S-46WM Backplane User's Manual - ELS
Contents
1. FLED Fan failure detection FLEDG Fan failure detection green RESET Reset Switch for buzzer alarm and Overheating LED TLEDR Temperature detection red 5V 5V Power TLEDG Temperature detection green GND Grounded LED Switch a When LED switch is set to enable position LED indicates Green when powered on and Orange color blinking for HDD accessing In this case the HDD does not spin up until the SATA initial signal is received b When LED switch is set to disable position LED always indicates SOLID GREEN both for HDD being powered on and HDD being accessing In this case the hard drive is spinning up when the system power is turned on2. S 46WM Backplane User s Manual Features of product Aluminum frame aluminum tray and plastic bezel Interface Support SATA I Il Ill amp SAS I Il Compatible to use with 3 5 or 2 5 SATA SAS HDD High performance transfer rate Max up to 6Gbps for SAS II amp SATA III Plug amp play hot swappable for 4 x 3 5 HDD or 4 x 2 5 HDD SATA 15Pin amp 4Pin Power connectors LED for P S HDD access Fan sensor amp Buzzer LED On Off setting switch Power Control Switch for each HDD 3 stage temperature alarm settings amp reset switch for buzzer alarm 8cm cooling fan x 1 and High Low stage adjustable fan speed Patent handle design with mechanical lock and advanced structure design Color for choice black or beige Patent balance handle No skew in out problem amp avoid the abrasion during connection Precisely connection on connector see picture A Dim 202 L X 146 W X 126 H mm Weight 1 7 Kgs D eee q S _ es Picture A Picture C Caddy Drive Drawer Install 1 Use TM 6 4 for 3 5 HDD amp IM3 3 5 for 2 5 HDD screws to mount the drive on the drawer see picture C 2 With anti shock stainless side springs on both side to reduce vibration C1 Front Panel see picture D E D 7 Picture D OPEN Picture E Rear View
3. see picture F IR OO LEDR T 9 Vr g gt O O LEDG e O GND IJP 3 IJP 1 LED Switch HDD 1 HOD 2 HDD 3 Ja 7 HOO 4 HIGH LOW Picture F D 1 Reset Switch for buzzer alarm and over heating LED When overheating occurs default setting is 60 C the buzzer alarms and the temperature LED turns red meanwhile buzzer is alarming and LED is blinking Press the Reset Switch to stop the alarm and LED goes off D2 D 5 HD1 HD4 Power SW and LED Power on LED indicates Green Orange color is blinking while HDD is in accessing D 6 Fan sensor LED LED is indicating Green when powered on When fan failed LED turns Red D7 Carrier Safety Lock The safety lock safeguards the hard disk in the correct position and prevents it bouncing out while HDD is working See Picture E Rear View Description Picture F POWERT1 4pin Power connector POWER2 15pin Serial ATA Power connector Two types power for connection 4pin power amp 15pin SATA power Use the 4pin power connector or the 15pin power connector Note Can mix using 4pin and 15pin powers Suggestion At least 2 power and 3 is better HD1 HD4 7pin Serial ATA Signal connector IJP1 Temperature setting jumper default is 60 C IJP3 Extension function jumpers FLEDR Fan failure detection red
Download Pdf Manuals
Related Search