mikroBootloader User's
Contents
1. Connect with MCU Connect Msg Waiting MCU response Connected Choose Browse HEX file for HEX Start Begin bootloader uploading Show Activity ready for further instructions http www ftdichip com Drivers VCP htm 3 Choose HEX file mikroBootloader manual 4 Start Bootloader mikroBootloader manual 5 Reset chip mikroBootloader manual LJ mikroXMEGA and XMEGA Ready Bootloader gt mikroXMEGA and XMEGA Ready Bootloader mikroBootioa der mikroBootioader AVR XMEGA aang oat Sad as coe 1 Setup COM Port COM1 Change eran Disconnect port Baud Rate 115200 Settings When the uploading process has been completed reset the chip to start your new program Load the program you want to upload into the chip by clicking on the Browse for HEX button or simply Connect Connect Choose Browse drag and drop a Msg Waiting MCU response your HEX on to Choose Browse Connected HEX file for HEX mikroBootloader Opened C Users mmatovic MIK Desktop Start Stop mikroBootloader final led hex bootloader uploading j Start Begin window You Il bootloader uploading be notified in the History Window Show Activity lai St y clicking on the Begin uploading button a gt atin The whole process is performed in two phases Click on the Mikroktlektronika Show Activity button to view the operation of the bootloader DEVELOPMENT TOCE oll San Bel i S Y lt oDi s y lt OD for more i2. 1 Setup port mikroBootloader manual 2 Connect with MCU mikroBootloader manual mikroBootloader for XMEGA Ready and mikroXMEGA boards This is a short manual that describes the operation of mikroBootloader application You will find that five simple steps are all it takes to successfully load your new program into the MCU Click on the lt J mikroXMEGA and XMEGA Ready Bootloader lt J mikroXMEGA and XMEGA Ready Bootloader Change Settings button and select mikroBootioader mikroBootioater the appropriate Setup COM Port COM1 Change gt Setup COM Port COM1 Change You should know this before you start 1 mikroBootloader may be used with XMEGA Ready and mikroXMEGA boards only Bootloader is specially adjusted for ATxmega128A1 chip 2 In order to enable the proper operation of the on board FTDI chip it is necessary to install the appropriate driver for the operating system you use Drivers may be downloaded at port Baud Rate 115200 Settings i port Baud Rate 115200 Settings COM port in the _ iv Setup window Connect Other parameters are set by default aie and should not be changed Click OK to proceed Start bootloader Connect Browse for HEX Settings Port Begin uploading Baud rate Data bits Stop bits Parity Flow control Software Reset the board and click on the Connect button within 5s The chip automatically enters the Bootloader mode and is
3. nformation visit http www mikroe com
Download Pdf Manuals
Related Search