Installation and operating instructions TRS 130 C, TRS
Contents
1. GB Installation and operating instructions TRS 130 C TRS 200 W Towel rail 1 Warnings 1 1 General You are requested to read all the information in these instructions attentively It gives important information concerning safety installation and mounting the use and servicing of the appliance Keep these instructions carefully and if applicable pass them on to the final owner The manufacturer is not responsible if the following directions are not respected If the appliance is damaged check immediately with the supplier before installation In order to guarantee the safe operation of the towel rail it is only to be mounted and connected in accordance with the instructions Where a fixed connection is made it must be installed by a competent electrician in accordance with the relevant safety regulations The appliance is only to be used for its stated uses Inthe event of a fault disconnect the electricity supply to the appliance pull out the plug Where the appliance is out of operation for a long period disconnect the electrical supply to the appliance 1 2 Specific to this appliance The towel rail can only be used to dry and heat towels and articles of clothing It is only suitable for domestic use or similar purposes within enclosed spaces The specified minimum clearances are to be respected Itis particularly important that the appropriate safety regulations for bathrooms showers swimming po2. er before cleaning and allow to cool The outside can be cleaned by wiping it over with a soft damp cloth and then dried Do not use abrasive cleaning powders or furniture polish as this can damage the surface finish 7 Guarantee The guarantee terms issued by our representatives in the country of purchase are applicable for this appliance The dealer from whom the appliance was purchased will provide details at any time on request Presentation of a receipt is essential for the implementation of the guarantee terms
3. ols etc are fulfilled The heater is to be installed in such a way that it cannot be touched from a bath or shower and that the switch cannot be operated The installation can only take place in safety zone 3 according to VDE 0100 Part 701 2 Description of the appliance Type Heating capacity Finish Weight Watt kg TRC 130 W 90 chrome 4 5 TRS 200 W 150 white 6 5 Supply voltage 1 N PE 230V 50Hz 45 51 TA r B i ae 6 r toe 1 15 Ip f A i REN T A G i 4Y F LS E t e s ob rs 35 min D E Type A B C D E F G H TRC 130W 850 570 535 180 285 300 600 510 TRS 200W 850 825 790 255 355 300 600 760 XC Dimplex T9623gb 04 02 A The appliances are provided with a supply cord and earthed plug with an inbuilt rocker switch and indicator light The appliances are splashproof to IP 44 construction class I The plug provided with the towel rail is not splashproof and cannot therefore be connected in the safety zone 3 Minimum clearances mounting Do not locate the towel rail immediately below a fixed socket outlet The stated minimum clearances to items of furniture walls floors and ceilings are to be respected Clearance to the side at least 50 mm Clearance underneath at least 35 mm Clearance above at least 50 mm When mounted on the wall the towel rail must be mounted vertically as shown The appliance can be fixed with the connection on either the left or the right side The wall brackets
4. supplied should be fitted as follows 1 Push the clip A over the towel rail tube 2 Place the bracket B over the clip with the nut and push it firmly against the towel rail tube 3 Insert screw C through the hole in the bracket B and screw it lightly into special nut 4 Position the complete bracket exactly on the towel rail and tighten the screw fully 5 Mark the position of the holes on the wall in accordance with the mounting sketch drill holes for the matching screws and insert the wall plugs 6 Fix the appliance horizontally on the wall by tightening all screws 4 Electrical connection The towel rail can be connected by either a fixed connection only made by a competent electrician or an earthed plug complete with integral switch and indicator lamp Moving a socket or replacing the supply cord with a longer one can only be carried out by a qualified electrician respecting the appropriate requirements 5 Faults If the appliance is not heating please check whether the appliance is switched on then whether it is switched on at the distribution board or the fuse is in order If this is so call your electrical installer Give him the order no for the heater see rating label Repairs and operations within the heater can only be carried out by a competent electrician or customer serviceman 6 Cleaning the appliance The heater does not require any special maintenance or attention Switch off the heat
Download Pdf Manuals
Related Search