Installation Manual
Contents
1. Installation Manual CHOOSE YOUR SPOT TO SHOW YOUR PROMOTIONS Pick a smooth dry and clean surface the most traditional places are on any wall door window or car do not block windshield When placing your WallATac on a standard painted wall make sure the wall had been previously primed prior to painting otherwise the paint may possibly come off If you place your WallATac on a pebbly textured or porous surface i e brick or cement walls you may receive poor results but in most cases it has worked We also suggest not placing it above fireplaces CLEAN IT BEFORE YOU STICK IT Use a warm damp cloth or sponge to clean the wall surface or window and allow it to completely dry You can remove and replace the WallATac over and over again however once the adhesive collects too much dust dirt or fibres it will become less effective and the WallATac may not stick as well to your surface PEEL AND STICK IT Depending on the size of your WallATac it may be helpful to have two people install it Try not to let the adhesive come together or the WallATac to fold up against itself It s okay if it does you can separate it by carefully pulling it apart so you do not ruin the print Start at the top of your WallATac and pull down approximately 2 3 of the backing By lightly pressing and smoothing apply the 2 3 exposed adhesive area of your WallATac to your chosen surface area Then continue to slowly pull the backing downward i2. n 2 3 increments smoothing the WallATac as you go Once the WallATac is started it may be helpful if another person holds the bottom and pulls down slightly giving some tension and keeping it straight and easier to apply If there are any bubbles or wrinkles you can lightly press or smooth them out or just peel back that area and re apply Please Note Pressing too hard will not damage the WallATac however it may cause your hands to gather ink due to the natural oils on your hands and it could transfer from your hands onto another surface SUGGESTIONS If a bubble re appears over the next day or two you can remove it by pressing and lightly rubbing it This may happen occasionally because oil dirt or dust could be on your surface You can use a pin to pop the bubble and then smooth it out with your fingers in a circular motion If you have any questions email us at enquiries wall a tac co uk 01246 570570 www wall a tac co uk enquiries wall a tac co uk
Download Pdf Manuals
Related Search