Datasheet - Pump Sales Direct
Contents
1. Extracted from VDMA Standard sheet 24292 These operating instructions contain basic information on the erection operating and maintenance and should be followed carefully For this reason it is essential that these instructions are carefully read before erection or commissioning by both the installation crew as well as those responsible for operation or maintenance The operating instructions should always be readily available at the location of the unit In addition to following the safety regulations of a general nature listed under these main headings it is also essential that the special safety instructions given under other headings be observed Identification of hints in the operating instructions Safety instructions given in this operating manual the non observance of which could cause danger to life have been specifically high lighted with the general danger symbol See DIN 4844 W9 The presence of a dangerous voltage is identified with the safety symbol See DIN 4844 W8 ATTENTION Applies to safety instructions the non observance of which could damage the unit or effect it s functioning Symbols directly on the unit itself e g Direction of rotation arrow Nameplate must be carefully observed and must be maintained in a legible condition ABS Coronada light drainage pump 250 Dangers which could arise due to non observance of safety instructions The non observance of the safety instructions ca2. 15970287GB 06 2010 oO Ka 3 o 2 im co 2 Di A S z a ABS Coronada light drainage pump 250 Installation and Operating Instructions www absgroup com 4 Installation and operating instructions ABS Coronada light drainage pump 250 ABS Coronada light drainage pump 250 Example of rating plate So CH E vg ABS Production Wexford Ltd 2 abs Wexford Ireland www absgroup com Typ Nr SN XX KXXK u v Ph A Hz PI kw Qmax min Hmax 1 min DIN EN12050 2 a IP68 Vv 5m Figure 1 Nameplate Standard Version Legend Typ Pump type n Speed min Nr SN Item No Serial No Qmax Max Flow m h xx xxxx Production date Week Year Hmax Max Head m UN Rated Voltage vV oo Water pressure tight IN Rated Current A IP 68 Protection type Frequency Hz v Max submersible depth m P1N Rated Input Power kW Application The submersible wastewater pumps of the Coronada 250 series are reliable quality products designed for the following applications Pumping of clear water Pumping of rain water Pumping of wastewater containing solids up to 10 mm X Version for industrial wastewater with aggressive components These pumps should not be used for the pumping of faecal matter Before using the standard or SX Versions the chemical resistance of the materials should be checked A The pump must not be used in an explosive or flammable environment or for pumping flammable liquids The pumps conform to the
3. DE FR ES PT IT Declaration of conformity NL Overeenkomstigheidsverklaring HU Megfelel s gi nyilatkozat Konformit tserkl rung SE F rs kran om verensst mmelse GR AnAwon evappovions D claration de Conformit NO Samsvarserkl ring ET Vastavusdeklaratsioon Declaraci n de Confirmidad DK Overensstemmelseserkl ring CZ Prohl en o shodsi Declarac o de conformidade Fi Vaatimustenmukaisuusvakuutus SI Izjava o skladnosti Dichiarazione di conformit PL Deklaracja zgodnosci SK Vyhl senie o zhode Cardo Production Wexford Ltd Clonard Road Wexford Ireland Declare under our sole responsibility that the products Erkl rt eigenverantwortlich da die Produkte D clarons sous notre seule responsabilit que les produits Declaramos bajo nuestra exclusiva responsabilidad que los productos Declaramos sob nossa nica responsabilidade que os produtos Dichiariamo sotto la nostra esclusiva responsabilita che i prodotti Verklaren geheel onder eigen verantwoordelijkheid dat de produkten Forsakrar under eget ansvar att produkterna Erkleerer pa eget ansvar at falgende produkter Products ABS Coronada light drainage pump 250 GB DE FR ES PT IT NL SE NO To which this declaration relates are in conformity with the following standards or other normative documents Auf die sich diese Erklarung bezieht den folgenden und oder anderen normativen Dokumenten entsprechen Auxquels se
