Home
        Specification - All
         Contents
1.                         Library Name__ Cylindrical Li ion Rechargeable Batteries Date 2010 11 13       Cylindrical Li ion Batteries    Specification    Batteries Type  LIC14500       Prepared   Date Checked   Date Approved   Date                   13 11 2010 13 11 2010 13 11 2010                                                                   Library Name__ Cylindrical Li ion Rechargeable Batteries Date 2010 11 13  1  Primary technical Parameters  Type   Rechargeable  Lithium ion Cylindrical Cell  Dimension   D  14 140 2mm 14 1    H 48 5 0 5mm  CsmAh   700  CsmA   700 d  Nominal Voltage   3 7V    Nominal 700 mAh  Capacity Minimum 650 mAh  when discharged at 0 2CsmA to 2 75V   Recommended  Charging   140mA 700mA charge termination control  Conditions parameters taper current 7 mA at 4 2V a   Max continuous   1400 mA     discharge   current  Service Life   300 cycles  280  CsmAh   Weight   Approx 20g  Internal    80mQ max  at 1000Hz  Resistance unit  mm       Charging Voltage      4 200 0 05V       Ambient      Charging   0  45  C          Temperatire Discharging    20   60  C  Range     Storage    lt b t36C  Note     1  Cs  the rated capacity  unit  Ah or mAh   2  Lithium content  less than 20g   Subject to change without prior notice     2  Performance                   Test item Test conditions Requirements   1 Outside Visual check No abnormal stain   Appearance Deformation nor damage   2 Standard test   Measurements are carried out at 20 5   Cand relative  conditions humi
2.  not pierce battery with a sharp object such as a needle     Do not hit with a hammer  step on or throw or drop to cause strong shock     Donot disassemble or modify the battery     Donot solder a battery directly     Do not use a battery with serious scar or deformation     Warning    Do not put battery into a microware oven  dryer  or high pressure container     Do not use battery with dry cells and other primary batteries  or batteries of a different  package  type  or brand     Stop charging the battery if charging is not completed within the specified time     Stop using the battery if abnormal heat  odor  discoloration  deformation or abnormal condition  is detected  During use  charge  or storage     Keep away from fire immediately when leakage or foul odor is detected     If liquid leaks onto your skin or clothes  wash well with fresh water immediately   If liquid leaking from the battery gets into your eyes  do not rub your eyes  Wash them well with clean  water and go to see a doctor immediately     Caution    Store batteries out of reach of children so that they are not accidentally swallowed     lf younger children use the battery  their guardians should explain the proper handling     Before using the battery  be sure to read the user   s manual and cautions on handling thoroughly     Thoroughly read the user   s manual for the charger before charging the battery     For information on installing and removing from equipment  thoroughly read the user   s manual fo
3. d capacity       No rupture  fire  smoke   Nor critical damage    290  CsmAh                                  Library Name__ Cylindrical Li ion Rechargeable Batteries Date 2010 11 13                   4  Safety Evaluation       Test Item Test Conditions Requirements        1 Hot Oven Test The charged batteries are to be heated in a gravity   No fire  Nor explosion  convection or circulating air oven  The temperature  of the oven is to be raised at a rate of 542  C per  minute  The oven is to remain for 30 minutes at    130 2  C before the test is discontinued         2 Short Circuit Test After fast charge at 20 2  C  Connect battery   No fire  Nor explosion  terminals with electric wire   electric resistance   50mQ or less    And stop the test when the  temperature of battery is 10  C lower than peak    temperature         3 Overcharge After discharged at 1 CsmA and to 2 75V  the   No fire  Nor explosion  batteries shall be charged at 3 CsmA current with a  voltage limit of 4 6V  chargeing is continued for 8    hours        4 Dip test The charged battery shall be dipped in water for 24h   No fire  Nor explosion    in an ambient temperature of 20  C 5  C                    5  Charge State of Battery before shipment   To be determined    Recommendation Approx  3 75     3 85V 30  charge    6  Duration of guarantee the product   We can keep on the quality in six month    7  Protection   When Li ion rechargeable battery is used over the permitted voltage or current  electrolyte ma
