USER MANUAL - Appliances Direct
Contents
1. electric AIRCUBE AC9000E PORTABLE AIR CONDITIONER WITH HEAT PUMP USER MANUAL Thank you for choosing ElectriQ Please read this user manual before using this innovative Air Conditioner and keep it safe for future reference Visit our page www electriQ co uk for our entire range of Intelligent Electricals Page 1 of 13 APPENDIX CONTENTS SAFETY INSTRUCTIONS FEATURES AND PARTS LIST _ s INSTALLATION OPERATION AND SETTINGS WATER DRAINAGE 6 MAINTENANCE s TROUBLE SHOOTING sssssssscssascesssasesconssecdeccessasesseai Page 2 of 13 11 12 SAFETY INSTRUCTIONS Important Carefully read the instructions before operating the unit Please retain this manual for future reference Note This AC is for indoor use only Rating This unit must be only connected to a 220 240 V 50 Hz earthed outlet Installation must be in accordance with regulations of the country where the unit is used If you are in any doubt about the suitability of your electrical supply have it checked and if necessary modified by a qualified electrician This air conditioner has been tested and is safe to use However as with any electrical appliances use it with care Disconnect the power plug from so2. 1057 or complete the online form 1 Has the unit been standing upright for at least 2 hours 2 15 the unit plugged into the mains 3 Is the fuse OK 4 Switch the unit off and wait three minutes to see if the issue is resolved Restart the unit 5 Check if the water tank is full Office hours 9AM 5PM Monday to Friday www ElectriQ co uk Unit 2 The Nursery Berristow Lane South Normanton Derbyshire DE55 2FX Page 13 of 13
3. coil temperature increases the protection will be stopped automatically Water full protection When the water level in the internal water tank is surpassing the maximum level the unit will stop and Full light will turn on Please discharge water In the machine according to Water Drainage section Compressor protection Compressor has an overheating protection function and may stop to prevent compressor damage Also the compressor runs under a 3 minute delay protection function WATER DRAINAGE This model is an advanced self evaporative air conditioner which reduces the need to empty the water tank in cooling mode If the unit is vented correctly most of the water is reused to cool the condenser coils and any excess is evaporated Please make sure that the rubber cap is firmly secured on drain hose when the unit is running In extreme humidity or while the unit is in reverse heating the internal water tank may fill quicker triggering the tank full alarm Please do not use continuous drainage if you intend to use the self evaporating facility for improved cooling effect Manual drainage 1 1 When the internal water tank is full the unit will stop working 1 2 Shut off the unit and unplug Try not to move the model abruptly as this may cause water to spill out from internal water tank 1 3 Place a tray under the water plug 1 4 Screw off the water plug and unplug the water blocker water will drain from the internal container 1 5 Pu
4. unit Avoid restarting the air conditioning unit unless 3 minutes have passed since being turned off This prevents damage to the compressor Never use the mains plug as a switch to start and turn off the air conditioning unit Use the provided ON OFF switch located on the control panel Always place the unit on a dry and stable surface The appliance should not be installed in laundry or wet rooms Energy Saving and Unit Safety Protection Tips Do not cover or restrict the airflow from the outlet or inlet grills For maximum performance the minimum distance from a wall or objects should be 50cm Unit is fitted with thermal cut off sensor that will prevent overheating Keep the filters clean Under normal conditions filters should only need cleaning once every three weeks approximately Since the filters remove airborne particles more frequent cleaning maybe necessary depending on the air quality To protect the unit we recommend not using the cooling function when the ambient temperature is higher than 35 C To protect the unit we recommend not using the heating function when the ambient temperature is lower than 7 C Use electrical or alternative heating to raise the room temperature to 10 C than start the air conditioner in heat mode and set it to the desired temperature Heating by heat pump will take longer but is cheaper than any other form of heating and ideal for maintaining room temperature constant Page 3 of 13 FEATURES AND PARTS L
