CX6100 User Manual HW0568 Issue B (09 2014).indd
Contents
1. entellion pre engineered power solutions European Headquarters Accutronics Ltd Unit 20 Loomer Road Chesterton Newcastle under Lyme Staffordshire ST5 7LB United Kingdom Sales amp Customer Services Tel 44 0 1782 566688 Fax 44 0 1782 576640 Email sales accutronics co uk Technical Support Tel 44 0 1782 566622 Fax 44 0 1782 576640 Email tech accutronics co uk www accutronics co uk Document HW0568 Issue B 09 2014 Battery solutions you can trust CX6100 Desktop Charger for Credit Card Batteries gt Overview The CX6100 is a standalone desktop battery charger which is compatible with Entellion CC2300 and CC3800 credit card batteries gt Contents e CX6100 desktop charger e Wall mount power supply e Set of AC blades allowing operation in Europe the United Kingdom North America Australia and China e User manual gt Operation Set up Select the AC blade for the appropriate AC outlet and attach it to the power supply The plastic base of the AC blade will only fit in one direction Ensure it is fully located in the aperture Return unused blades to their packaging and store for future use in different geographic locations Place the charger on a flat level surface away from sources of heat and moisture Plug the DC connector from the power supply into the rear of the charger and connect the power supply to the AC supply A green LED will be seen to illuminate on the charge2. ply as this may cause over heating e Do not attempt to use any power supply other than that supplied e Do not use the charger or power supply if they are damaged e Do not attempt to charge any battery other than a CC2300 or CC3800 e Follow local regulations and ordinances for the disposal or recycling of waste electronics goods and for the disposal or recycling of the batteries Recycle facilities may not be available in all areas e The wall mount power supply is the disconnect device The socket outlet shall be installed near the equipment and be easily accessible e Retain this user manual for future use wall mount power supply AC blades CX6100 desktop charger
3. r Charging a Battery Place a CC2300 or CC3800 credit card battery into the charging bay sliding it forward so that the electrical contacts on the battery mate fully with the contacts on the charger The green LED will turn to amber indicating that the battery is charging Once the battery is fully charged the LED will change from amber back to green If the LED remains green when the battery is first inserted then it is already fully charged If a red LED illuminates then this indicates a fault condition see following page Charge Time The time required to charge a battery will depend on the model the initial state of charge the age of the battery and the ambient temperature A fully discharged CC2300 battery will normally be charged in approximately four hours while a CC3800 requires approximately six hours Fault Conditions If the CX6100 displays a red LED then this indicates a possible fault condition e Check that the correct power supply is being used Replace if necessary e Ensure the charger has not overheated due to it being covered or placed ina warm location such as strong direct sunlight Move the charger allow to cool and retry If the fault condition persists the charger may be faulty Please contact the seller for advice gt Recommendations to users e Do not expose the charger or power supply to water or other liquids e Do not open the charger or power supply case e Do not cover the charger or power sup
Download Pdf Manuals
Related Search