Quiet Glide HPIDHP3000 Instructions / Assembly
Contents
1. LONG TRACK SCREW TK 10009 B TRACK ENDCAP 2 X 6 HEADER NOT PROVIDED e T FE E t3 re EN Ta2. INTERIOR DOOR HARDWARE PROGRAM a _ n e i a _ E ga z La X Se a e 3000Star Kit includes 2 Star Drop Strap 1 8 Easy Track IDHP 2 61 2 Trolley with Roller Bearings 1 Handle dm a HP IDHP 3000 Interior Track amp Trolley Installation Guide Step 1 Mount Track to Wall The track has pre drilled holes at 16 centers to match typical wall studs 1 3 155 screws are provided to mount to wall Note If your opening has trim installed around it you will require a 2 x 6 x 9 wood header This will move the track away from the wall to avoid contact with the trim If not please proceed with number 1 above Step 2 Mount End Caps to end of track There are two caps provided with carriage bolts stops and nuts 1 End Caps slide inside the end of the track and and cam in the bottom Once inside use the 1 3 1 2 screw to lock cap in place Leave one end open to side door assembly and then install cap to secure door Step 3 Mount Trolley to Door There are two trolley assemblies provided with hardware 1 Trolley s should be mounted at the top end of the doors approximately 6 from the edge of the door 2 Use the drill pattern provided to ensure that the holes drilled are properly spaced The critical element 15 to line up the Top of Door Line on the template befo
3. re you drill 3 Use a 3 8 drill bit to drill holes 4 Fasten Trolley to door with carriage bolts provided Again make sure the carriage bolts are facing out Tighten nuts on back of the door Step 4 Mount Handle on Door There is one handle provided with each kit 1 Decide which way the door will open and install the door handle on the side of the door that you will pull to open and close Step 5 Lift Door Assembly on Track Depending on your door configuration you may need assistance to lift the door and trolley onto the track 1 Lift Door and place trolley onto track There is a grove in the wheel that allows the trolley to ride on the track Step 6 Install Door Guide to Wall There is one door guide provided with each kit This guide keeps the bottom of the door to swing out away from the wall as well as provides support for the door to slide open and close 1 Mount Door Guide on the wall 14 below the bottom of the hanging door Locate the guide on the side of the opening in which the door 16 slid open to This will allow the guide to work as the door is open and closed DP a NI ml RI d pm _______ 3 457 DIA HOLES DESCRIPTION QTY 100101 5 DOOR HANGER TROLLEY ASSEMBLY 5 16 FLAT WASHER 5 16 NUT I 15 16 x 3 4 LONG CARRIAGE BOLTS J nR Ci pC HANDLE sd 1 1 4 SCREWS FOR HANDLE DOOR GUIDE DOOR GUIDE ASSEMBLY HW 200021 B 10 x 3 1 2
Download Pdf Manuals
Related Search