in the transport case 2 Tilt the back end of the EMField upward while keeping
3. the nose in the foam hollow 2 With a gentle forward motion move the nose of the EMField into the foam hollow 3 Continue to raise the back end of the EMField upward while moving the nose toward the back do not lift the nose straight up 3 With the nose in the foam hollow lower the back end of the EMField into the foam Make sure the back end is flush with the foam sides 4 Once the nose of the EMField is away from the foam lift up to remove completely from the case Continue to step 4 on the back page of this document ets lindgren com
Download Pdf Manuals
Related Search