Front Change Code digital lock Box Contents:
Contents
1. neoprene seals and install to door am me ze a N 2 o 10 3 Tight up the upper and lower al m fixing but DO NOT CLOSE THE DOOR UNTIL YOU ARE SURE THAT THE CODE WORKS DO NOT over tighten the fixing bolts as this may cause distortion and lead to poor operation Guide to Change Entry Code To change the code simple remove the lock from the door On the reverse of the digital lock you will see screw buttons Which relate to the push buttons on the front of the lock All code off All code on To set about to operate within the code turn the screw ee an Ov relating to the button so that the dot is facing inward DE towards the F if you wish to take a button out of the code Ms i De i Turn the screw so that the dot is facing outward towards G gt lt gt 0 07 Check the code on the lock to ensure the code works be De before re fitting the lock and closing the door Mc Ma o Important Note When the lock is coded and required to change new code First of all turn the coded button in clockwise direction by 180 degrees to cancel the original code Then set to new code 210 tk Sul 17 9mm YO iD 40 lil 130 mm uu 09 yy ua Jaqqn4 jo ulmno 130mm pos q qqn 102. 1 94 aut HOLVI 40 u l 0 yoon ww 09 y Suolp poz 4021
3. 4 Position the strike plate on the door so that it lines up with the flat of the latchbolt NOT THE PLUNGER Make the inner and outer edges of the strike plate and cut a 1mm rebate so that it fits flush with the surface of the door frame Drill or cut a recess for latchbolt Fit the strike plate using only one wood screw at first to ensure that it is positioned accurately The latch bolt and not the plunger should enter the aperture easily and be held without too much play When satisfied secure the strike with the second screw N B The plunger beside the latchbolt deadlocks the latchbolt and protects it against manipulation IT MUST NOT enter the strike plate aperture when the the door is closed Spring loaded Spindle installation 1 The split is loaded with spring Split line of ratch which ensures the split line is in line to the centre line of the latch YY 7 11 1444 VUUI VU 2 The spring can be used for door 7 12 i H thickness 35 60mm 2 3 The spring installed must be J Front plate inserted to the end of the L front plate Fixing the lock Ij 1 Cut the fixing bolt length to suit for the door thickness 000000 0009000 2 Put front and back plate with
4. Front Change Code digital lock FR FH G 5 Box Contents 1 Front plate Ss l 2 Back plate m 3 Neoprene seals x 2 4 Spindle o CNN 5 Latch En 6 Strike plate 7 VVood screvvs x 4 8 Fixing bolts x 2 Tools Required Power Drill 10mm 12mm 15mm amp 25mm drill bits Philips screwdriver Hammer mallet Chisel 25mm Stanley knife Adhensive tape pencil bradawl tape measure Installation Check the hand of your door Your door is right handed if viewed from outside the hinges are on the right Apply the template 1 Tape the template to the door Make sure that you fold it along the appropriate line depending on the backset of the latch 60mm n RIGHT HAND LEFT HAND 2 zm Oe OUTSIDE 5 2 Mark and drill two 10mm one 12mm and 14mm holes 3 Mark a central point on the centre line of latch on the door edge 4 Drill a 25mm hole x 85mm deep 5 Insert the latch into the hole and draw around the face plate 6 Remove the latch and cut a 3mm rebate so that the face plate will fit flush with the door 7 Secure the latch with the wood screws Fitting the strike plate
Download Pdf Manuals
Related Search