4. dity of 65 20  without other specified condition   Accuracy of voltmeters and ammeters used in test is  equal to or better than the grade 0 5    3 Standard Cells shall be charged continuously at the constant  charge current of 0 5 CsmA to 4 2V  then charge at the constant  voltage of 4 2V until the end current of mA   4 Standard Cells shall be discharged continuously at the constant  discharge current of 0 2 CsmA to 2 75V           5 Fast charge       Cells shall be charged continuously at the constant                               Library Name       Cylindrical Li ion Rechargeable Batteries    Date          2010 11 13          current of 1500mA to 4 2V  then charge at the constant  voltage of 4 2V until the end current of 7mA           6 Open circuit 23 700  voltage OCV    7 Rated Cells shall be charged in Item  3  and discharged in Item   Rated capacity    4  within 30minutes after full charged  If the discharge o  Capacity duration does not reach the specified value  the test   27 00 CsmAh    may be repeated up to three times in total         8 high rate    Cells shall be charged in Item  3  and discharged    Discharge capacity        discharged continuously at the constant current of 1 CsmA to 2 75V   295 CsmAh  Capacity within 30 minutes after full charged  If the discharge  duration does not reach the specified value  the test  may be repeated up to three times in total    9 Cycle Life Cells shall be charged continuously at the constant 2300 cycles    current of 1C5mA t
5. o 4 2V and discharged continuously       oo at the constant current of 1C5mA to 2 75V A cycles  defined as one charge and discharge   Carry out cycles  until discharge capacity  lt 80  CsmAh   10 Low Cells shall be stored under  20  C 2  C for 16h 24h after   Discharge capacity   Temperature   charged in Item  3  then discharged at constant current   260 CsmAh  discharge of 0 2 CsmA to 2 75V   11 Storage Cell shall be charged in Item  3    and stored in a   Remaining capacity  characteristics temperature controlled environment at 20 5  C for 28   290 CsmAh          days  After storage  cell shall be discharged in Item        4  to obtain the remaining capacity        3  Mechanical test       Test Item    Test Conditions    Requirements        1 Vibration Test    Vibrate test sample for 90 minutes per each of the  three mutually perpendicular axis   x y z   after rated  charge    Amplitude  0 38mm  10 30Hz   0 19mm  30 55Hz    Frequency  10 55Hz   1oct min     Direction  X  Y    After test  cells are discharge at constant current of  0 2IhmA  and cycles per 1 3  and 1 4  for 3 cycles to  obtain recovered capacity    No rupture  fire  smoke   Nor critical damage     90  CsmAh        2  Drop Test       Drop 100  charged test sample from 1 meter above  onto concrete board with more than 5cm thickness  two times each for every direction after rated charge   After test  cells are discharge at constant current of  0 2C5mA and cycles per 1 3  and 1 4  for 3 cycles to  obtain recovere
6. r  the specific equipment     Batteries have life cycles  If the time that the battery powers equipment becomes much shorter  than usual  the battery life is at an end  Replace the battery with a new same one     Remove a battery whose life cycle has expired from equipment immediately     When the battery is thrown away  be sure it is non conducting by applying vinyl tape to the     and      terminals     When not using battery for an extended period  remove it from the equipment and store in a place  with low humidity and low temperature     While the battery pack is charged  used and stored  keep it away from objects or materials with                   Library Name__ Cylindrical Li ion Rechargeable Batteries Date 2010 11 13                      static electric charges      Ifthe terminals of the battery become dirty  wipe with a dry clothe before using the battery      The battery can be used within the following temperature ranges  Do not exceed these ranges   Charge temperature range   0  C to 45  C  Discharge temperature range    20  C to 60  C     When using equipment           
7. y  disassemble  and this case will affect safety performance of Li ion rechargeable battery  So    PTC  heat fuse    and protection circuit module were used in order to prevent overcharge  overdischarge and  overcurrent   The parameters of protection circuit module as follows     overcharge protection voltage 4 250 0 025V  overdischarge protection voltage 2 30 0 08V  overcurrent protection  3 0A    8  Handling precautions on Lithium lon Rechargeable Battery    To assure product safety  describe the following precautions in the instruction manual of the  equipment       Danger    When charging the battery  use dedicated chargers and follow the specified conditions                       Library Name__ Cylindrical Li ion Rechargeable Batteries Date 2010 11 13                     Use the battery only in the specified equipment     Donot connect battery directly to an electric outlet or cigarette lighter charger     Do not heat or throw battery into a fire     Do not use  leave battery close to fire or inside of a car where temperature may be above  60  C  Also do not charge   discharge in such conditions     Donotimmerse  throw  and wet battery in water  seawater     Do not put batteries in your pockets or a bag together with metal objects such as necklaces   Hairpins  coins  or screws  Do not store batteries with such objects     Donot short circuit the     and     terminals with other metals     Donot place battery in a device with the     and     in the wrong way around     Do
    
Download Pdf Manuals
 
 
    
Related Search
    
Related Contents
system operations and programming guide  Fronius IG  OPERATOR`S MANUAL - Agilent Technologies  Troubleshooting Guide  Kerbl 84472 Amethyst User's Manual  DeLOCK RS-232, 1m  MPS-200 e-drum-modul bedienungsanleitung  OPTICAL MEASURING INSTRUMENTS ML9001A  ADTRAN T1 User's Manual    Copyright © All rights reserved. 
   Failed to retrieve file