Parts List Installation Instructions Part Number 450-610
Contents
1. www atraid com2. Installation Instructions Part Number 450 610 n Poweraid Spacer For OWE F AED 2005 09 Ford Mustang GT 4 6L V 8 Parts List 1 Poweraid Spacer xI 2 6mmx50mm Bolts x4 3 6mm Flat Washers x4 4 Fiber Gasket x1 Tools Required For Installation 5 16 Deep 10mm Sockets Ratchet and Extension 10mm Wrench Thank you for purchasing the Poweraid Throttle Body Spacer Please read the in struction manual carefully before proceeding with the installation Contact AlIRAID 800 498 6951 8 00 AM 5 00 PM MST Weekdays for questions regarding fit or instructions that are not clear to you Your Poweraid Throttle Body Spacer was carefully inspected and packaged Check that no parts are missing or were damaged during shipping If any parts are missing please contact AIRAID Included with your Poweraid Spacer is a sticker with a California Air Resources Board C A R B Executive Order EO number This sticker must be placed in plain view inside of the engine compartment Failure to do so may prevent you from passing a smog inspection Thank you for selecting AI RAID 1 Disconnect the negative battery cable 2 Remove beauty cover on top of intake manifold if Using a 5 16 socket loosen two hose clamps that equipped 2008 09 hold the intake tube between the throttle body and the A Using a 5 16 deep socket remove two studs from air Cleaner lid the top of the throttle body Turn the green tab and disconnect the br
3. eather hose B Using a 10mm socket remove two nuts from the from the air intake tube Remove the tube from the studs on the bottom of the throttle body vehicle Flip the throttle body out of the way 4 Install two bolts 2 and washers 3 thru the as shown on one of the studs snug them together and throttle body thru the gasket 4 thru the Poweraid then turn the nut closest to the manifold and remove Spacer 1 and into the intake manifold as shown the stud Repeat the procedure on the second stud Use caution to retain the factory o ring gasket on the plastic intake manifold Next install the remaining bolts in the bottom holes of the throttle body and tighten evenly to the manufac ture s specifications Do Not Over Tighten The Bolts e A L a 6 Inspect amp test the throttle linkage for full open phia and closed travel before driving Some cruise and kickdown cables may require adjustment Please refer to vehicles service manual for proper adjust ment 7 Re connect the negative battery cable o ee 5 Reinstall the intake tube and tighten the hose clamps Reconnect the breather hose to the intake tube The sound of power The whistle means its working Contact your nearest Airaid dealer for an Airaid Intake System for your car truck or SUV Instructions Revision 07 15 08 AIRAID Filter Co 2688 E Rose Garden Ln Phoenix AZ 85050 800 498 6951 _AiraidinfoQaraid com
Download Pdf Manuals
Related Search