Sealant Applicator User Guide PLEASE READ INSTRUCTIONS
Contents
1. over the fresh sealant bead as shown As the bead is being formed any access sealant is scooped into the Applicator recess area Any imperfections are easily rectified by re drawing the Applicator over the same area PRODUCT GUARANTEE This product has been manufactured to meet high operational demands For guarantee and general customer service information please contact your local retailer Guarantee is limited to replacement of the product only DISCLAIMER This product should be used in accordance with manufacturer s instructions Easybead Applicator and Easybead Nozzle may not be suitable for use with materials other than those recommended by the manufacturer CONTACT INFORMATION For technical support and advice on how to use any of our products please email our Technical Department at support easybead co uk For more information please visit www easybead co uk 27 Old Gloucester Street London England WC1N 3AX Discover more at www easybead co uk Ail 5 060318 790210 Easybead is a registered trade mark of Duckbill Products Limited 42. Qtasyl MESS SEALANT APPLICATOR Sealant Applicator User Guide PLEASE READ INSTRUCTIONS CAREFULLY BEFORE USE www easybead co uk ee GETTING TO KNOW EASYBEAD Please note mastic gun and craft knife are not included A mastic gun is required to perform the actions listed in this guide Parts not shown to scale LIST OF ITEMS PRODUCT FEATURES A Easybead Applicator 1 Applicator wipers 5 Grip points B Easybead Nozzle 2 Applicator scoop recess 6 Bead guides C Sealant Cartridge 3 Aligning grooves D Mastic Gun 4 Smoothing tip IMPORTANT NOTES For best results and good sealant adhesion clean and dry surfaces before applying sealant For baths fill bath fully with water to ensure optimum position to allow for potential joint movement Sealant cures more quickly in a warm room temperature Any delay in smoothing the bead may result in an uneven finish The Easybead Applicator is recommended for use on clean flat and smooth surfaces Suitable for application on joints 1 10mm width Not suitable for abrasive surfaces such as brickwork or concrete Easybead Applicator is not recommended for use with any Nozzle other than an Easybead Nozzle CLEANING EASYBEAD Remove fresh sealant using paper towel cloth towel and multi purpose wet wipes Do not use abrasive or aggressive chemical products for cleaning as it may affect the product finish and perfo
3. rmance To re use the Easybead Applicator and Nozzle clean immediately after use to prevent dried sealant causing a blockage Keep all items out of reach of children Use gloves Take extra care when using a knife QUICK GUIDE TO USING EASYBEAD Follow these simple steps to get a professional bead Open or cut off the cartridge tip ABOVE the Screw the Nozzle onto the cartridge Insert into screw thread mastic gun 10mm 12mm 27 The Applicator is pre set to produce a 7mm bead Push the Applicator securely onto the Nozzle This can be increased to suit the joint by using aligning grooves 3 trimming the tip as shown Carefully check the size of bead you require before trimming the Applicator It is IMPORTANT that you use a sharp knife to trim the Applicator to avoid leaving any rough edges as this will affect the bead finish Squeeze the gun trigger to produce a steady flow of sealant then draw the Applicator gently along the joint Apply light pressure to ensure that the flexible wiping Applicator edges 1 fit tightly against the surface to prevent sealant from escaping Any imperfections are easily rectified by re drawing the Applicator over the same area USING EASYBEAD AS A HAND HELD TOOL The following instructions only apply when using Easybead as a hand held finishing tool Detach the Applicator from the Nozzle Apply sealant to the joint Draw the Applicator
Download Pdf Manuals
Related Search