WATER WIZARDTM HAND PUMP MODEL 150
Contents
1. SHURIIo WATER WIZARD HAND PUMP MODEL 150 gt E SPOUT lt DD TRIM COVER FEATURES ye ie e Delivers Water in both stroking directions e Retrofits into most existing hand pump installations e Twist of the Wrist Hands Free operation with city water Lie e Easy winterizing and sanitizing T F e FDA materials e All corrosion resistant materials e Parts supplied with aftermarket pump model 150 001 00 1 Swivel Barb 1 2 Hose Fitting 8 161 00 2 Hose Clamps 4 6 Screws 1 Sealing Cap READALL INSTRUCTIONS BEFORE STARTING THE INSTALLATION CAUTION DO NOT freeze with water in pump Refer to page 2 for E N na Winterizing instructions o RR c gt CAUTION DO NOT snap the square trim cover to the pump until the unit is correctly located and screwed into position NOTE To remove trim plate slip screwdriver into slot on plate and gently pry up on both sides 3 8 10mm INLET FITTING gt i gt POTABLE TANK gt REGULATED The procedure outlined below is for new installations To install CITY WATER the spout there must be 21 6 35 cm clearance from the template centerline to any interference behind the unit back wall and there must be 4 12 06 cm from the centerline to any interference to the left side of the unit see template If the Wizard is to replace an existing hand pump modifications to the existing hole may be required Use2. OFF Return handle clockwise 1 4 turn SANITIZING Mix into solution Y ounce of common household bleach for every gallon of potable water tank capacity liter 1 ml and then fill the tank completely Operate the pump until the chlorine odor is detected Allow the solution to have a 4 hour contact time and then drain the holding tank Refill the tank and operate pump until the line is flushed clear of solution WINTERIZING CAUTION DO NOT use propylene glycol based anti freeze fluids Never allow water freeze in pump To winterize the pump simply drain the holding tank Operate the pump until all water is flushed from the lines Remove the city water inlet fitting or threaded cap and collect the water that drains out Operate the pump several strokes then reinstall the city water fitting or cap Make sure pump is thawed before using Water Wizard LIMITED WARRANTY SHURflo warrants the Water Wizard hand pump to be free from material and workmanship defects under normal use and service for a period of one 1 year from the date of manufacture or one 1 year of use with proof of purchase In no case will the terms of this limited warranty extend beyond two years from the date of manufacture Warranty claims may be resolved by the nearest authorized dealer service center or by a SHURflo service center All returns are to be shipped with charges pre paid Package all returns carefully SHURflo will not be responsible for freight damag
3. the template to determine if the trim cover will cover an existing hole after modifications In most installations there are limitations on space Use of a hole saw allows the easiest and most precise method to make the cut out 1 Determine the position and check under the counter for adequate space to mount the pump Make certain there is sufficient clearance to rotate the spout when installing Also if mounted in a flip galley check for proper clearance in both positions for the pump and tubing Mark layout lines in line with the center of the drain and 2 5 72 cm from the outer edge of the sink rim The 1 6 35 mm clearance will allow cleaning between the trim cover and the sink rim 2 Cut the template Page 3 out around the edge of trim cover Position the template over the layout lines and hold in place with tape Mark pilot drill the position of the four 19 4 44 cm holes 3 Use a 1 4 44 cm hole saw to cut the four holes Trim out the remaining material to attain the cut out shown on the template bold line The trim cover may not cover the hole if enlarged past the size shown 4 Place the pump in the cut out and square it to the sink Squaring up the pump is easier if the trim cover is placed in position but DO NOT snap it in place Mark the four mounting holes and remove the pump before drilling small pilot holes for 6 hardware If using a power screwdriver pilot holes may not be necessary If installing into an existi
