L.R. Baggs T-Bridge: Installation Manual & User's Guide
Contents
1. MICRODRIVE il INSTALLATION MANUAL amp USER S GUIDE CR Bergen 483 N FRONTAGE RD NIPOMO CA 93444 1 PACKAGE CONTENTS WWW LRBAGGS COM One 1 Microdrive Il preamp One 1 prewired strapjack assembly One 1 mini plug Two 2 self stick wire clips 2 OVERVIEW AND CAUTIONS The Microdrive Il preamp is designed for use with the L R Baggs LB6 Series pickups but it is compatible with most other piezo ceramic pickups We do not however guarantee guarantee optimum performance or warranty use with pickups other than the LB6 LB12 LBX and LBC We recommend that the Microdrive Il preamp be attached to the inside of the guitar on the straight spot just above the waist This will make it possible to use the optional Remote Control module and facilitate battery replacement We do not provide installation advice or support for home or hobbyist installations Installers please read the instructions carefully before proceeding We will not be responsible for any damage to the guitar or personal injury resulting from installation use or misuse of the product 3 INSTALLATION 1 The pickup and output harness plug into the preamp module Be sure that there s room to plug and unplug the pickup and output harness before you stick the preamp in place 2 Before you stick the preamp to the side of the guitar carefully consider its location and be sure that the area is free of dust After the desired location is found put the two pieces of v2. ack in the wire so it does not touch the brace 4 USER S GUIDE The Microdrive II by itself has no user controls The output level has been set to the 10dB standard when partnered with LB6 Series pickups The Microdrive Il preamp is designed to interface with almost any piece of outboard gear The output jack acts as the switch plug it in and it s on unplug it and it s off The easiest way to check the battery is to plug into your rig and play very hard on the lower strings If the sound is clean your battery is fine If the tone is fuzzy drop in a fresh one
3. elcro together if it s not already done Peel off the paper from one of the sticky sides of the velcro and stick it to the back of the preamp pressing firmly to insure a good bond Then with your chosen location in mind remove the backing from the other side of the velcro and stick the entire preamp in the desired location 3 Prepare the guitar for the strapjack by drilling a clean 1 2 hole in the tailblock of the guitar using a step drill It s a good idea to mask off the area you are drilling to avoid chipping the finish 4 Remove the strap ring from the end of the jack There should still be a star washer and locking nut on the middle of the jack Put the strapjack into the pre drilled 1 2 hole using the nut and star washer as a depth guide The jack should stick out enough to tighten the strap ring onto the threaded barrel of the jack Once the depth is set and the barrel is in the hole screw the strap ring onto the barrel until the assembly is tight Use caution when tightening the strap ring so you don t crack the finish 5 Install the LB6 Series pickup using the instructions provided with the pickup 6 Plug the pickup and the output jack into the preamp 7 Secure the output jack wire to the inside of the guitar with two of the peel and stick cable platforms provided Choose a location for the platform between the pickup and preamp several inches away from the pickup If there is a secure brace that the wire will cross leave a little sl
Download Pdf Manuals
Related Search