4. EU machine directive See rating plate The manufacturer guarantees that a new pump will not emit airborne noise in excess of 70 dB A during normal operation when either fully or partially submerged A The pump must not be run if it has been partially dismantled Electrical connections The pump must be connected to terminals or starting equipment installed at a level at which the pump cannot be flooded All electrical equipment must always be earthed grounded This applies both to pump and to any monitoring equipment The electrical installation must conform to national and local regulations Check that the mains voltage frequency starting equipment and method of starting agree with the particulars stamped on the motor rating plate The unit should be protected by a correctly dimensioned slow blow fuse suitable for the rated power of the pump We recommend the use of an overload relay The electrical installation shall be inspected by an authorized electrician Operation Before commencing operations the pump pump station should be examined and a function check carried out Particular attention should be paid to the following Check that the power cable and plug are undamaged Does the electrical connection comply with regulations Is the motor overload correctly set Is the level control system operating correctly Are the switch On switch Off levels correctly set The installation instructions for pumps
5. een sucked in Ensure that all screen slots are free from foreign bodies Reassemble the screen KS version clean float 1132 00 Figure 2 Coronada 250 Assembly Transport During transport the unit should not be dropped or thrown A The unit should never be raised or lowered by the Power cable A handle is provided for transport If necessary it is possible to suspend the pump by attaching a rope or chain to the handle ABS reserves the right to alter specifications due to technical developments Installation and operating instructions 5 abs Particular application conditions In the case of submersible pumps of the Protection Type 1 such as the Coronada 250 series all accessible metal parts are connected to the earth lead Before operation a qualified person should check that the earth lead is correctly connected For the usage of pumps to Protection Type 1 IEC 335 2 41 1984 Mod 1 1990 applies Pumps of protection type 1 for use in swimming pools or garden ponds must be fitted with an earth leakage circuit breaker 30mA in the incoming power line The pump must never be used if people are in the pools or tanks Pumps for use in swimming pools where people are present must only use pumps to Protection Type Ill with a voltage not greater than 12V NOTE Suitable earth leakage protection devices are available from electrical suppliers Please consult your electrician Safety
6. intended to be used in outdoor fountains garden ponds and similar places shall state that the pump is to be supplied through a residual current device RCD having a rated residual Operating current not exceeding 30mA abs Service and Maintenance A Before any work is started check that the pump is isolated from the power supply and cannot be energized Regular inspection and preventive maintenance will ensure more reliable operation The pump should be inspected every six months but more frequently if the operating conditions are difficult However should a fault occur do not attempt to improvise but call on your ABS Service Centre This applies particularly in the case where the unit is continually switched off by the current overload in the control panel or by the thermal sensors of the thermo control system For a complete overhaul of the pump please get in touch with an authorized ABS workshop or your ABS dealer If the pump is taken out of service in order to prevent deposition of soil or other materials the pump should be cleaned by pumping clear water If there are leaves or fibrous matter in the medium being pumped we recommend that the screen be cleaned from time to time To clean the screen proceed as follows Completely disconnect the pump from the power mains Place the pump in a horizontal position Remove the screen Clean the inside of the screen removing any particles that may have b
7. liitty ovat seuraavien standardien sek muiden s nt m r vien asiakirjojen mukaisia Do kt rych odnosi sie niniejsza deklaracja sa zgodne z nastepujacymi normami lub innymi dokumentami normatywnymi Amelyekre ez a nyilatkozat vonatkozik megfelelnek a k6vetkez6szab v nyokban s egy b szab lyoz dokumentumokban le rtaknak Ta omoia apopa n Tapo oa Gun eivai o upwva pe Ta aKOAOUBAa KOU GAAG Trp TUTTA KAVOVIOTIK Eyypa a Mida k esp ev deklaratsioon puudutab on vastavuses j rgmiste stan dardite ja muude normatiivdokumentidega Na kter se toto prohl eni vztahuje jsou v souladu s n sleduj c mi normami nebo jin mi normativnimi dokumenty Na katere se ta izjava nana a skladni z naslednjimi standardi ali drugimi normativnimi dokumenti Na ktor sa vz ahuje toto vyhl senie zodpovedaj nasleduj cim tandardom a in m z v zn m dokumentom DIN EN 12050 2 EN 60335 EN ISO 12100 1 EN ISO 12100 2 EN 809 A1 amp EN 61000 6 01 6 2010 c he Lhe Sean Roche Cardo Production Wexford Ltd ns We know how water works Cardo Production Wexford Ltd Clonard Road Wexford Ireland Tel 353 53 91 63 200 Fax 353 53 91 42335 www absgroup com
