The Handy Post HP-1W Installation Guide
Contents
1. yellow from the sun Visit for Optional Enhancements and photos of Handy Post installations WARNING When attaching a mailbox to the Handy Post arm use screws that do not protrude over inside the arm This can lead to interference with objects being placed inside the arm or can cause injury when reaching inside the arm2. INSTALLATION INSTRUCTIONS Instucciones de instalacion WHEN INSTALLING OVER NEW OR EXISTING 4 X4 3 5 X3 5 POST STEP 3 REMOVE MAILBOX SLIDE VERTICAL SLEEVE SECURE VERTICAL SLEEVE Borrar buzon Slide vertical en manga Asegure vertical en manga STEP 4 STEP 5 STEP 6 INSTALL ARM MEASURE LOCATION SECURE ARM Instalar el brazo Medida de ubicacion Brazo de forma segura Step 1 If you re installing a new 4 x4x72 post or No Dig support it is recommended to place it a minimum of 24 in the ground Step 2 Make sure the wood 4 x4 is not more than 52 above ground Slide the vinyl 4 x4 x54 sleeve over the wood 4 x4 Step 3 Use 1 screw from the Handy Post Kit to secure the vertical sleeve in the rear and near the ground Step 4 Bring the 5 x5 x24 vinyl arm down over the vertical sleeve by inserting through both 4 square holes Step 5 You can locate the arm anywhere along the upright Check with your local Post Office for mailbox height regulations Step 6 Use 4 screws from the Handy Post Kit to secure the arm in the pre drilled holes Two on each side CAUTION Do not over tighten the screws Once the vinyl begins to indent back the screw off until the vinyl is smooth If you are using the Handy Post as a Sign or Planter Post secure the additional cap included with a touch of PVC cement CAUTION Be careful not to allow cement glue to get on the outside of the Arm or Cap as it will turn
Download Pdf Manuals
Related Search