Miller Nitro AutoSPRAY cable Installation Manual
Contents
1. Miller Nitro AutoSPRAY cable Part No 1 2844 Installation Manual Part Number 1 1281 Revision C Issue Date October 2008 when it has to be right Seica Geosystems R NEX INTRODUCTION The Miller Nitro AutoSPRAY Cable Part No 1 2844 is designed to suit the following installations Compatible Spray Controllers Miller Nitro 2200 Miller Nitro 3200 Miller Nitro N2XP Miller Nitro 2275 Miller Nitro 3275 The cable will control up to five individual boom sections and will also detect the status of the Master Switch in the installation Dhe Wi ul H J i li Hi 1 a lil LT a i ee Figure 1 AutoSPRAY Interface Cable Part No 1 2844 INSTALLATION A schematic of the cable installation is shown in Figure 2 yoy stick section SWilChas 6928 6 gt Maala Sw AutoSPRAY AuteSPRAY Cable 1 2644 Ee EE eee Figure 2 Schematic layout of typical AUtoSPRAY installation 1 1281 Rev C Miller Nitro AutoSPRAY Cable Installation Page 1 It is recommended that all electrical wiring should be Installed by a qualified auto electrician Incorrect wiring may damage the AutoSPRAY controller and or the spray rate controller The installation and configuration of the RINEX AutoSPRAY controller is detailed in the appropriate User Manual Step l Note Instruction Check that the spray controller and boom section switches are functioning correctly before commencing the instal2. is controlled with the vehicle ignition wiring power with the vehicle is ON Then connect the BLACK wire labelled GROUND to a ground point on the vehicle l 1281 Rev C Miller Nitro AutoSPRAY Cable Installation Page 3
3. lation Locate the wiring panel inside the cabin at the rear right hand side of the drivers seat with the spray control wiring harness The supplied 1 2844 Nitro AutoSPRAY interface cable simply connects in line with the harness as shown in Figure 2 Confirm that the spray controller and boom section switches function correctly before connecting the cable to the RINEX AutoSPRAY controller Check that all section switches function correctly and the controller still displays the correct flow rate Connect the 16 pin circular AMP connector on the other end of the 1 2844 Nitro AutoSPRAY cable to the RINEX AutoSPRAY controller Confirm that the spray controller and boom section switches function correctly f the RINEX AutoSPRAY controller is not connected directly to a 12Vdc source vehicle power then it is necessary to connect the AutoSPRAY cable to the vehicle power supply for correct operation of the system Refer to APPENDIX A for connecting to vehicle power l 1281 Rev C Miller Nitro AutoSPRAY Cable Installation Page 2 R NEX APPENDIX A CONNECTING POWER Power for the AutoSPRAY Controller cable must be a clean 12Vdc source Connecting the AutoSPRAY controller to 24Vdc will cause damage to the controller If connecting to a 24Vdc vehicle 12Vdc power must be connected to the same power source the spray rate controller Is using Step Instruction l Connect the RED wire labelled POWER to a 12Vdc power source that
Download Pdf Manuals
Related Search