ObservaDome™ Recessed Camera Enclosure
Contents
1. 81 Dome Ceiling panel with cutout Camera mount 3 14 20 thumb screws il Remove section of ceiling tile where intending to install unit Remove adjacent section of ceiling tile as well for installing camera housing and making proper adjustments Be sure Ceiling grid is adequately supported from above 2 Place OHO81 Dome down into cutout of the supplied ceiling panel As seen in Figure 1 3 Install panel with dome in ceiling 4 Attach camera to mount using a 14 20 thumb screw Using 2 4 20 thumb screws attach camera with mount using the bottom holes on yoke and tighten thumb screws on ttach video and power cables to camera D ake all camera tilt adjustments by loosening thumb screws nd adjusting mount e N nstall camera and housing using adjacent open area by placing back box onto top of panel and dome Pan by manually rotating camera housing to desired position Refer to Figure 2 8 Make all neccessary camera zoom and or focus adjustments 9 Replace ceiling panel that you removed earlier back to proper position Black ABS Back Box Figure 1 PVC CEILING PANEL Figure 2 lt 23 75 BACK BOX WITH INTEGRATED TILT MOUNT PVC CEILING PANEL 8 INCH DIA OPTICALLY CORRECT DOVE TYPICAL CAMERA NOT SUPPLIED2. Installation and Operation Instructions MA O O gt Before attempting to connect or operate this product please read these instructions completely 0H031 ObservaDome Recessed Camera Enclosure OHO81TL eee 8 Drop Ceiling dome housing tinted dome 1 fixed camera bracket liner and dust cover MCL 8 OHO81D eee 8 Drop Ceiling dummy dome OHO81CL cee 8 Drop Ceiling dome housing clear dome 1 fixed camera bracket liner and dust cover MCL 8 Moog Inc Sensor and Surveillance Systems 2013 Moog Inc All Rights Reserved 3650 Woodhead Drive Northbrook IL USA 60062 1 847 498 0700 Fax 1 847 498 1258 www moogS3 com 81 IN5271 111413 IMPORTANT SAFEGUARDS SAFETY PRECAUTIONS 1 Read these instructions 2 Keep these instructions CAUTION 3 Heed all warnings RISK OF ELECTRIC SHOCK 4 Follow all instructions DO NOTOFEN 5 Do not use this apparatus near water CAUTION TO REDUCE THE RISK OF 6 Clean only with damp cloth ELECTRIC SHOCK DO NOT REMOVE 7 Do not block any of the ventilation openings Install in accordance with the COVER OR BACK NO USER SERVICE AAR PAGtUror Sinsation ABLE PARTS INSIDE REFER SEVICING TO QUALIFIED SERVICE PERSONNEL 8 Cable Runs All cable runs must be within permissible distance Mounting This unit must be properly and securely mounted to a supporting structure capable of sustaining the weight of the unit Accordingly The lightning flash with an arr
3. accident or acts of God i e hurricanes earthquakes modification failure of the end user to follow the directions outlined in the product instructions failure of the end user to follow the maintenance procedures recommended by the International Security Industry Organization written in product instructions or recommended in the service manual for the Product Furthermore Manufacturer shall have no liability where a schedule is specified for regular replacement or maintenance or cleaning of certain parts based on usage and the end user has failed to follow such schedule attempted repair by non qualified personnel operation of the Product outside of the published environmental and electrical parameters or if such Product s original identification trademark serial number markings have been defaced altered or removed Manufacturer excludes from warranty coverage Products sold AS IS and or WITH ALL FAULTS and excludes used Products which have not been sold by Manufacturer to the Purchaser All software and accompanying documentation furnished with or as part of the Product is furnished AS IS i e without any warranty of any kind except where expressly provided otherwise in any documentation or license agreement furnished with the Product ANY COST ASSOCIATED WITH REMOVAL OF DEFECTIVE PRODUCT AND INSTALLATION OF REPLACEMENT PRODUCT IS NOT INCLUDED IN THIS WARRANTY 4 PROOF OF PURCHASE The Purchaser s dated bill of sale must be retai
