User manual Reda EN
Contents
1. e When the red lamp blinks the lift unit should be taken out of use to be charged e The green lamp lights up when the battery is fully charged Procedure for charging via a charger station Move the lift unit to the charger station at the end of the rail A green diode on the lift unit indicates that charging is in progress The lamp switches off after 10 minutes e When battery charge is low a red diode lights up e When the red lamp blinks the lift unit should be taken out of use to be charged e The green lamp lights up when the battery is fully charged Charge indication The lift unit has two charge indicators One signals that battery charge is low and one indicates that the lift unit is connected to the charger The lift unit will indicate the following when charge is low e A tone will be audible e A red diode will light up NOTE The emergency stop button must not be pressed in during charging Accessories from SystemRoMedic Scale m SystemRoMedic s Scale660 and Scale880 are used together with stationary or mobile lifts for weighing of users Article no 70100002 0 Article no 70200003 i Positioning aids TopSheet Article no 1510 or 1520 SafeHandlingSheet Article no 47522007 SafeHandlingSheet disposableArticle no 47592006 RoMedicClips pair Article no 70200007 Z For more information about SystemRoMedic manual transfer assistive devices and lifting accessories please visit www2. lead accumulator gel type batteries Charger IN Mascot 2240 100 240VAC 50 60Hz Max 0 35A Charger OUT 24 VDC 27 6 0 3 Max 0 5A Intermittent operation _ Int Op 10 90 active op max 2 min Out of a time of 100 active time must be less than 10 though not more than 2 min Emergency lowering ___ Electrical Handcontrol Electrical Handcontrol pressure __ 2 1 N SWL 230 kg 505 Ibs Lifting range 235 cm 92 5 inch Dimensions 30 1x26 7x13 9 cm 11 9x10 5x5 5 inch Safety class lift unit IPXX Safety class handcontrol IP65 Estimated service life __ 10 years The device is intended for indoor use Type B according to the degree of protection against electric shock
3. handicare com a Accessories from Ready for life The Ready for life four point slingbar Sling bar RFL X4 is designed to provide more space in the sling for example for obese and or pain sensitive users Article no 70200017 Handcontrol Raising lowering the sling bar a Arrows indicate direction of travel Motion stops as soon as Jar the button is released H Switching the lift unit on The handcontrol is equipped with an On button and an Emergency stop button To save power the lift unit which is wail charged via a charger station switches off after 10 minutes of inactivity The lift unit must then be reactivated via the On button on the handcontrol Emergency stop Emergency stop Press the red emergency stop button on the handcontrol or on the underside of the lift unit Reset Cd N Emergency Switch the lift unit on via the On button on the stop 4 a handcontrol d H On button emergency Emergency lowering aep gt Electrical emergency lowering Press the red button on the underside of the o lt gt lift unit Motion stops as soon as the button S is released DP Emergency lowering Maintenance The lift must undergo thorough inspection at least once per year This must be done by authorized Handicare service personnel and in accordance with Handicare s service manual Repairs and maintenance may only be done by authorized personnel using original spare parts Sf Spent batter
4. Dimensions Reda 191 All measurements are in mm Veddestav 15 Box 640 s a SE 175 27 J rf lla 9 handicare SWEDEN Internet www handicare com E mail info handicare se Tel 46 0 8 557 62 200 Fax 46 0 8 557 62 299 e Functional inspection Visual inspection Inspect lift functions regularly Check to ensure that material is free from damage Before use Make certain the lift is properly assembled Check rail end stops Check sling bar connection and safety latch function Check lifting movement Cii Always read the manual Read instructions for all assistive devices used in connection with transfers Keep the manual where it is accessible to users of the product Under no circumstances may the lift be used by persons who have not received instruction in the operation of the lift English P eadytor fe Manual Reda Manual nr 00780En Ver 3 110316 Ready for life is a series of assistive devices that are designed to give users the best possible conditions for living an active life on a daily ba sis The products have been specially developed to meet the conditions for homecare and institutional care settings Ready for life offers the right quality the right function and the right performance at the right price The transfer assistive products can be used either independently or as a complement to products in the SystemRoMedic range Assembly of Reda Check to ensure that all
5. afe and easy transfers of patients weighing up to 230 kg 505 Ibs Installation of a lift unit that charges via a charger station The lift unit is mounted so that the charging plate faces the end of the rail A charger sta e tion is then mounted at the end of the rail The charger station acts as an end stop The lift unit is placed against the charger station for charging Check to ensure that the charging plate on the lift unit comes in contact with the charger station Final inspection Check to ensure that no parts have been left in the packaging Inspect the lift for signs of wear and damage Check all connections and fixtures including screws and bolts Check emergency stop function by depressing the emergency stop button and then pressing either the Up or Down button If nothing happens when the Up or Down buttons are pressed the emergency stop is functioning properly Check the entire length of the lift strap for signs of damage and inspect seams for wear Press the Up button and run the lift strap all the way up Then press the Down button and run the lift strap all the way down Test lift function by lifting a person not a patient using an approved sling At the same time check the emergency lowering function with someone in the lift See section on Emergency Lowering Check to ensure that the track system is equipped with end stops Run the lift to the charger station at the end of the track and check to
