User's Guide LRD8200 Label Sensor Lion Precision
Contents
1. Running lights may be active while running labels If more then the three Running lights are active use adjustments to center the display a ae ea For best performance web must remain in contact with the base plate Light Dark Switching Light Dark switching mode see Fig 3 is displayed by the Light Dark Indicators see fig 2 To change between light and dark switching hold the Light Dark Select 1S button for 1 second Sensing Area Indicator NINNNY dn1aS dY9 a 25 on oF a Fig 1 GAP SETUP LIGHT On when gap is LIGHT BAR amp sai Triple Check Verification lt ADJUST ACKNOWLEDGE Running Lights Light flashes green with While running these three every ADJUST key press lights or more are active on or flashing when properly adjusted Flashes red when adjustment is at maximum UP ADJUST LIGHT DARK INDICATORS Shifts light bar up ee Hold down for rapid adjustment Light Switching Dark Switching DOWN ADJUST Shifts light bar down LIGHT DARK SELECT Hold down for rapid adjustment OUTPUT INDICATOR Light is on when outputs are on conducting Changes between light dark switching Must be held for one second to change2. 0 mA max es ae site 2 White NPN Output 150 mA max 150 mA max 3 Blue Ground Connected to Dao a but sensor body PNP Load l 4 Black PNP Output 150 mA max Gro nd Shield Ground Sensor Case Any other wires in the cable if using 5 wire are x 1 not connected in the sensor and can be ignored M12 connector on rear of sensor 3 a Specifications Voltage 12 24 V reverse polarity protected Power supply Current 50 mA On or Off 125 425 us max Response time Switching Frequency 1 kHz max 250 m min for 2mm gaps Output Current sinking or sourcing 150 mA max overload protected Pat PNP sourcing or NPN sinking Output ohg oupi Dark or light switching 60 m min 0 15 mm 0 006 Registration Accuracy 250 m min 0 60 mm 0 024 Temperature Operating Range 40 F to 140 F 4 C to 60 C Supply Inverse Polarity Protection Protections Switching output Short Circuit and Overload Protection Sensor Setup Labels must pass under the Sensing Area indicator see fig 1 Place a gap in the sensor or remove a label and place the liner only in the sensor Use Adjust buttons to light the Gap Setup light on the light bar see fig 1 2 Run labels through the sensor and verify that the three Running lights see fig 1 2 are active on or flashing while labels are passing through the sensor If not use Adjust buttons until they are More lights than the three
3. Output lt lt Output Indicator Tl Dark swiching utput Indicator lt Outputs vy Light Swtening Kr Q lt Output Indicator f1 ai __ lt Outputs t 0 125 3 18 Two Year Warranty details at www lionprecision com warranty html User s Guide for the LRD8200 Label Sensor from Lion Precision Lion Precision 563 Shoreview Park Road St Paul MN 55126 651 484 6544 www lionprecision com Document Number M016 6100 004 Description The Lion Precision LRD8200 Label Sensor uses ultrasonic technology to monitor label registration and or count labels A change in the sensor output indicates the presence of a label edge Connecting to the Sensor Warnings Sensors must not be attached to voltages in excess of 30 VRMS or 60 VDC All external connections must be SELV Safety Extra Low Voltage A shielded cable is required for full protection and safety compliance All power must be off when installing the sensor Use of the equipment in any other manner may impair the safety and EMI protections of the equipment If outputs are overloaded all indicators on the sensor will flash together and sensor will stop operating Normal operation will be restored when the overload is removed Wire Connection Notes 1 Brown 224 Color s 1 Brown Vin 12 24 V 5
Download Pdf Manuals
Related Search