4. e 5 Years Controllers Three 3 Years Power Supplies IR Illuminators Three 3 Years Poles PolEvators CamEvator Three 3 Years Warrior Series Q View Three 3 Years SView Series Three 3 Years 6 months if used in auto scan tour operation DeputyDome NiteTrac Igloo Dome PurgeDome Three 3 Years 6 months if used in auto scan tour operation EXO Series Dome and Fixed Camera Systems Three 3 Years 6 months if used in auto scan tour operation EXO Series GeminEye Visible and Thermal Camera Systems One 1 Year During the labor warranty period to repair the Product Purchaser will either return the defective product freight prepaid or deliver it to Manufacturer at Moog Decatur Operations 2525 Park Central Boulevard Decatur Georgia 30035 The Product to be repaired is to be returned in either its original carton or a similar package affording an equal degree of protection with a RMA Return Materials Authorization number displayed on the outer box or packing slip To obtain a RMA you must contact our Technical Support Team at 800 554 1124 extension 101 Manufacturer will return the repaired product freight prepaid to Purchaser Manufacturer is not obligated to provide Purchaser with a substitute unit during the warranty period or at any time After the applicable warranty period Purchaser must pay all labor and or parts charges The limited warranty stated in these product instructions is subject to al
5. ichtigen Anweisungen in der Literatur alarmieren die das Ger t begleitet Este s mbolo do ponto do exclamation pretendido alertar o usu rio presen a de instru es importantes na literatura que acompanha o dispositivo Questo simbolo del punto del exclamaton inteso per avvertire l utente alla presenza delle istruzioni importanti nella letteratura che accompagna l apparecchio MADEIN L8 E749 BUY AMERICA COMPLIANT COUNTRY OF ORIGIN U S A Product Warranty Registration Register Your Products Online www moogS3 com technical support product registration Moog values your patronage We are solely committed to providing you with the highest quality products and superior customer service With 3 Year and 5 Year warranties depending on the product purchased we stand behind every product we sell See full warranty details at www moogS3 com technical support warranty plan Register your products today to receive the following benefits e Simple and Trouble Free RMA process e Product software updates e Special promotions e Eliminate the need to archive purchase documents such as receipts purchase orders etc Limited Warranty for Moog Products Moog Decatur Operations subsequently referred to as Manufacturer warrants these products to be free from defects in material or workmanship as follows PRODUCT CATEGORY PARTS LABOR All Enclosures and Electronics Five 5 Years Accessory Brackets Fiv
6. l of the following terms and conditions TERMS AND CONDITIONS 1 NOTIFICATION OF CLAIMS WARRANTY SERVICE If Purchaser believes that the Product is defective in material or workmanship then written notice with an explanation of the claim shall be given promptly by Purchaser to Manufacturer All claims for warranty service must be made within the warranty period If after investigation Manufacturer determines the reported problem was not covered by the warranty Purchaser shall pay Manufacturer for the cost of investigating the problem at its then prevailing per incident billable rate No repair or replacement of any Product or part thereof shall extend the warranty period of the entire Product The specific warranty on the repaired part only shall be in effect for a period of ninety 90 days following the repair or replacement of that part or the remaining period of the Product parts warranty whichever is greater 2 EXCLUSIVE REMEDY ACCEPTANCE Purchaser s exclusive remedy and Manufacturer s sole obligation is to supply or pay for all labor necessary to repair any Product found to be defective within the warranty period and to supply at no extra charge new or rebuilt replacements for defective parts 3 EXCEPTIONS TO LIMITED WARRANTY Manufacturer shall have no liability or obligation to Purchaser with respect to any Product requiring service during the warranty period which is subjected to any of the following abuse improper use negligence
7. ned as evidence of the date of purchase and to establish warranty eligibility DISCLAIMER OF WARRANTY EXCEPT FOR THE FOREGOING WARRANTIES MANUFACTURER HEREBY DISCLAIMS AND EXCLUDES ALL OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING BUT NOT LIMITED TO ANY AND OR ALL IMPLIED WARRANTIES OF MERCHANTABILITY FITNESS FOR A PARTICULAR PURPOSE AND OR ANY WARRANTY WITH REGARD TO ANY CLAIM OF INFRINGEMENT THAT MAY BE PROVIDED IN SECTION 2 312 3 OF THE UNIFORM COMMERCIAL CODE AND OR IN ANY OTHER COMPARABLE STATE STATUTE MANUFACTURER HEREBY DISCLAIMS ANY REPRESENTATIONS OR WARRANTY THAT THE PRODUCT IS COMPATIBLE WITH ANY COMBINATION OF NON MANUFACTURER PRODUCTS OR NON MANUFACTURER RECOMMENDED PRODUCTS PURCHASER MAY CHOOSE TO CONNECT TO THE PRODUCT LIMITATION OF LIABILITY THE LIABILITY OF Manufacturer IF ANY AND PURCHASER S SOLE AND EXCLUSIVE REMEDY FOR DAMAGES FOR ANY CLAIM OF ANY KIND WHATSOEVER REGARDLESS OF THE LEGAL THEORY AND WHETHER ARISING IN TORT OR CONTRACT SHALL NOT BE GREATER THAN THE ACTUAL PURCHASE PRICE OF THE PRODUCT WITH RESPECT TO WHICH SUCH CLAIM IS MADE IN NO EVENT SHALL MANUFACTURER BE LIABLE TO PURCHASER FOR ANY SPECIAL INDIRECT INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY KIND INCLUDING BUT NOT LIMITED TO COMPENSATION REPLACEMENT LABOR COSTS REIMBURSEMENT OR DAMAGES ON ACCOUNT OF THE LOSS OF PRESENT OR PROSPECTIVE PROFITS OR FOR ANY OTHER REASON WHATSOEVER Field Installation Included items Black ABS Back Box Yoke OHO
