Installation Manual
Contents
1. a signal that you have installed At this point replace the filter cartridges or elements TO POWER SOURCE 1AMP 50 WATT SPST MAXIMUM TEMP 200 F INDICATOR SWITCH SIGNAL2. R NE UTEK We make compressed air work Extractor Dryer 50 SCFM SERIES NO PARTNO DESCRIPTION 10537 BOLT 4 10521 WASHER 6 10501AF23 MANIFOLD 1 4 NPT 10601A F23 MANIFOLD 3 8 NPT 10701A F23 MANIFOLD 1 2 NPT 401 FIRST STAGE CARTRIDGE 402 SECOND STAGE CARTRIDGE 10510 CRP GASKET 10503A F23 CHAMBER 10528 GASKET 10508 BASE CORE 10502A F23 BASE 10535 WEEP DRAIN SPECIFICATIONS FILTRATION 5 MICRON AIRFLOW 50 SCFM MAXIMUN PRESSURE 250 PSI DEW POINT 10 TO 35 F ATMOSPHERIC PRESSURE PORT SIZE MODEL NT 105 1 4 NPT MODEL NT 106 3 8 NPT MODEL NT 107 1 2 NPT HEIGHT 9 00 WIDTH 4 00 DEPTH 2 50 BOLT TORQUE 50 INCH POUNDS MAXIMUM TEMPERATURE 180 F SERVICE ITEMS 050SK SERVICK KIT PATENT NO RE 32 989 5 261 946 WARNING Injury can occur if the Extractor Dryer is used at Pressures higher than the maximum pressure and with any compressed gases other than normal compressed air for power tool use only R NE UTEK We make compressed air work INSTALLATION INSTRUCTIONSS WARNING ALWAYS TURN OFF AIR SUPPLU AND BLEED AIR PRESSURE BEFORE DISASSEMBLING UNIT OR INJURY COULD RESULT WARNING USE PERSONAL PROTECTIVE EQIPMENT TO PREVEMT EYE INJURY WHEN SERVICING THIS UNIT 1 Installation MUST NOT be at the compressor sight install the filter as close as possible to the machinery or air tools being used 2 The weep drain if equipped should be left open up to 1 4 turn depending on amount of liquid in
3. air line at all times The weep Drain will allow 10SCFH of air to escape with 100PSIG line pressure in the closed position This will allow water oil and contamination to drain from the unit 3 Replace elements every three to four months depending on airline conditions 4 To replace elements loosen bolts enough to allow cartridges to move freely Slide out old filters Install new filter cartridges Tighten bolts to specified torque limit in an X pattern Slowly pressurize unit and check for leaks The slider Gauge under normal operating conditions will be in the green area As the element becomes dirtier over a period of time the gauge will slowly move into the red zone 10 PSIG drop At this time changing the filter elements or cartridges in recommended DIFFERENTIAL PRESSURE INDICATORS OPTIONAL r ape 1 11032 Screw i Fe 2 11026 Switch Gauge gt s 3 52023 Gasket LY 4 11031 Screw Oe 5 11024 Gauge GAUGE SWITCH GAUGE The indicators are factory installed and set to indicate a 10 PSIG pressure drop across the filter Under normal operation the indicating needle will point to the green zone and the switch contacts will remain open This indicates a pressure drop of less than 10 PSIG As the filter traps dirt the pointer will move towards the red zone and the switch contacts will move closer together When is reached the pointer will point to the red zone and or the switch contacts will close actuating
Download Pdf Manuals
Related Search