AQUA COULEUR – USER GUIDE
Contents
1. 1522214 AQUA COULEUR USER GUIDE Please read these instructions carefully and please do not hesitate to contact us if you have any questions or queries Aqua Couleur is a temporary water colourant it does not affect the balance transparency or quality of your pool water It is totally hypoallergenic and will not cause ill heath if accidentally swallowed in its diluted form This product has been vigorously tested in collaboration with the pharmaceutical department of the French National Research Centre Preparation of pool for colouring This is vital for a successful party Before using Aqua Couleur it is vital to reduce your chlorine bromine levels to below 1ppm this level must be consistent throughout the whole of the pool circulation system 1 Calculate your pool turnaround 2 Turn off your chlorination system or make controller set point below 1ppm 3 It is recommended to add the necessary amount of Premio to speed the reduction of chlorine bromine leave for at least two hours to allow to work especially in strainers before the filters as these can contain a lot of chlorinamines We would also suggest putting it in areas of the pool where circulation may be poor 4 Allow for complete pool turnover time to expire and ensure that the control system is measuring below 1ppm and THAT ALL WATER in the pool system is measuring below 1ppm If any pockets of water have a residual over gt 1ppm then colour will quickly dis2. ith the help of a testing kit check the chlorine bromine level is less than 1 before using AQUAcouleur AQUA Premio is a product specially designed to help decrease your chlorine bromine level quickly and efficiently and therefore prepares your pool for a colouring Please use in areas of poor circulation or where a high chlorine level is expected eg the filters Our colour is fading The colour is designed to gently fade away however it could be due to there being chlorine in the circulation possibly in the filters Please check that your injection set point is below 1ppm and that the chlorine injection is deactivated Please check that your whole pool is below 1ppm and you have an adequate amount of colour for your pool ALWAYS READ THE MANUFACTURES INSTRUCTIONS
3. sipate ALWAYS READ THE MANUFACTURES INSTRUCTIONS Colouring your pool To colour your pool add the relevant quantity of aqua couleur through a skimmer whilst leaving the filtration system running colour should spread quickly turning your Chemical injection points off for the duration of the party will also help the colour to last as if your chlorine level falls below the set point they will automatically inject chlorine It is important to colour your pool with the correct amount of product below is a table to guide you however please note that there are variations in treatment depending on the colour used due to pigmentation differences Please use this table as a guide only Cubic Meters Product Volume 0 75 m3 15ml 1 5m3 30ml 50 70 m3 180ml 150 170m3 528ml 250 270m3 859ml 350 370m3 1188ml 450 470m3 1518ml 550 570m3 1848ml Removing the colour in your pool Colour will fade with time however to speed up the removal just restart your chlorination system and colour will quickly dissipate returning your pool to its original state Troubleshooting poured the bottle into the pool and the colour was really nice but it only lasted 10 minutes The most likely cause is that the level of chlorine in your pool was too high Have you checked and confirmed a chlorine level less than 1ppm We recommend that you lower your chorine bromine level for future uses and to neutralise using Premio Also w
Download Pdf Manuals
Related Search