Tusk Clutch Holding Tool Instructions
Contents
1. OFF ROAD Tusk Clutch Holding Tool Instructions Note Always refer to your service manual for proper instructions for your specific machine and safety information Improper use may damage the tool or engine parts General information The tusk clutch holding tool can be used to hold the inner clutch hub on most motorcycles and ATVs It is only recommended on inner clutch hubs with square style teeth The tool can also be used to hold flywheels gears sprockets and other parts for easier removal Clutch hub instructions Place the jaws on the clutch hub so the ends fit into the square grooves where the drive plates steel plates would usually rest Using the adjusting bolt on the back of the tool adjust the tension so the tool can apply light pressure on the hub when clamped down Caution Do not overtighten If the tool is too tight you will damage the inner hub Enough pressure to barely hold the tool in place is all that is needed With the clutch hub held in place the center nut can be removed with the appropriate wrench Other uses The Tusk clutch holding tool can be used to hold flywheels gears sprockets and other items with the appropriate sized holding holes The pins on the back of the jaws are used to fit into the holding holes Simply use the jaw adjusting bolt to set the tool to fit the object you are holding Once again there should only be light pressure used to cla2. mp the tool to the object Once in place you can hold the object and more easily remove or tighten the nut or bolt
Download Pdf Manuals
Related Search