8. n lead to both danger to personnel and also to possible harm to the environment or the unit itself Non observance of the safety instructions can invalidate the rights of the user to any compensation or regress In detail non observance can for example result in the following dangers Failure of important functions of the unit installation Danger to personnel by electrical mechanical or chemical influences Danger to the environment by leakage of dangerous substances NOTE Carry out work in a safety conscious manner The safety instruction listed in this operating manual the existing National Regulations for safety as well as any internal operating or safety regulations which apply in the user s own premises must be observed Safety Regulations for the Owner Operator All dangers due to electricity must be avoided for details consult the Regulations of your local Electricity Supply Company Safety Regulations for maintenance inspection and installation work The user of the unit should ensure that all maintenance inspection or installation work is carried out by authorised and qualified skilled personnel The user must also make certain that they have carefully studied the operating instructions In principle all work on the unit should only be carried out while it is stationary Pumps or units used for pumping of fluids which could be injurious to health must be decontaminated After completion of the work all safety and pro
9. r f re cette d claration sont conformes aux normes ou a d autres documents normatifs Objeto de esta declaraci n estan conformes con las siguientes normas u otros documentos normativos Aque se refere esta declaracao esta em conformidade com as Normas our outros documentos normativos Ai quali questa dichiarazione si riferisce sono conformi alla seguente norma o ad altri documenti normativi Waarop deze verklaring betrekking heeft in overeenstemming zijn met de volgende normen of andere normatieve documenten Som omfattas av denna f rs kran ar i verensst mmelse med f ljande standarder eller andra regelgivande dokument Som dekkes av denne erkl ringen er i samsvar med f lgende stan darder eller andre normative dokumenter DK FI PL HU GR ET CZ SI SK Erkl rer pa eget ansvar at f lgende produkter Vakuutamme yksinomaan omalla vastuullamme etta seuraavat tuotteet Deklaruje z pelna odpowiedzialnoscia ze urzadzenia typu Felel ss g nk teljes tudat ban kijelentj k hogy a term kek Dhl noyme me apokleistikq maw eyuynh ti ta pro nta Deklareerime ainuvastutajana et tooted ProhlaSuje na vlastn odpovidnost e v robky Izjavljamo da so z na o izklju no odgovornostjo izdelki Vyhlasujeme na na u zodpovednos e v robky Som er omfattet af denne erkl ring er i overensstemmelse med f l gende standarder eller andre normative dokumenter Joihin t m vakuutus
10. tective devices must be refitted and a check should be made that they are fully functional Before starting up again the points listed under the section commissioning should be complied with Unilateral modification and spare parts manufacturing Modifications or changes to the unit installation should only be carried out after consultations with the manufacturer Original spare parts and accessories authorised by the manufacturer are essential for compliance with safety requirements The use of other parts can invalidate any claims for warranty or compensation Unproven usage The operating safety of the unit is only guaranteed provided that the unit is used in accordance with the section 1 The limit values given in the data sheet should under no circumstance be exceeded These installation and operation instructions do not supersede or exclude the following of generally valid regulation and standards VDMA Verband Deutscher Maschinen und Anlagebau e V German Machinery Manufacturers Association End of life units can be returned to ABS or recycled in accordance with local regulations Installation and operating instructions ABS Coronada light drainage pump 250 Bl abs Declaration of conformity CE 7 Declaration of conformity ABS light drainage pump Coronada 250 As defined by Machinery Directive 2006 42 EC EMC Directive 2004 108 EC Low Voltage Directive 2006 95 EC Construction Direc tive 89 106 EC GB
Download Pdf Manuals
Related Search