OPERATING INSTRUCTIONS FOR THE T24
Contents
1. DELPHI FORCE Measurement Pty Ltd ABN 19 088 011 152 64 Township Drive West Burleigh Qld 4219 Australia PO Box 317 Coolangatta Qld 4225 Australia Website www delphiforce com au Phone 07 5508 2498 Email admin delphiforce com au Fax 07 5508 2650 OPERATING INSTRUCTIONS FOR THE T24 HS DISPLAY Press and hold the power key until the display shows BUSY then release the key Can also be used by giving a quick press to reset the Auto Sleep delay Press the TARE key This will toggle between gross and zeroed net mode l e If the display shows gross then pressing the key will zero the display Pressing the key when in net mode will return the display to gross mode The Gross and Net modes are indicated as described below Gross and Net are retained through power off G The display is showing Gross weight NET The display is showing Net weight gue The radio signal from the acquisition module is low The device is still functioning but aud the limit of the range may be near Communications may start to deteriorate when this indicator is visible Until is displayed the communications is still OK and the display can be relied on for accuracy Note Even with a degraded signal the display value will always be correct BATT Low The batteries in the handheld are low and need to be replaced REMOTE ERROR The tension cell transmitter module has an error that the handheld display does not recognise REMOTE BATT2. LOW The battery or supply to the tension cell transmitter module is low Errors displayed on handheld LCD Error 1 The tension cell transmitter module has a strain gauge input and is in shunt cal mode An external device has placed the tension cell transmitter module in shunt calibration mode so rather than display a misleading reading this error is displayed instead Error 2 Input integrity error The acquisition module has found a problem with the input There may be open or short circuits Rather than display a misleading reading this error is displayed instead Overload A user settable value which when exceeded causes this message to be displayed Power Switch OFF ON OFF Antenna Connector 2 4GHz TNC RP Load Cell Battery Charger Connection Note NiMH Batteries Only use specified charger Status indicato rs J Frequency 2 4GHz Supply I3Veeo 2 X AA Batteries Consi RADZ lt Rado Modde FOC IDNHARAOZ4 IC TZMA RADI4 CE Power ON OFF Tare button Battery case 2 x AA
Download Pdf Manuals
Related Search