Samsung SC5128 Инструкция по использованию
Contents
1. TRANSPORTING AND STORING THE VACUUM CLEANER For easy storage and transportation this vacuum cleaner has a Clip system built onto the body which will keep the tube hose and nozzle in a vertical position REPLACING THE DUST BAG 1 To open the dust cover of the dust bag com 2 Remove the dust bag from the cleaner partment press the clamper upwards The clamper is located at the front of the dust cover 3 After removing the used dust bag insert the 4 Press the dust cover down gently until the cardboard bag collar of the new dust bag into clamper relocks its original position FOR CLOTH FILTER BAG After using if the cloth filter bag is full of dust clean the cloth filter bag and use it again MAINTENANCE OR REPLACEMENT OF THE FILTERS gt INLET FILTER To protect the motor your cleaner features a secondary filter at the front of the motor in the dust compartment Do not allow the filter to become clogged Suction power reduction or motor damage may result After cleaning the secondary filter attach it in place Ly SECONDARY FILTER SECONDARY FILTER gt OUTLET FILTER 1 Open the grille part separate the 2 Reassemble it after cleaning or replacing the filter in the reverse order o Jore The filters must be completely dried before being replaced in the dust compartment 6 exhausted filter2. USAGE OF FLOOR NOZZLE FOR RUG FLOOR SELECTOR Before use make sure that the position of the selector is in the right position for the type of surface to be cleaned Select the carpet indicator when cleaning carpets Select flat surface indicator when cleaning the floors tiles etc FOR UNIVERSAL BRUSH Use the floor nozzle for cleaning all surfaces Jior For optimum efficiency clean floor brush with crevice tool TROUBLE SHOOTING PROBLEM Motor does not start CAUSE No power supply REMEDY Check cable plug and socket Suction force is gradually decreasing Filter nozzle suction hose or tube is blocked Remove the object Cord does not rewind fully Check that the cord is not twisted or wound unevenly Pull the cord out 2 3m amp push down the cord rewind button This Vacuum cleaner is approved the following EMC Directive 89 336 EEC 92 31EEC and 93 68 EEC Low Voltage Safety Directive 73 23 EEC and 93 68 EEC If you have any comments or questions regarding a Samsung products contact the SAMSUNG customer care center Country Customer Care Center T Web Site U K 0870 242 0303 www samsung com uk SOUTH AFRICA 0860 7267864 SAMSUNG www samsung com za DJ68 00094E REV 0 2
3. Operating Instructions ss Be VACUUM CLEANER Sm Before operating this unit please read the instructions carefully Register your product at www samsung com global register Features include automatic cord rewind and dust indicator Jore Not all models have the same features IMPORTANT SAFEGUARDS 1 Read all instructions carefully Before switching on make sure that the voltage of your electricity supply is the same as that indicated on the rating plate on the bottom of the cleaner 2 WARNING Do not use the vacuum cleaner when rug or floor is wet 3 Close supervision is necessary when any appliance is used by or near children Do not allow the vacuum cleaner to be used as a toy Do not allow the vacuum cleaner to run unattended at any time Use the vacuum cleaner only for its intended use as described in these instructions 4 Do not use the vacuum cleaner without a dust bag Change the dust bag before itis full in order to maintain best efficiency 5 Do not use the vacuum cleaner to pick up matches live ashes or cigarette butts Keep the vacuum cleaner away from stoves and other heat sources Heat can deform and discolour the plastic parts of the unit 6 Avoid picking up hard sharp objects with the vacuum cleaner as they may damage the cleaner parts Do not stand on the hose assembly Do not put a weight on the hose Do not block the suction or the exhaustion part 7 Switch the vacuum cleaner off at
4. the machine before unplugging from the electrical outlet Grasp the plug to disconnect from power outlet to avoid damage to cord plug prongs or socket Do not pull the power cord Always disconnect cord from electrical outlet before changing the dust bag 8 The use of an extension cord is not recommended 9 If your vacuum cleaner is not operating correctly switch off the power supply and consult an authorized service agent 10 If the supply cord is damaged it must be replaced by the manufacturer or its service agent or a simi larly qualified person in order to avoid a hazard Ts PN TIFICATIONS OF PARTS HANDLE SUCTION HOSE AIR REGULATOR CORD REWIND BUTTON DUST FULL INDICATOR POWER CONTROL SWITCH amp ON OFF SWITCH CARRYING HANDLE TUBE BUTTON FOR SUCTION HOSE REMOVAL CLAMPER FOR DUST BAG COMPARTMENT WL ee 7 Neen BELT STRAP ASSY CREVICE TOOL So HANGER ACCESSORY DUSTING BRUSH gt Features marked may vary according to model ASSEMBLING THE VACUUM CLEANER READY FOR USE 1 Connect the suction hose to the suction tube 2 Connect the suction tubes together depending on model Loe 4 Grip the body connector with one hand and squeeze the tube in an inward direction JSPTION EXTENDING Holding the narrow part of the telescopic tube with one hand pull the handle in the opposite direction with your ot
5. and check whether the hose tube or nozzle is clogged USING THE ACCESSORIES CREVICE DUSTING Crevice tool for radiators crevices Dusting brush for furniture e Before use assemble the dusting corners between cushions shelves books etc brush to the crevice tool TOOL STORAGE Your cleaner features a tool storage device Assemble the accessory hanger on to the extension tube It can be used to store the cleaning tools while they are not in use This tool can be separated into two parts Bs Zl USING amp ASSEMBLING THE STRAP OPTIONAL This appliance is designed to be conveniently carried on your waist using the belt strap accessory When cleaning steps curtains shelves etc you can carry the unit with the strap over your shoulder gt Ready for use 1 Insert the lockers into the holes on the cleaner taking care of the lockers direction Strap ends should face the body of the cleaner 2 Pull the lockers to the front of the cleaner until they click into place 3 Adjust the strap length to fit your body gt When not using the strap Detach the lockers by pushing them down and drawing them out from the unit Keep the strap separately for the next time you want to use it PARK POSITION Located on the top rear side of the vacuum cleaner there is a nozzle support that can be used to park the nozzle during pauses in cleaning Locker
6. her hand SHORTENING Holding the narrow part of the telescopic tube with one hand push the handle towards it using the other hand Adjustable telescopic tube not available with all models A POWER CORD 1 PULLING OUT The power cord is long enough to be drawn out for convenience 2 REWINDING When you have finished cleaning disconnect the plug from the electrical outlet and simply press the cord rewind button lightly with your toe Jore When removing the power cord from the electrical outlet grasp the plug not the cord ON OFF SWITCH With the cord plugged into an electrical outlet start or stop the vacuum cleaner by pushing lightly downward on the switch OTE ON OFF switch is combined with POWER CON TROLLER To start or stop the unit just lightly press it downward POWER CONTROL VARIABLE CONTROL TYPE ONLY The vacuuming power can be adjusted to suit any situa tion with the electrical power control H MIN For delicate fabrics e g net curtains MAX For hard floors and heavily soiled carpets To adjust power output just turn it right or left es UST FULL INDICATOR If the Dust Full indicator changes to RED while you are cleaning the dust bag requires replacement Jhore If the Dust Full indicator continues to display RED even after changing the dust bag turn the cleaner off
Download Pdf Manuals
Related Search