5. IST 1 Features Part of ElectriQ AirCube range of Air Conditioning products Cooling Heating and Fan mode for all around the year use Improves comfort and indoor air quality Reduces the humidity in the air Self evaporative system no external water tank needed Compact designer inspired model Side vents to prevent dust and dirt entering the machine The hot air outlet is positioned high on the unit this allows for improved performance with the use of a short hose Two Speeds fan great for selecting improved performance vs quitter operation Advanced Compressor protection technology Recessed castors for improved portability 2 Parts list 1 Control panel control knob 7 Bottom drain port 2 Cold air outlet 8 RC slide in slot NA 3 Cold air outlet hose mount 9 Hot air outlet hose mount 4 Exhaust hose connector 10 Hot air outlet 5 Exhaust hose 11 Secondary drain port 6 Hot air inlet 12 Cool air inlet and Evaporator filter Page 4 of 13 INSTALLATION Warning Before using this unit please keep it upright for at least 3 4 hours This unit can easily be moved from one room to another While moving the unit please note that it must always be kept upright and then placed on an even surface Unpacking Open the box and remove all the packing out of way Grip the unit by the carry handles located on either sides of the unit and carefully lift until it slides out of the foam base Lift and lean the unit
6. cket before dismantling assembling or cleaning Avoid touching any moving parts of the appliance Never insert fingers pencils or any other objects though the guard This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities It is also not intended for use by those with a lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety Do not leave children unsupervised with this appliance Do not clean the unit by spraying it or immersing it in water Never connect the unit to an electrical outlet using an extension cord If an outlet is not available one should be installed by a qualified electrician Never operate this appliance if the cord or plug is damaged Ensure the power cord is not stretched or exposed to sharp object edges A damaged supply cord should be replaced by the manufacturer or a qualified electrician in order to avoid a hazard Any service other than regular cleaning or filter replacement should be performed by an authorized service representative Failure to comply could result in a voided warranty Do not use the appliance for any other purposes than its intended use The air conditioner unit must always be stored and transported upright otherwise irreparable damage may be caused to the compressor if in doubt we suggest waiting at least 24 hours before starting the
7. eutral detergent d Rinse it and then dry it thoroughly e Carefully re install air filters Open from here End of Season Maintenance 1 Pull out the plug from the drainage hole and empty the internal tank You can also drain the water by leaning the unit Then switch the unit to low fan mode Keep the unit in this mode for half day until the conduit is dried Doing this helps to keep the inside of the unit dry and prevents mold developing Turn off the unit and pull out the plug Separate the air exhausted pipe and store it safely Cover the unit and keep it in a dry place Page 10 of 13 Trouble Shooting Do not repair or disassemble the unit by yourself Unauthorized repair attempts will invalidate the a and may cause bodily harm Trouble Reason No power supply Power on and turn on the unit Water full indicator Drain the internal water tank Use only in ambient temperatures between Room temperature too low or too high The unit does not 17 35 C Windows or doors open Large amount of people or heat source in the room Close windows and turn on another air conditioner work Filter is very dirty Clean or change the air filter Air inlet or air outlet is blocked Clear out debris The unit loud The unit is not put on flat surface Put the unit on flat and hard surface Check venting Compressor does Overheating protection is active Restart the unit after 5 minutes when not wor
8. in 55cm max 100cm Make sure the unit is upright and there are no obstructions to the air inlets and outlet grills Note The window kit is only designed to be installed with sliding or sash windows or doors The window kit is not made to be used with any other style of windows However the fish tail adaptor can be used with most windows doors but there will be an cold air escape making unit less efficient When using the cooling mode ensure that the opening left is as small as possible The best form of installation is through a wall duct Please note that the unit will need to be vented out in heating mode ideally through the wall By properly venting your air conditioner expels cold air from your room while efficiently heating it Important safeguards The length of the soft hose extends from 28 cm to 150 cm If hose is extended above this length the unit may malfunction and this can invalidate the warranty Shorter the hose the better the results The outlet vent must be well ventilated and not obstructed as this will cause the unit to overheat Avoid bending the air hose more than 30 degrees Page 6 of 13 OPERATION AND SETTINGS This portable air conditioner features three functions cooling heating and fan Also the unit will reduce the humidity in the room by extracting water in cooling or heating mode The fan has two speeds high and low 1 Control instruction Control panel FAN lt Make sure the knob is in off pos