8. owhead symbol 10 a This installation should be made by a qualified service person and should conform to all local codes b Care should be exercised to select suitable hardware to install the unit taking into account both the composition of the mounting surface and the weight of the unit Do not install near any heat sources such as radiators heat registers stoves or other apparatus including amplifiers that produce heat within an equilateral triangle is intended to alert the user to the presence of non insulated dangerous voltage within the product s enclosure that may be of sufficient magnitude to constitute a risk to persons Este simbolo se piensa para alertar al usuario a la presencia del voltaje peligroso no aislado dentro del recinto de los 11 Do not defeat the safety purpose of the polarized or grounding type plug A productos que puede ser un riesgo de choque el ctrico polarized plug has two blades with one wider than the other A grounding type plug has two blades and a third grounding prong The wide blade or the third Ce symbole est pr vu pour alerter l utilisateur la presence ided f f Wh h idedibl ad fiti de la tension dangereuse non isol e dans la cl ture de prong are provided for your safety en the provided plug does not fit into your produits qui peut tre un risque de choc lectrique outlet consult an electrician for replacement of the obsolete outlet 12 Protect the power cord f
9. rom being walked on or pinched particularly at plugs Dieses Symbol soll den Benutzer zum Vorhandensein der i g nicht Isolier Gef hrdungsspannung innerhalb der convenience receptacles and the point where they exit from the apparatus ProdukteinschlieBung alarmieren die eine Gefahr des 13 Only use attachment accessories specified by the manufacturer elektrischen Schlages sein kann 14 Use only with a cart stand tripod bracket or table specified by the manufact y 4 Aid ete en o ei S yane PAN Este s mbolo pretendido alertar o usu rio presen a di or sold with the apparatus When a cart is used use caution when moving the cart tens o perigosa non isolada dentro do cerco dos produtos apparatus combination to avoid injury from tip over que pode ser um risco de choque el trico 15 Unplug this apparatus during lighting storms or when unused for long periods of time Questo simbolo inteso per awvertire l utente alla presenza 16 Refer all servicing to qualified service personnel Servicing is required when the di tensione pericolosa non isolata all interno della apparatus has been damaged in any way such as power supply cord or plug is damaged liquid has been spilled of objects have fallen into the apparatus the apparatus has been exposed to rain or moisture does not operate normally or has been dropped recinzione dei prodotti che pu essere un rischio di scossa elettrica Be sure to periodically examine the
10. unit and the supporting structure to make sure that the integrity The exclamation point within an equilateral triangle is intended to alert the user to of the installation is intact Failure to comply with the foregoing could result in the unit separating from the support structure and falling with resultant damages or injury to anyone or anything struck by the falling unit UNPACKING Unpack carefully Electronic components can be damaged if improperly handled or dropped If an item appears to have been damaged in shipment replace it properly in its carton and notify the shipper Be sure to save 1 The shipping carton and packaging material They are the safest material in which to make future shipments of the equipment 2 These Installation and Operating Instructions SERVICE If technical support or service is needed contact us at the following number TECHNICAL SUPPORT AVAILABLE 24 HOURS 1 800 554 1124 presence of important operating and maintenance servicing instructions in the literature accompanying the appliance Este simbolo del punto del exclamation se piensa para alertar al usuario a la presencia de instrucciones importantes en la literatura que acompa a la aplicaci n Ce symbole de point d exclamation est pr vu pour alerter l utilisateur la presence des instructions importantes dans la litt rature accompagnant l appareil Dieses Ausruf Punktsymbol soll den Benutzer zum Vorhandensein de w
Download Pdf Manuals
Related Search