INSTRUCTIONS - Harley
Contents
1. lt MOTOR2 HARLEY DAVIDSON NY General This Control Power Supply Harness is designed for use with the following FLHP I and FLHTPI models when equipped with Police Tour Pak Kit Part Number 53238 01 or 53239 01 and Front Mounted Strobe Lights J02192 FXDP models when equipped with Police Tour Pak Kit Part Number 53240 01 or 53241 01 and Front Mounted Strobe Lights See Service Parts Illustration for kit contents NOTE A Service Manual for your vehicle is available from your Harley Davidson dealer Installation 1 See Figure 1 and Service Parts Illustration Obtain Harness 2 from kit Route Spade end of harness through Tour Pak as shown and connect the 3 Pin connector to the power supply 2 Route spade end out through bottom of Tour Pak and lay aside Gain access to the flasher connector by performing the following FXDP Models Follow instructions in applicable Service Manual and remove the Tank Console Locate flasher connector FLHP I Models Remove amplifier from left saddlebag support to provide access to left cover Remove left side cover by pulling away from grommets Locate flasher connector FLHTPI Models See Figure 4 Remove the outer fairing per the Service manual instructions to locate the pursuit flasher connector 3 See Figure 2 Locate X spade position on Connector 4 Install spade terminal from harness into the X position of flasher connector See Figure 3 P2. ower supply N A J02192 2 of 2
3. ush conduit up over spade terminal housing and using cable strap 1 secure spade terminal to flasher connector by wrapping around conduit then fastening to connector as shown Using another cable strap secure flasher connector to something rigid to eliminate rattle 5 FXDP Models Follow instructions in applicable Service Manual and re install Tank Console FLHP I Models Install left side cover to grommets FLHTPI Models Reinstall outer fairing per service manual instructions 6 Pull excess harness inside Tour Pak and use remaining cable straps 1 to secure harness to right side fender support 7 If installed test lamps for proper operation Kit Number 70669 01 i03792 S1 Connect 3 gt Pin Terminal INSTRUCTIONS REV 2 26 02 HARNESS KIT FOR POLICE TOUR PAK 7 Route Spade End of Terminal Through Tour Pak Figure 1 Route Harness through Tour Pak and Connect 3 Pin Connector Cable Strap Routed Through Center Of Connecter and Fastened 103793 uy Spade Terminal Position X Position on Connector Cable Strap Wrapped Around Conduit Figure 3 Connect Spade Terminal To Flasher Connector Then Secure 1 of 2 04635 Pursuit flasher connector Figure 4 Inner Fairing Connectors FLHTP lI Part No 70669 01 Date 2 02 103795 Item Description Qty Part Number 1 Strap cable 3 10181 2 Harness control p
Download Pdf Manuals
Related Search