Alkaline Battery Pack for AirChek XR5000 Sample Pumps Operating
Contents
1. For safe operation in hazardous locations ensure the pump label contains the p logo and the battery pack label contains Cat No P85004 or P85002 Use of any other battery pack including alkaline or device to power the pump voids the UL Listing for intrinsic safety Failure to follow warnings and cautions voids any warranty Alkaline Battery Pack for AirChek XR5000 Sample Pumps To retain display data ensure pump is placed in Hold before disconnecting the battery pack Display data will not be retained if battery is removed while pump is running Operating Instructions 863 Valley View Road Eighty Four PA 15330 USA Tel 724 941 9701 Fax 724 941 1369 e mail skctech skcinc com www skcinc com Notice This operating instruction may not address all safety concerns if any associated with this product and its use The user is responsible for determining and following the appropriate safety and health practices and regulatory limitations if any before using the product The information contained in this document should not be construed as legal advice opinion or as a nal authority on legal or regulatory procedures Form 37733 Rev 1001 5 Orient battery holder properly with battery pack housing black and red wires and battery terminal toward front of housing with SKC logo To avoid breakage orient battery holder properly and do not force the battery holder into the battery pack housing Resetting Pump to Manufac2. turer Settings If the pump does not operate as expected perform the following procedure 1 Remove the battery pack see Removing Existing Battery Pack 2 On the pump keypad press and hold the key and the key simultaneously while attaching the pump to the new battery pack The LCD should display the software version number 525X Do not release hold on the two keys until the pump is rmly attached to the battery pack 3 Release the and keys 4 Press the key 2 times The LCD should read 0 If it does not separate battery pack from pump and repeat Steps 1 through 4 until successful 5 Replace and tighten two screws on the bottom of the battery pack housing 5 5 Front of housing with SKC logo Removing Existing Battery Pack 1 Remove two screws on bottom of battery pack housing 2 Pull battery pack housing away from pump case 3 Holding battery pack housing tightly in one hand place a nger from the other hand through the loop on top of the battery pack Pull upward rmly to remove the battery holder from the housing Installing New Batteries 4 If replacing existing batteries rst remove batteries from holder Place new batteries into the holder in the following polarity arrangement 1 3 4 Polarity is marked inside the batt ery holder Front layer Back layer
Download Pdf Manuals
Related Search