Dimplex DXGLO2 Instructions
Contents
1. that dust or fluff does not accumulate inside the heater as this could lead to overheating of the element Use a vacuum cleaner to remove any fluff which does accumulate Recycling For electrical products sold within the European Community At the end of the electrical products useful life it should not be disposed of with household waste Please recycle where facilities exist Check with your Local Authority or retailer for recycling advice in your country After Sales Service Your product is guaranteed for three years from the date of purchase Within this period we undertake to repair or exchange this product free of charge provided it has been installed and operated in accordance with these instructions Your rights under this guarantee are additional to your statutory rights which in turn are not affected by this guarantee Should you require after sales information or assistance with this product please go to www dimplex co uk where you will find our self help guide by clicking on After Sales or ring our help desk on 0845 600 5111 UK or 01 842 4833 R O Spare parts are also available on the website www dimplex co uk Please do not return a faulty product to us in the first instance as this may result in loss or damage and delay in providing you with a satisfactory service Please retain your receipt as proof of purchase Dimplex UK Ltd Millbrook House Grange Drive Hedge End Southampton Hampshire S2. ND RETAINED FOR FUTURE REFERENCE IMPORTANT SAFETY ADVICE DO NOT use the heater on deep pile carpets or the long hair type of rugs or less than 750mm away from any overhanging surface Keep combustible materials such as drapes and other furnishings clear from the front sides and rear of the heater Do not use heater to dry your laundry DO NOT use the heater in the immediate surroundings of a bath a shower or a swimming pool DO NOT place the heater directly below a fixed socket outlet The socket outlet must be accessible at all times to enable the mains plug to be disconnected as quickly as possible DO NOT COVER or obstruct the air inlet and outlet openings in any way The heater must be on a flat stable surface when in use DO NOT operate the heater with the mains lead overhanging the front outlet grille This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilites or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance THE HEATER CARRIES THE WARNING SYMBOL INDICATING THAT ITMUST NOT BE COVERED The instruction leaflet belongs to the appliance and must be kept in a safe place If changing owners the leaflet must be surrendered to the new owner IMPORTANT If
3. O30 2DF c Dimplex UK Limited www dimplex co uk Republic of Ireland Tel 01 8424833 All rights reserved Material contained in this publication may not be reproduced in whole or in part without prior permission in writing of Dimplex UK Limited
4. he coloured markings in your plug proceed as follows Connect the BROWN wire to the terminal marked L or coloured RED Connect the BLUE wire to the terminal marked N or coloured BLACK Note L or N must not be connected to the EARTH terminal marked E or or coloured GREEN or GREEN AND YELLOW If in doubt consult your electrician General The heater has a loading of 2kW Heat output and temperature control on this appliance are provided using the electronic control With the unit plugged in and by pressing the STAND BY button see 1 in Fig 4 the heater can be activated The appliance is provided with a handle for easy carrying see Fig 3 Operation see Fig 4 The heat output is electronically controlled according to the room temperature To activate the appliance press the STAND BY button see 1 in Fig 4 Press button 2 to select Fan only Low heat High heat By pressing this button once Fan only is selected pressing twice provides Low heat and by pressing three times High heat is selected On the display screen see Fig 4 two temperature readings appear at the top of the screen The room ambient temperature appears on the right and the desired temperature appears on the left hand side Use buttons 3 and 4 to set the desired room temperature when Low or High heat is selected The temperature can be set from 5 C to 35 C and this will be
5. shown on the display When the temperature is reached the heater will automatically switch off If the ambient temperature drops the heater will come on again automatically Note the electronic climate control device conserves energy and assists with temperature regulation e g if the heater is set to HIGH heat and the temperature is set to 28 C at 27 C the heater will switch to LOW heat Then at 28 C the heater will switch OFF completely An audible beep can be heard when any button is pressed A double beep can be heard when 5 and 35 is selected the upper and lower limits By keeping buttons 3 and 4 pressed down the user can scroll quickly to the desired temperature Note The heater retains it s last setting once the appliance has been switched off or disconnected from the power supply Overheat cut out The built in overheat cut out switches off the appliance automatically in the event of a fault Disconnect the mains plug from the socket After a short cooling down phase the appliance switches into stand by mode and is ready for use again If the fault should occur again see your local dealer Cleaning WARNING ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER Do not use detergents abrasive cleaning powders or polish of any kind on the heater Wipe with a dry cloth to remove dust and a damp cloth not wet to clean off stains Be careful not to allow moisture into the heater Ensure
6. the mains lead of this appliance is damaged it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard WARNING In order to avoid a hazard due to inadvertent resetting of the thermal cut out this appliance must not be supplied through an external switching device such as a timer or connected to a circuit that is regularly switched on and off by the utility Electrical connection This heater must be used on an A C supply only and the voltage marked on the heater must correspond to the supply voltage This heater is fitted with a plug incorporating a 13 amp fuse When replacing the fuse a 13 amp fuse approved by ASTA to BS 1362 must be used If the plug is not suitable for the socket outlets in your home the plug must be cut off and an appropriate one fitted A plug cut off from a mains lead will give a shock hazard if inserted into a 13 amp socket elsewhere in the house To avoid this it should be disposed of immediately NOTE The fuse cover of a non rewirable plug must be refitted when changing the fuse Should the cover become lost the plug must not be used until the correct replacement fuse cover is obtained from your supplier or by contacting our customer helpline IMPORTANT The wires in this mains lead are coloured in accordance with the following code BLUE NEUTRAL BROWN LIVE As the colours of the wires in the mains lead may not correspond with t
7. xX Dimplex A world of expertise Contact Details Please note that some of the contact details on this PDF document may not be current Please use the following details if you need to contact us Telephone 0844 879 3588 Email customer services gdcgroup co uk The customer support section of our website also features a wide range of information which may be of use to you and is available 24 hours a day It includes e Operating and installation instructions e Easy How to use guides for storage heaters e Service and repairs e Where to buy our products e Literature downloads e Heating requirement calculator Visit www dimplex co uk support A division of GDC Group Ltd Registered No 1313016 England Millbrook House Grange Drive Hedge End Southampton S030 2DF eal rea ea N roducer Registration Number www dimplex co uk WEE GE0057TS Paper from sustainable sources X lt Dimplex DXGLO2 Electric Fan Heater with Climate Control 08 35287 0 Issue 0 The product complies with the European Safety Standards EN60335 2 30 and the European Standard Electromagnetic Compatibility EMC EN55014 EN60555 2 and EN60555 3 These cover the essential requirements of EEC Directives 2006 95 EC and 2004 108 EC DXGLO2 2kW Fan Heater THESE INSTRUCTIONS SHOULD BE READ CAREFULLYA
Download Pdf Manuals
Related Search