9. ition before plugging the unit on Starting the unit 1 Turn the control knob to the OFF position 2 Plug the unit into an appropriate power supply 3 Turn the control knob to COOL HEAT the cooling heating light is on while the unit is in operation Turning off the unit Turn the control knob to the OFF position and the unit will stop operating FAN MODE Low Fan Speed Turn the control knob to the position the unit operates at low fan speed High Fan Speed Turn the control switch to the position the unit operates at high fan speed Compressor will not start in fan mode unit will just move the air around the room Cooling Heating mode COOL HIGH Cooling Heating Turn the knob to the HEAT position high cooling heating mode is activated COOL LOW Colling Heating Turn the knob to HEAT position low cooling heating mode is activated The compressor will be active on in this mode To use the unit in heat mode please ensure that is installed as in figure C2 page 5 with unit expelling cold air via the exhaust hose and hot air from the front vent back into the room FULL When the internal water tank is full the full light will be on Page 7 of 13 Multi protective function Anti freezing protecting control When the ambient temperature is low while in Cooling Mode the compressor and water pump will stop working if the copper coil temperature is too low When the copper
10. k compressor has cooled If the above solutions do not resolve the problem please contact the service centre Page 11 of 13 APPENDIX Disposal Do not dispose this product as unsorted municipal waste Collection of such waste must be handled separately as special treatment is necessary mums Recycling facilities are now available for all customers at which you can deposit your old electrical products Customers will be able to take any old electrical equipment to participating civic amenity sites run by their local councils Please remember that this equipment will be further handled during the recycling process so please be considerate when depositing your equipment Please contact the local council for details of your local household waste recycling centres TECHNICAL DATA MODEL AIRCUBE 9000 Cooling 2 kW eating 2 Heating 700KW Heating E Max Noise Level Sound Pressure Noise Level Sound Energy 65 dB A Max Noise Level Sound Pressure 52 dB A Airflow Dimension L D H Unit must be vented outside when in Air Cooling and Heating mode For the purposes of EU regulation EN12102 this is a local air conditioner and produces less than 65dB A sound energy AC9000E nglish V1 0230114 Page 12 of 13 ElectriQ UK SUPPORT www ElectriQ co uk support Please for your own convenience make these simple checks before calling the service line If the unit still fails to operate call 0871 620
11. slightly to take out exhaust hose from under the unit as in the picture attached Install the exhaust hose on the unit before operating the unit g 10 of Sa 2565656565000 o0 A 52529255505 CONTENTS 1 Air conditioner unit 2 Side hose mount 3 Hose and window kit Assemble the hose 1 Clip the hose connector side of the unit 2 Insert the hose and rotate is firmly into adapter 3 To remove the hose reverse the procedure Note To install the hose for heat mode please remove the hose and clip as in figure ca and reversing it to the other side of the unit using the adapter provided Assemble the adapter on the panel facing the grills as in figure B After insertion of the adapter the procedure is the same as in figure A In heat mode the unit will look as in figure 2 C 1 adapter 2 Page 5 of 13 Assemble hose fish tail adaptor Prepare both parts of hose adaptor and clip them together Do not push too hard as this may cause damage Extend one head of the hose and screw the adaptor to it Note to screw it into place should take no less than three rotations Installation of window kit partially open the window and then fix the window kit to the window Window slider kit min 55cm max 100cm Window slider kit m
12. t the water blocker back 2 Continuous drainage 2 1 Remove the water plug 2 2 Use a water pipe to connect to the water outlet 2 3 You can plumb this pipe into your current plumbing system lead it outside or use a water pump Page 8 of 13 Note When the unit is in the cooling function it is recommended not to have the drain pipe installed Please make sure that the rubber cap is in place when the unit is running When operating the heating function the low rubber cap on drain port could be pulled out and install a permanent drain pipe in order to improve the heating effect X When the water tank fills the FULL light is on To resume operation please unplug the unit before removing the rubber 2 of the drain hole to drain out water After the drainage is completed please plug the unit and restart Page 9 of 13 Maintenance Cleaning Please shut off the unit and unplug from the mains before cleaning or performing any maintenance Clean the surface Clean the plastic housing with a duster or a soft wet cloth Do not use chemical solvents such as benzene alcohol or gasoline as they may cause irreversible damage Air filter cleaning a Clean the air filters every 2 weeks If the air filter is blocked with dust the unit s performance will be significantly affected b Pull out the top and bottom filters as pictured below Wash the air filters by immersing them in warm about 40 C water with a n
Download Pdf Manuals
Related Search