Hi-Copy DMX- 8711E User's Guide Revision 2.0
Contents
1. DVD RW medium must be Erased first before using DVD RW Pioneer DVD RW Ricoh drives all support CD R CD RW writings If source medium is a DVD then the des tination must also be a blank DVD medium If source medium is a CD then the destination must be a blank CD R or CD RW 2 Before You Start Please make sure your source CD DVD is clean and does not 7 KSA 7 7 7 Ww e Me om have any scratch on its surface Configure DVD RW drive as master device and DVD ROM as slave device Set jumpers on them to correct positions om 1 DMX 8711E Installation Guide 3 Easy Setup Open the case 1 Release the screw on the back plane 2 Remove top cover by sliding it toward backplane 1 2 cm then pulling itup Remove the front door Secure DVD ROM and DVD RW drives with attached screws and accessories DMX 8711E Installation Guide 1 Install DMX 8711E controller seat it properly on to the case 2 Configure DVD RW as master device and DVD ROM as slave device Set jumpers on both devices to correct positions 3 Connect IDE cable to DMX 8711E controller board DVD ROM DVD RW drives Note Pin 1 of IDE cable can be identified by red color 4 Attach power connectors to all devices and finally slide DVD de vices into the case carefully DVD ROM Slave DVD RW Master Replace and fasten the front panel Put top cover onto top of the case with a gap o2. DMX 8711E Installation Guide Hi Copy DMX 8711E User s Guide Revision 2 0 FOR HOME OR OFFICE USE C Tested To Comply With FCC Standards DMX 8711E Installation Guide This device complies with Part 15 of the FCC Rules Operation is sub ject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received includ ing interference that may cause undesired operation Federal Communications Commission FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a resi dential installation This equipment generates uses and can radiate radio fre quency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equip ment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and the receiver o Connect the equipment to an outlet on a circui
3. date firmware Mode Operation Error Message Put update CD R into DVD ROM One long beep sounds Press Mode and Run keys red LED lights together then release them Finish update all LED s will be turned off Please turn off the power then power on again 8 Specifications Humidi 20 80 Operating temperature 5 C 35 C Connector IDE Regulation FCC CE 9 Technical Support Welcome to our web site http www domex com tw E mail address tec domex com tw
4. f 1 2 cm to the front panel then push and slide it 1n DMX 8711E Installation Guide 4 Front Panel Hi Copy Sees Ss There are three push buttons and three LED s on the front panel Their functions are Mode This key has to work with Run and Speed keys to enter special function modes Mode Run Upgrade controller firmware Mode Speed Erase CD RW or DVD RW content Press and halt Mode key then press Run or Speed key Release Run or Speed key and finally release Mode key Speed The CD R writing will perform a speed test first It will try the maximum speed 4x speeds and finally 1x speeds Once a speed test passes it will use that speed to perform the duplication DVD writing always uses constant speed Run This is the default setting of using the maximun speed to duplicate CD DVD 5 Update Firmware There are many new models and faster speed DVD RW coming to the market everyday In order to provide the best service DMX 8711E allows user to upgrade firmware privately User can download new firmware from http www domex com tw then use a PC with CD RW drive to write it on a CD R put this CD R into DVD ROM drive of DMX 8711E and press Mode and Run keys together to upgrade the firmware During the process please do not turn off power of DMX 8711E otherwise damage might happen 6 Opera
5. t different from that to which the receiver is connected o Consult the dealer or an experienced radio TV technician for help Warning To meet FCC requirements a shielded power cord is required in order to prevent interference It is essential that only the supplied power cord is to be used Use only shielded cables to connect I O devices to this equipment You are cautioned that changes or modifications not approved by the party respon sible for compliance could void your authority to operate the equipment DMX 8711E Installation Guide Welcome to the DMX 8711E User s Guide Thank you for your purchasing of DMX 8711E CD DVD duplicator controller DMX 8711E features very easy operation with three LED s on front panel to inform you the operating result DMX 8711E uses IDE interface one DVD ROM and one DVD RW drive are needed for proper operation 1 Features Fully stand alone CD DVD duplicator device Auto format detection It supports CD R CD RW DVD R DVD RW DVD RW writings When select DVD RW drive Pioneer as writer please use DVD R or DVD RW medium When se lect DVD RW drive Ricoh as writer please use DVD RW medium Normal backup takes 50 minutes 7 KSA IDE bus interface Only for normal backup purpose Protected CD DVD backup is not supported If source DVD has a particular area code inside please pur chase DVD ROM for that area to read Firmware upgradeable by a DVD ROM drive A blank
6. tion for quick duplication DMX 8711E Installation Guide 5 1 Power on and wait for 4 5 seconds to warm up 5 2 Open doors of both DVD ROM and DVD RW drives 5 3 Put source CD DVD into DVD ROM drive 5 4 Put blank CD DVD into DVD RW drive 5 5 Close doors of both drives 5 6 If source CD DVD is in good condition just press Run key to perform the maximun speed duplication Press Speed key will get into secure writing In this mode CD R writing will select speed from the maximum speed 4x speeds then going down to 1x speeds If a speed meets the requirement it will use that speed to perform the writing DVD writing always uses constant speed 7 Operation Step by Step Warming up Operation Error Message Green orange and red LED s flash 5 seconds One short beep sounds green LED lights One long beep sounds red LED lights Copy Mode Operation Error Message Open doors of DVD ROM and DVD RW drives Put source CD DVD into DVD ROM then put blank CD DVD into DVD RW drive Close doors of both drives Press Run key to have default copy or press Speed key to have secure copy One long beep sounds red LED lights During copy LED on panels of DVD ROM and DVD RW flash Yellow LED lights If OK one short beep sounds and ejects target CD DVD Yellow LED off DMX 8711E Installation Guide Up
Download Pdf Manuals
Related Search