OPERATING INSTRUCTIONS
Contents
1. short circuiting Both components must be installed close together in the same room 2 Connect the solar panel to the corresponding terminals on the solar charger Two LED s display the operating status LED red Sufficient charging voltage from the generator charger is charging LED green charger is full final charging voltage reached sufficient charging voltage If no LED lights up generator is not supplying sufficient charging voltage or charging voltage is less than charger voltage charger is full Specifications Nominal voltage 12 24V Charging current solar cells 4A max Load 4A max Power use 1 5 mA Final charging voltage 13 8 V Temperature range 10 C up to 50 C Measurements 68 x 57 x 28 mm Weight 150g Delivered Solar Battery Charger Unit with operating instructions Subject to technical alternation No responsibility will be taken for printing mistakes 08 2002 IVT Innovative Versorgungs Technik GmbH Dienhof 14 D 92242 Hirschau Phone 49 9622 71221 Fax 49 9622 71220 www lVT Hirschau de Info IVT Hirschau de2. OPERATING INSTRUCTIONS SOLAR BATTERY CHARGER UNIT 12V4A CE Dear Customer Thanks you for buying our product You have bought one of the most powerful compact and reliable units of its class Please read the operating instructions carefully before use WARNING Safety Instructions Do not use the unit In places which are dusty damp In a high humidity area over 80 rel humidity Temperatures above 50 C In areas containing inflammable materials liquids solvents gas Do not immerse in water Use only in closed and dry areas Should the unit fail to operate or show signs of not operating properly unplug immediately and make sure that the unit is not put into further operation Do not use the unit when visible signs of damage due to transport or inadequate storage are noticeable To prevent the risk of explosion by overcharging install the battery in a well ventilated place Use only solar panels as power source To prevent a short circuit between Solar charger unit and battery install a fuse on the positive terminal pole FUNCTION DESCRIPTION OF OPERATION The use of lead batteries is common for the storage of solar energy photovoltaik solar systems Lead batteries require protection against overcharging The solar charging regulator fulfils this function Protection against overcharge The battery is not fully charged when the final charging voltage is reached The charging current should not be c
3. ompletely switched off instead reduced so that the final charging voltage is not exceeded This is accomplished by the solar charger unit Connection and Operating elements Terminal Pole lead battery Terminal Pole solar panel LED red lead battery is charged LED green lead battery fully charged SOLAR Laderegler 4A ON Akku voll Batterie Modul ig Installation Warning Take care that the Terminals Pols correspond The solar charger unit should be placed proximity to the battery and be sufficiently protected against the weather Take care to place the battery in a well ventilated place To guarantee that the unit functions properly it must be connected to the solar generator the lead battery and the load Each part of the system solar generator lead battery load and solar charger unit should have the corresponding power supply Please check each component before installation when in doubt contact a Specialist Take careful attention of the following installation instructions 1 Connect the battery to the corresponding terminals on the solar charger unit To prevent the wiring from overheating and power supply reduction the use of cable wire 2 5 mm flexible is recommended Only when a short circuit protection connection is installed can the battery be operated without a fuse Otherwise must a fuse be connected to the battery terminal pole in order to prevent the connection to the solar charger unit from
Download Pdf Manuals
Related Search