Wind `N Go® 1-Watt Waterproof Flashlight #7351
Contents
1. NAL RECHARGEABLE 3 6V 800mAh Ni Mh BATTERY DC INPUT 6V 200 mA DC OUTPUT 6V 700 800 mA Te 1 Watt Waterproof DIMENSIONS 7 Lx 3 W x 2 25 H 173 x 69 x 56 5 mm aa BRIGHTNESS IN MCD watt center LED 250 000 MCD 20 Im Flashlight 2 side LEDs 30 000 MCD 4 Im POWER DURATION FLASHLIGHT O 1 minute winding 1 watt center LED 20 minutes 1 watt center LED 50 minutes a rad OPERATING INSTRUCTIONS AC DC Charge 1 watt center LED 8 hours 1 watt center LED 40 hours Full charge 8 hours 2 side LEDs 40 hours CELL PHONE CHARGING 1 3 minutes of 3 7 minutes of emergency talk time winding Longer talk times may be achieved with additional winding AERVOE INDUSTRIES INC Gardnerville NV 89410 1 800 227 0196 www aervoe com mailbox aervoe com 7351inst cs6 15 Wind N Go is a registered trademark of Aervoe Industries Inc2. Wind N Go 1 Watt Waterproof Flashlight 7351 IMPORTANT SAFEGUARDS e Read all instructions before operating e Do not look directly at the light may cause injury to your eyes e Do not use in flammable or explosive environments e Do not operate at temperatures above 120 F or below 32 F e Turn off flashlight before charging e Do not use alcohol flammable or other solvents on or near this unit only clean with warm water and soft cloth e Protect LED lens from damage and scratching e Administer close supervision when using around children e Never use or submerge in water with DC CAP removed PARTS IDENTIFICATION Dynamo Hand Crank DC In Out Port Wrist Strap 2 Standard LEDs On Off Button 1 Watt LED CHARGING Note Before charging turn flashlight off Dynamo charging by hand crank 1 Open DYNAMO HAND CRANK and rotate clockwise at approximately 120 cycles minute for a minimum of 1 minute Winding for longer periods of time will yield longer power durations Close DYNAMO HAND CRANK and unit is now ready for use If desired to verify that charging is taking place remove the DC IN OUT PORT cap to exposes the small green LED charge indicator light Caution Close cap and seal completely to assure waterproof integrity after charging and before use Do not open cap under water Unit may also be charged under water AC DC Adapter charging adapter not included 1 3 Charge the internal b
3. attery of the flashlight for increased standby power by using an auxiliary AC DC ADAPTER Remove the DC IN OUT PORT cap to expose the DC IN OUT PORT Carefully plug the small male connector of the AC DC ADAPTER into the DC IN OUT PORT Plug the adapter into an approved 120V AC power outlet Verify that the charge is taking place by assuring the small LED indicator light is illuminated Close cap and seal completely to assure waterproof integrity after charging and before use Full charge times are indicated in the specifications on the back page Charging a cell phone 1 Unit charges cell phones by using the DYNAMO HAND CRANK 2 Flashlight includes a Nokia cell phone adapter tip to match most common Nokia phones 3 To charge your phone connect the Universal DC cable into the DC IN OUT PORT of the flashlight Plug the other end of the cable directly into the Nokia phone or the appropriate adapter tip for your phone 4 Wind the flashlight DYNAMO HAND CRANK for a minimum of 1 3 minutes for a 1 5 minute phone call depending on cell phone model Longer cranking duration will increase talk time ability FLASHLIGHT OPERATION Press the ON OFF BUTTON located on front of flashlight Press once to activate the 2 left and right side LEDs Press twice to activate center 1 watt single LED Press third time to activate 1 watt single LED with flashers Press fourth time to turn flashlight off TECHNICAL INFORMATION SPECIFICATIONS INTER
Download Pdf Manuals
Related Search