SDK-9603 USER GUIDE
Contents
1. nsceiver The 9603 Active and ON OFF indicators will both turn on when power supply is available to the transceiver and the toggle switch is set to the ON position Iridium Antenna U FL to SMA Antenna Cable Banana Jack IRIDIUM SATELLITE LLC 5809603 1 HE ar SERIAL EE ER HEN sd ER EE Fig 2 SDK 9603 Peripherals Serial Data Port This is the communication interface between the 9603 transceiver and a Data Terminal Equipment DTE such as a PC A logic level convertor chip is provided on the test interface board to facilitate communication between an RS232 interface DTE and the 9603 transceiver which has a 3 3V CMOS interface The serial data port supports 9 wire RS232 communication between the transceiver and the DTE using a straight through standard 9 pin D type cable such as one supplied with the SDK9603 kit This port supports the AT command interface to the 9603 transceiver The factory default setting of a 9603 transceiver is 8 bits 1 stop bit no parity and no handshake at a baud rate of 19200 bps www satelligent ca 2 v1 1 Y SATELLIGENT TELEMETRY SOLUTIONS SDK 9603 User Guide Network Availability A visual indication of Iridium satellite visibility is available on the test interface board by means of the NW Available LED Revision History Version Date Comments gt 14 Jan 2013 Initial Release 15 Aug 2014 Formatting updates www satelligent ca 3 v1 12. www Satelligent ca Y SATELLIGENT SDK 9603 USER GUIDE O SATELLIGENT SDK 9603 User Guide TELEMETRY SOLUTIONS Introduction The steps involved in using the SDK 9603 for testing the Iridium 9603 transceiver are described below Powering up the SDK9603 There are two ways of supplying DC power to the SDK9603 1 Use the red and black banana jacks to provide 6 15 VDC Short pins 1 and 2 of jumper J2 to select this option 2 Use the DC power jack to provide regulated DC supply from a wall adaptor in the range of 6 15 VDC Short pins 2 and 3 of jumper J2 to select this option The 9603 Power LED lights up to indicate when power is available on the board The jumper location is as shown inside the red box in Fig 1 5V Supply Jumper An on board jumper J4 allows 5V supply to be connected or disconnected to the 9603 transceiver This allows the user to monitor the current draw of the transceiver at its supply voltage of 5V The jumper location is as shown inside the yellow box in Fig 1 RS j 1 U i a ay u ol oi 9 x AVAILABLE 9603 POWER o AJ gt oO Lei Fig 1 Jumper Location www Satelligent ca OQ SATELLIGENT TELEMETRY SOLUTIONS SDK 9603 User Guide ON OFF Switch The 9603 transceiver can be turned ON OFF using toggle switch SW1 even when DC supply is available to the transceiver This is only a digital control to the transceiver and does not shut off power to the tra
Download Pdf Manuals
Related Search