6. also be equipped with many clever and functional accessories from the SystemRoMedic lifting range For security reasons Always read the manual and remember that lifting accessories must be properly trial fitted and tested in relation to the user s needs and functional ability Slings SystemRoMedic offers a wide variety of functional and comfortable high quality lifting slings adapted to meet the different requirements of all kinds of lifting situations and users The lifting slings are available in four different materials and in sizes ranging from XXS to XXL All models are safe and very easy to use and have a safe working load of up to 300 kg 660 Ibs Sling bars SlingBar is SystemRoMedic s aluminium sling bar It s _ available in three different widths and is therefore suitable in most lifting situations and for users of all sizes SlingBar S Article no 70200001 SlingBar M Article no 70200002 SlingBar L Article no 70200003 Side bars are used in combination with the standard two point sling bar delivered with Reda to provide more space Glu in the sling for large users They open up the sling and enable more reclined comfortable position SideBar Article no 70200013 Charging batteries Procedure for in rail charging The lift unit charges continuously when the green diode on the unit lights during use The lamp switches off after 10 minutes of inactivity e When battery charge is low a red diode lights up
7. components are included Lift unit sling bar and handcontrol with cable Manual and charger Installation of a lift unit that charges via the rail The lift unit is mounted on the rail so that the charging wheel with the red cable runs in the positive rail The charging wheel with the black cable runs in the negative rail Push the charging wheels forward red and backward black when the lift unit is installed on the rail Check to ensure that the charging wheels on the lift unit come in contact with the contact plates When the lift unit has been installed connect the cable from the charger to the contact plates Install an end stop at the end of the rail cE 1 Lift unit 2 Sling bar 3 Safety latch 4 Handcontrol with emergency stop button and On button 5 Emergency stop emergency lowering red button Safe working load 230 kg 450 Ibs The product meets the requirements of the Medical Devices Directive 93 42 EEC Reda is a safe and easy to use overhead lift unit that combines new design with well thought out and proven functionality Reda is suitable for use with all types of rails on both permanent rail systems and on portable freestanding lift stands It is very easy to use moves silently and gently and features many functions that maximize comfort and security Reda is delivered complete with a sling bar and a whole new unique and user friendly handcontrol Reda is all you need to perform s
8. ensure that the charging lamp lights NOTE Before the lift is used for the first time it must be charged for at least 4 hours See section on charging batteries Keep the manual where it is accessible to users of the product How to use the product A Important information e The lift system must be installed according to Handicare s installation guide e The lift may only be used indoors e Lifting accessories must be properly trial fitted and tested in relation to the patient s needs and functional ability e Do not leave the patient unattended during a transfer situation e Under no circumstances may max load be exceeded See section on max load e The lift must not come in direct contact with water e The lift must not be charged in a wet room e To ensure optimal function the lift must be inspected regularly See section on maintenance e Warranty applies only if repairs or alterations are done by an authorized technician Safe working load Different products on the assembled lift system ie lift sling bar lifting sling scale and other accessories may have different safe working loads It is always the lowest maximum allowable load indicated for the respective products on the system that applies for the entire system Always check the markings on all products in the unit and contact Handicare with any questions Accessories from SystemRoMedic Reda are delivered complete and ready to use but they can
9. ies are to be left at the nearest recycling station or returned for recycling to Handicare or a Handicare dealer Cleaning Clean the lift with warm water or rubbing alcohol Do not use cleaning agents containing phenol or chlorine as this may damage the material Storage If the lift is not to be used for some time or e g when transporting we recom mend that the emergency stop button be pressed in Store the lift at a tempe rature exceeding freezing point and at normal relative humidity about 60 Service agreements Handicare offers the possibility of service agreements for maintenance and regular testing of your mobile lift Contact your local Handicare representative Lift strap Lifting must always be performed verti cally from directly above the centre of gravity to ensure that the lift strap feeds in and out of the lift unit without binding a Make sure that the strap is not twisted Trouble shooting If the lift is not working check to ensure the following That the lift unit is switched on That the cable for the handcontrol is properly and securely connected Pull out the contact and plug it in again firmly That the battery is charged If the lift is not working properly contact your dealer Technical information Motor 24VDC Motor chassies Fire resistant ABS plastic Sound level Lifting speed 5 5 cm s 1 38 inch s Batteries 24 VDC 2 pcs 12VDC 2 9 Ah valve regulated sealed
Download Pdf Manuals
Related Search