4. xxx de teinturier de l eau potable de SHURflo A Eau d un r servoir Remplir le r servoir d eau Actionner la poign e de haut en bas S assurer que tous les raccords sont tanches B Eau municipale D ARRIVEE 3 8 10mm OUVERTURE Tourner la poign e d de tour dans le sens inverse des aiguilles d une montre FERMETURE Ramener la poign e d de tour dans le sens des aiguilles d une montre NETTOYAGE RESEVOIR M langer 4 ml d eau de javel par litre de capacit POTABLE d eau potable du r servoir oz par gallon puis compl tement o PRE ee ae remplir le r servoir Actionner la pompe jusqu ce qu une odeur Nor PE de chlore soit d tect e Laisser la solution reposer pendant 4 heures puis vidanger le r servoir Remplir nouveau le r servoir et actionner la pompe jusqu a ce que la conduite soit purg e de toute solution chlor e PREPARATION AVANT L HIVER EAU MUNICIPALE REGULEE Avant l hiver vidanger le r servoir Actionner la pompe jusqu ce que les conduites soient totalement vides D monter le raccord d arriv e d eau municipale ou le capuchon viss et r cup rer l eau de vidange Actionner la pompe plusieurs fois puis remonter le raccord d arriv e d eau ou le capuchon Attention N utiliser pas les fluides antigel bas s par glycol de propyline Ne laisser pas la pompe geles avec l int rieur de l eau Fourni en tant que pi ce d tach e uniquement S assurer que la po
5. droit de modifier les caract ristiques ou les prix de ses produits ou d effectuer des substitutions 911 439 Rev G 5 99 Page 4 of 4
6. e incurred during shipping For complete warranty details refer to SHURflo Service Bulletin 1041 5 SHURfIo ISO Certified Facility SHURflo reserves the right to update specifications prices or make substitutions SHURflo x SHURflo East SHURflo Ltd 12650 Westminster Ave 52748 Park Six Court Unit 5 Sterling Park Santa Ana CA 92706 2100 Elkhart IN 46514 5427 Gatwick Road Crawley 800 854 3218 714 554 7709 800 762 8094 219 262 0478 West Sussex RH10 2QT FAX 714 554 4721 FAX 219 264 2169 United Kingdom Shipping UPS 12650 Westminster http www shurflo com 44 1293 424000 Ave 1999 FAX 44 1293 421880 ve Garden Grove CA 92843 911 439 Rev G 5 99 Page 2 of 4 p JO abe o DAPR IAE PETT SS SE e GA IS DES fhe is A PAGE ed y a Y y 2 Fe y 4 va 7 Ro SPOUT INSTALL POSITION A ae G aes V 1 3 4 DIA ARA X 4 44 cm LA 4 PLACES Lx PA 2 1 2 ZA 6 35 cm a REM a Y ERA P a eS va A x A 4 f fa A o 2 1 4 ea 5 72 cm al Y IA 4 3 4 12 06 cm SUGGESTED PA At CLEARANCE s gt 5 Water Wizard ALIGN TAB TO INSERT SPOUT SHURflo Template OUTER RIM OF SINK POMPE A MAIN WATER WIZARD MODELE 150 Manuel d utilisation et d entretien FONCTIONNEMENT ER POIGNEE Nous recommandons qu un tamis de l eau est utilis entre le H a R servoir et la pompe utilisons une maille 55 ou plus fin comme le num ro 170
7. mpe est d gel e avant de s en servir D MONTAGE Avertissement Vidanger toute l eau et d brancher l arriv e Essayez ces autres produiis SHURTIO d eau municipale a ae 2 Filtres eau municipale Waterguard Bec Faire tourner le bec de mani re aligner les rep res Robinets lectriques du bec et du couvercle D monter le bec Pompes eau potable 12 V C le Gli n tournevis dans la fente de la plaque et R servoirs accumulation ouvercle Glisser un tournevis dans la fente de la plaqu Arriv es d eau municipale soulever d licatement les deux c t s Filtres tamis et raccords En Pompe D monter les tuyaux Enlever les 4 vis de fixation de Fompes de transfert g n rales et de vidange d huile la pompe Gamme compl te de pompes marines et accessoires Consultez notre catalogue lectronique sur notre GARANTIE LIMITEE site Internet http www shurflo com SHURflo garantit que la pompe manuelle Water Wizard est exempte de tout d faut de mat riel et de fabrication dans des conditions normales d utilisation et de service pendant une dur e d un 1 an compter de la date de fabrication ou d un 1 an d utilisation sur pr sentation du justificatif d achat En aucun cas les termes de la garantie limit e ne pourront s tendre au del de deux ans compter de la date de fabrication Les d tails complets de la garantie figurent dans le Bulletin de service SHURflo n 1041 SHURflo se r serve le
8. ng hole simply install the supplied screws into the existing holes 5 On the water line between the tank and pump a water strainer is recommend To protect the pump a 50 mesh screen or finer is necessary such as the SHURflo Potable Water Strainer 170 061 XX supplied with after market pump 150 001 00 911 439 Rev G 5 99 Page 1 of 4 6 Connect the tubing from the potable water tank to the inlet fitting The regulated city water line if used is connected with the swivel barb fitting to the threaded port at the bottom of the pump DO NOT OVER TIGHTEN HAND TIGHTEN ONLY Secure the tubing with hose clamps If the city water feature is not being used install the threaded seal cap DO NOT OVER TIGHTEN HAND TIGHTEN ONLY 7 Install the pump back into the hole and fasten in place DO NOT over tighten the screws Doing so can distort the plastic bosses creating difficulty when snapping the trim plate in place 8 Perform a visual inspection of the installation before snapping the trim plate into position To install the spout align marks on spout and trim plate Press spout into the hole and turn to the forward position Test the pump for proper operation and check tubing for leaks Remove and properly discard spout label supplied with after market pump 150 001 00 OPERATION A Water from Tank Fill water tank Pump the piston up and down Make sure all connections are tight B City Water ON Turn handle counterclockwise 1 4 turn
Download Pdf Manuals
Related Search