LR Digital Remote Control System User Guide
Contents
1. 42. Flash Output Press Flash controller blue triangles to adjust flash output up or down press flash controller center to rotate through maximum minimum and last power setting used This can also be used to select an F stop IF the aperture control system has been set up page 3 Adjust Modeling Light Output Press Modeling Light controller red triangles to adjust model light output up or down Press modeling Light controller center to rotate V through maximum minimum last power setting used and OFF Turn Cell ON OFF Press the CELL button to turn photo cell on or off When Cell is turned on the CEL display on the default screen is filled in with grey Turn Sound ON OFF Press the SOUND button to turn audible alert on or off this will indicate that the flash is ready to fire again When Cell is turned on the SND display on the default screen is filled in with grey Set Proportional Lighting Press the PROP button to turn proportional lighting on press and hold to turn on Continuous lighting When PROP is turned on the PRO display on the default screen is filled in with grey When Continuous is turned on the CON display on the default screen is filled in with grey Test Fire Flash Press the TEST button to trigger flash Turn Flash Off Press the STROBE OFF button to turn flash off Note You can turn strobe on again using this button as long as the strobe power button is in the ON position Lightrein
3. LR Digital Remote Control System User Guide Table of Contents Install LR Digital Remote Control System Set Up Group Id for each Flash Page 3 Remote Control Operation Page 3 4 LR Digital Remote Control System User Guide June 01 2010 Install LR Digital Digital Remote Control System The 2 4 GHZ LR Digital Remote Control System is made up of 3 components sold separately or as a kit a receiver a transmitter and a hand held remote controller 1 Remove plastic cover from receiver socket located at top of flash control panel and insert receiver with antennae attached ensuring it is properly seated a The receiver draws its power from the flash 2 Insert battery into transmitter a It comes with one 3V battery CR123A UI 3 Mount transmitter with antennae attached onto the hotshoe of your camera a Locate the power switch on the back side of the transmitter b Turn power switch to left ON position 4 Use the M button on the top of the transmitter to identify which GROUP of flashes you wish to trigger A B C D or E See next page for instructions on setting up a GROUP ID on each flash a T Test Fire Flash 5 Press camera shutter to activate transmitter and fire the flash Lightrein 2 LR Digital Remote Control System User Guide June 01 2010 Set Up Group and ID on each Flash You need to set up a Group and ID for on each flash when you want to control that flash fro
4. m the hand held remote controller This set up is done on the flash itself There are five GROUP SETTINGS A B C D E each of these can have 10 flashes assigned to them ID SETTINGS 1 to 10 To set the GROUP and ID on each flash you will use the e XB button e LCD display and e both flash and modeling light dials 1 Press the XB button for approximately 3 seconds a The LCD screen will display the GROUP ID SETTING screen opposite b The GROUP ID SETTING screen will revert back to the default screen if you do not activate steps 2 and 3 below 2 Rotate the Flash dial to set the GROUP SETTING A B C D E GROUP ID Displayed here 3 Rotate the Modeling Light dial to set the ID SETTING 1 to 10 a After setting GROUP and ID the screen will revert back to default screen after several seconds Remote Control Operation You can fire and control the functions of each flash up to 50 with the hand held remote control 1 Press the POWER button to turn the remote control ON it will power OFF on its own after approx 1 minute 2 Press SCAN to identify flashes connected to the remote controller 3 Use alphanumeric pad to select a flash GROUP A to E and ID 1 to 10 4 Press the REM button the default screen will display on the remote control Functions of the controller are explained in chart next page Lightrein 3 LR Digital Remote Control System User Guide June 01 2010 Adjust
Download Pdf Manuals
Related Search